Ikea IBMS1456XB, IBMS1456XS, IBMS1455XB Installation Instructions

BUILT-IN MICROWAVE OVEN
INSTALLATION INSTRUCTIONS
30" (76.2 cm)
This product is suitable for use above electric or gas built-in ovens, and below non-vented electric or gas cooktops. This product is not suitable for use below downdraft cooktops.
FOUR À MICRO-ONDES ENCASTRÉ
INSTRUCTIONS D'INSTALLATION
30" (76,2 cm)
Ce produit convient pour une utilisation au-dessus de fours encastrés électriques ou à gaz, et au-dessous de tables de cuisson électriques ou à gaz sans décharge à l’extérieur. Ce produit ne convient pas à une utilisation au-dessous de tables de cuisson avec extraction par le bas.
Ces instructions d'installation couvrent plusieurs modèles. L’apparence de votre modèle peut différer légèrement des illustrations présentes dans ce manuel.
Table of Contents / Table des matières
BUILT-IN MICROWAVE OVEN SAFETY ................................. 1
INSTALLATION REQUIREMENTS........................................... 2
Tools and Parts ...................................................................... 2
Location Requirements.......................................................... 2
Minimum Dimensions............................................................. 3
Product Dimensions............................................................... 4
Electrical Requirements ......................................................... 5
INSTALLATION INSTRUCTIONS............................................. 5
Install Spacer Strips ................................................................5
Install the Microwave Oven
(30" [76.2 cm] Installation Only) ............................................. 6
Complete Installation ............................................................. 7
ASSISTANCE............................................................................. 8
SÉCURITÉ DU FOUR À MICRO-ONDES ENCASTRÉ......................9
EXIGENCES D’INSTALLATION...........................................................9
Outillage et composants ...................................................................9
Exigences d'emplacement..............................................................10
Dimensions minimales ....................................................................10
Dimensions du produit....................................................................11
Spécifications électriques ...............................................................12
INSTRUCTIONS D’INSTALLATION..................................................12
Installation des bandes d’espacement...........................................12
Installation du four à micro-ondes
(Installation de 30" [76,2 cm] uniquement)......................................13
Achever l'installation........................................................................14
ASSISTANCE......................................................................................15
BUILT-IN MICROWAVE OVEN SAFETY
Your safety and the safety of others are very important.
We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages.
This is the safety alert symbol.
This symbol alerts you to potential hazards that can kill or hurt you and others.
All safety messages will follow the safety alert symbol and either the word “DANGER” or “WARNING.”
These words mean:
You can be killed or seriously injured if you don't immediately
DANGER
WARNING
All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can happen if the instructions are not followed.
W10335301A
follow instructions.
can be killed or seriously injured if you don't
You instructions.
follow
INSTALLATION REQUIREMENTS
Tools and Parts
Tools Needed
Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed here.
Measuring tape
Pencil
T10 TORX
®†
screwdriver
*Shim may be needed for 30" (76.2 cm) installation in double-
walled cabinetry (having outer walls that protrude past the front surface of the cutout opening). See Step 7 in “Install the Microwave Oven (30" [76.2 cm] Installation Only)” section.
Parts Supplied
All of the following parts are provided.
A
B
Drill
5/64" (2 mm) drill bit
1/4" (6 mm) shim*
C
Location Requirements
The microwave oven may be located in a cabinet, and/or above a built-in oven, or below the counter and/or below a non-vented cooktop. Check the opening where the microwave oven will be installed. The location must provide:
Wood cabinetry.
Cutout opening that is plumb and square. See “Minimum
Cutout Dimensions” in “Minimum Dimensions” section.
Cutout floor that is solid, level and flush with bottom of
cabinet cutout.
Support for weight of at least 150 lbs (68 kg), which includes
microwave oven and items placed inside.
Grounded electrical outlet. See “Electrical Requirements”
section.
Minimum installation clearances for installation location. See
“Minimum Dimensions” section.
Complete enclosure around the recessed portion of the
microwave oven.
A. Side brackets (2) B. Side trim panels (2) C. Spacer strips (4) D. 1" T-10 screws (6)
D
†®TORX is a registered trademark of Acument Intellectual Properties, LLC
2
Minimum Dimensions
Minimum Installation Clearances
For proper installation, the following minimum clearances must exist above and below the cutout opening.
Above Cabinet/Storage Drawer Installation Above Oven/Warming Drawer Installation
A
⁵⁄₁₆"
(8 mm)
1"
(25 mm)
⁵⁄₁₆"
(8 mm)
B
C
Below Counter Installation Below Built-in Cooktop Installation
D
E
A
⁵⁄₁₆"
(8 mm)
3"
(76 mm)
See note
below.
⁵⁄₁₆"
(8 mm)
A. Cutout floor B. Cabinet or storage drawer
C. Oven or warming drawer facing (Overlaps
lower opening. A minimum distance of 3/4" [19 mm] must exist between cutout floor [A] and lower appliance if microwave oven is installed over heat source.)
D. Countertop
E. Built-in cooktop (non-vented)
NOTE: The bottom of the cooktop may be sunk into the counter and lower cabinet. The minimum 3" (7.6 cm) clearance must exist below the lowest point of the cooktop, and there must be no interference between any part of the cooktop (including any gas fittings) and the microwave oven.
3
Minimum Cutout Dimensions
26 ⁄₄ (66.7 cm)
NOTE: Depth dimension may be 21³⁄₄" (55.2 cm) with non-flush receptacle only if the receptacle is located in upper right or upper left corner. See “Cutout Top View.”
W idthW idth
17³⁄₄"
(45.1 cm)
min.
*With flush receptacle, or with non-flush receptacle located in
upper right or upper left corner of cutout.
**With non-flush receptacle.
†The minimum distance of 3/4" (19 mm) must exist if microwave
oven is installed over a heat source (oven, warming drawer, etc.).
Width 28¹⁵⁄₃₂" (72.3 cm) ± 1/16" (2 mm)
Height 17³⁄₄" (45.1 cm) for all installations
Depth 21³⁄₄" (55.2 cm) with flush receptacle, or with non-flush
receptacle located in upper left or upper right corner; 26¹⁄₄" (66.7 cm) with non-flush receptacle
28¹⁵⁄₃₂" (72.3 cm)
Cutout Top View
A B C D
17
¹⁵⁄₁₆"
(45.5 cm)*
26
¹⁄₄"
(66.7 cm)
21³⁄₄"
(55.2 cm)
A. Microwave oven B. Non-flush receptacle C. Flush receptacle D. Non-flush receptacle located in upper right
or upper left corner
Product Dimensions
21⁷⁄₈"
(55.6 cm)
¹⁄₂"
17
(44.5 cm)
¹⁄₄"
18
(46.4 cm)
¹⁄₄"
21
¹³⁄₃₂"
23
(59.5 cm)*
(54.0 cm)*
*Measurements include front facing of microwave oven. Depth
measurement also includes door handle.
4
Electrical Requirements
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death, fire, or electrical shock.
Observe all governing codes and ordinances.
Required:
A 120 Volt, 60 Hz, AC only, 15- or 20-amp electrical supply
with a fuse or circuit breaker.
Recommended:
A time-delay fuse or time-delay circuit breaker.
A separate circuit serving only this microwave oven.
GROUNDING INSTRUCTIONS
For all cord connected appliances:
The microwave oven must be grounded. In the event of an electrical short circuit, grounding reduces the risk of electric shock by providing an escape wire for the electric current. The microwave oven is equipped with a cord having a grounding wire with a grounding plug. The plug must be plugged into an outlet that is properly installed and grounded.
WARNING: Improper use of the grounding plug can
result in a risk of electric shock. Consult a qualified electrician or serviceman if the grounding instructions are not completely understood, or if doubt exists as to whether the microwave oven is properly grounded.
Do not use an extension cord. If the power supply cord is too short, have a qualified electrician or serviceman install an outlet near the microwave oven.
SAVE THESE INSTRUCTIONS
INSTALLATION INSTRUCTIONS
Install Spacer Strips
The provided self-adhesive spacer strips must be installed on the cutout floor, as shown below. They are to be installed under the feet of the microwave oven. This raises the microwave oven 1/8" (3 mm) to ensure enough clearance for the door to open fully, without obstruction from an installed lower appliance.
A
10³⁄₈" (26.4 cm) 10³⁄₈" (26.4 cm)
B
A. Spacer strips in place B. Centerline
To Install Spacer Strips:
1. Mark centerline on floor of cutout opening.
2. Measure and mark 10³⁄₈" (26.4 cm) out on either side of
centerline.
3. Remove adhesive backing from each strip.
4. Place one spacer strip flush with the front edge of the cutout
opening. Make sure it is centered at 10³⁄₈" (26.4 cm) out from centerline, as shown.
5. Place second spacer strip directly behind the first spacer
strip.
6. Repeat on other side.
5
Loading...
+ 11 hidden pages