IKEA of Sweden E1201C User Manual

TRANSMITTER – E1201C ANSLUTA

No.

Description

Function

indicator

The indicator blinks to indicate signal transmission status.

USER INSTRUCTION

A. Features

1. Easy and simple to use.

2. Blinking blue LED indicates signal transmission status.

B. Diagram & Descriptions

C. Operation

1. Configure Press the“ON/OFF Lear ning Code ”butt on on the receiver until the LED “Indicator” blinks . Then press any one of the four “OFF” buttons until the red LED “Indicator” goes off. The receiver is trained to respond to the corresponding channel.

2. Control

1 OFF，1 ON

Switch on and off the appliances connected to channel 1 receiver E1201

Press the “ON” or “OFF” button to switc h on or off th e appliance c onnected to the recei ver trained to the corresponding channel.

D. Specifications

1. Battery : 2X AAA

2. Frequency : 433.92 MHz

3. Distance : 20 meters max. (in the open air)

E. Holder

IKEA of Sweden, AB Manufactory: Everflo uris h Electrical Co., Ltd.

Adress:Renjiu Village, Wuxiang Town, Yinzhou Ningbo 315111 P.R. China

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.

Changes or modifications not expressly approved by the party responsible for compliance could vo id the user 's author it y to operate the equipment.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

—Reorient or relocate the receiving antenna.

+ 1 hidden pages