Page 1
QUICKSTART GUIDE
DH7
7" 4K 1920 x 1200 HDMI Monitor w/ Canon LP-E6 & Sony L
What’s Included
1 x DH7 Monitor
1 x AC Adapter
1 x Camera Shoe Mount
1 x Screen Wipe
1 x Screen Protection Film
1 x Sunhood
1 x USB Drive
1 x Canon E6 Battery Plate
1 x Sony L Series Battery Plate
www.ikancorp.com
support@ikancorp.com © 2015 ikan Corporation. All rights Reserved
CHECKED BY
713.272.8822
Page 2
Getting Started
FRONT
4
3
10
2
1
1920 x 1200
7 In.
BACK
Menu Button - Scroll Wheel
1
Used to enter and navigate the menu.
Exit / Aspect
2
Used to exit the menu.
Function Buttons
3
Functions can be selected in the menu
1
MENU
DC
7~ 24V
11
2
EXIT
7 8
Model: DH7
Picture Size: 7 inch
Resolution: 1920X1200
Aspect Ratio: 16:9/4:3
Color System: NTSC/PAL
Operating Volts: DC 7 ~ 24V
www. ikancorp. com
9
4K HDMI LCD MONITOR
10
RoHS
COMPLIANT
MADE IN CHINA
F2 F1
201508270001
DH7
3.5mm Headphone Output
7
HDMI Output Terminal
8
USB Connector
9
Used for Software Updates
1/4"-20 Threaded Insert
10
3
PRESS DOWN
OUT HDMI IN
4
POWER
5
6
Power Button
4
Power ON/OFF
Battery Plate Release
5
Releases Battery Plate
HDMI Input Terminal
6
DC 7-24V Power Terminal
11
Standard DC Connection
DV Battery Plate Slot
12
Used for mounting DV Battery plate
Page 3
Battery Plate Installation & Removal
Installation
To Install Battery Plate by pressing down on the battery plate, and pushing it left
until you hear it click into place.
3. Push plate to the left until it clicks!
1. Position plate against “Press Down” Button
2. Press down on Battery plate
Removal
To Remove your battery plate, simply press down on the Release Button, then push
the Battery Plate to the right until the plate releases.
1. Press down on Release Button
2. Push to the right until plate releases
Page 4
Configuration of Setting Menus
Guides Toggle between the following: 80%, 90%, 15:9, 4:3, 1.5:1, 2:1, 2.35:1
Crosshair Activates Crosshair on center of screen.
Grids Activates grid on the screen to assist with framing.
Video Config Brightness: 0-100
Contrast: 0-100
Chroma: 0-100
Sharpness: 0-100
Tint: 0-100
Color Temp 5600K, 6500K, 9300K, Manual
Backlight Allows user to fine tune the intensity of the LCD Panel’s backlight.
Aspect Allows user to change the aspect ratio of the image.
System Config OSD - Language: Choose between English & Chinese for OSD.
OSD - Duration: Choose how long the menu stays active without activity.
OSD - Transparency: Choose from low, medium, high, or off.
MENU Setup - Allows 5 users to save menu settings.
System Reset - Reset Settings to factory defaults.
Flip Control Flip Image and/or Menu
Low Battery Alarm - Warns the user when battery is low.
Function Set Up 1-8
Guides
Crosshair
Peaking
Underscan
DSLR Scaling
Pixel-to-Pixel
Zooming
Check Field
HV Delay
Grids
False Color
Audio Wave
Clip Guides
Histogram
5DII Rec.
Firmware Version
Information
Update (USB)
Displays a crosshair on the center of the screen.
The DH7 is equipped with Monochrome Peaking features, which highlight
the desired focus area in a bright, red outline. The operator adjusts the focus
control until the red indicator outlines on the desired area are razor sharp,
indicating optimal focus. For best results, be sure object is properly exposed.
The DSLR Scaling function will allow users to extend their DSLR camera’s
HDMI Video Output any option of four; Normal 3:2, 16:9, or Full Screen.
Convenience Made simple.
The 1:1 pixel to pixel mapping allows you to emphasize on individual chosen
elements in the shot. This feature is essential for ensuring you are in focus.
This feature allows you to enlarge the image up to 3x
Toggles between the Blue only, Red only, Green only, & Mono Modes.
This is to help calibrate the image.
This function displays the blanking portion of the incoming signal.
Activates grid on screen to assist with framing.
This feature utilizes a full spectrum of assigned color indicators, ensuring
flawless shot exposure. Under/Over luminance warnings enable the user to
get the desired quality every time.
NOTE:
To see further options
for an active function,
hold the function key
for 2 seconds until
option mode appears.
Displays Audio Stereo Levels.
The DH7 offers adjustable upper Clip Guide levels to accurately display
overexposed images in any shooting condition. The operator simply assigns
the upper IRE to their preference and any exposure over the set IRE limit will
flash in a vivid purple, indicating only the over exposed area.
A graphical representation of the pixels exposed in your image. The left side
of the graph represents the blacks or shadows, the right side represents the
highlights or bright areas and the middle section is mid-tones. How high the
peaks reach represent the number of pixels in that particular tone. This tool
helps you get proper exposure.
Displays currently installed firmware.
Used to update firmware when a USB containing update file is inserted.
Page 5
Specifications
Aspect Ratio
Backlight
Brightness
Build Material
Color Depth
Color System
Contrast Ratio
Dimensions
Input Voltage
Inputs
Operating Temperature
PAL/NTSC/SECAM (Auto-Detected)
0°C~50°C / 32°F~122°F
16 x 10
LED
300cd/m2
Heavy Duty Plastic
16.7 Million
800:1
7.2 x 4.5 x 0.6 In.
DC 7V - 24V
HDMI
Supported Video Signals
HDMI
1280x720p @ 23.97, 24, 25, 29.94, 30, 50, 59.94, 60 Hz
1920x1080p @ 23.97, 24, 25, 29.94, 30, 50.94, 60 Hz
3840x2160p @ 24, 25, 30 Hz
Outputs
Pixel Pitch
Power Consumption
Resolution
Response Time
Screen Size
Viewing Angle
Weight
Shipping Dimensions
Shipping Weight
0.07875 x 0.07875 mm
178° horizontal / 178° vertical
720x480i & 720x480p @ 59.94, 60 Hz
720x576i @ 50 Hz
1920x1080i @ 50, 59.94, 60 Hz
1920x1080psf @ 24, 25, 29.97, 30 Hz
HDMI
6W
1920 x 1200
20ms
7 In.
0.5 lbs
3 x 14.75 x 7.75 In.
2 lbs
Optional Accessories
MOUNTS
MA207
MA211
MA211-R
BATTERY
PLATES
BP5-C
BP5-E6
BP5-P
BP5-S
BP5-N
BP5-PG6
BP5-SU
11 In. Articulating Arm w/ Single Rod Mount
7 In. Articulating Arm
11 In. Articulating Arm
Canon 900 Battery Plate
Canon LP-E6+ Battery Plate
Panasonic D54 Battery
Sony L Series Battery Plate
Nikon EN-EL15 Battery Plate
Panasonic G6 Battery Plate
Sony BP-U Series Battery Plate
Page 6
Learn More
More dynamic information at official website: www.ikancorp.com
Support
Contact email: support@ikancorp.com
CONDITIONS OF WARRANTY SERVICE
• Free service for one year from the day of purchase if the problem is caused by manufacturing errors.
• The components and maintenance service fee will be charged if the warranty period is expired.
Free Service will not be Provided in the Following Situations:(*Even if the product is still within the warranty period.)
• Damage caused by abuse or misuse, dismantling, or changes to the product not made by the company.
• Damage caused by natural disaster, abnormal voltage, and environmental factors, etc.
©2015 ikan Coporation. All rights reserved
Loading...