Iiyama PROLITE LH5563S, PROLITE TH5563MTS User Manual
USER MANUAL
Thank you very much for choosing the iiyama
LCD monitor.
We recommend that you take a few minutes
to read this comprehensive manual carefully
before installing and switching on the monitor.
Please keep this manual in a safe place for
your future reference.
ENGLISH
ENGLISH
CE MARKING DECLARATION OF CONFORMITY
This LCD monitor complies with the requirements of the EC Directive 2004/108/EC “EMC Directive”
and 2006/95/EC “Low Voltage Directive”.
Warning
This is a class A product. In a domestic environment this product may cause radio interference in
which case the user may be required to take adequate measures.
IIYAMA CORPORATION: Breguetlaan 8, 1438BC Oude Meer The Netherlands
ENGLISH
We recommend recycling of used product. Please contact your dealer or iiyama
service center. Recycle information is obtained via the Internet, using the address:
http://www.iiyama.com
You can access the Web page of different countries from there.
We reserve the right to change specifi cations without notice.
All trademarks used in this user manual are the property of their respective owners.
ENGLISH
TABLE OF CONTENTS
FOR YOUR SAFETY ..........................................................................1
SAFETY PRECAUTIONS ..............................................................1
SPECIAL NOTES ON LCD MONITORS .......................................3
CUSTOMER SERVICE .................................................................3
CLEANING ....................................................................................3
BEFORE YOU OPERATE THE MONITOR ........................................4
FEATURES ....................................................................................4
CHECKING THE CONTENTS OF THE PACKAGE ......................4
UNPACKING .................................................................................5
SPECIAL NOTES ON : ProLite TH5563MTS ................................5
CONTROLS AND CONNECTORS : MONITOR ............................6
INSTALLATION .............................................................................8
CONTROLS AND CONNECTORS : REMOTE CONTROL .........10
PREPARING THE REMOTE CONTROL .....................................11
BASIC OPERATION ....................................................................12
CONNECTING YOUR MONITOR : ProLite TH5563MTS ...........15
CONNECTING YOUR MONITOR : ProLite LH5563S .................16
COMPUTER SETTING ...............................................................18
OPERATING THE MONITOR ...........................................................19
ADJUSTMENT MENU CONTENTS ............................................21
SCREEN ADJUSTMENTS ..........................................................27
POWER MANAGEMENT FEATURE ...........................................30
TROUBLE SHOOTING ....................................................................31
RECYCLING INFORMATION ...........................................................32
APPENDIX ......................................................................................33
SPECIFICATIONS : ProLite TH5563MTS ...................................33
SPECIFICATIONS : ProLite LH5563S ........................................34
DIMENSIONS ..............................................................................35
COMPLIANT TIMING ..................................................................36
PIP SUPPORT SCREEN TABLE ................................................37
FOR YOUR SAFETY
SAFETY PRECAUTIONS
WARNING
STOP OPERATING THE MONITOR WHEN YOU SENSE TROUBLE
If you notice any abnormal phenomena such as smoke, strange sounds or fumes, unplug the monitor
and contact your dealer or iiyama service center immediately. Further use may be dangerous and can
cause fi re or electric shock.
NEVER REMOVE THE CABINET
High voltage circuits are inside the monitor. Removing the cabinet may expose you to the danger of fi re
or electric shock.
DO NOT PUT ANY OBJECT INTO THE MONITOR
Do not put any solid objects or liquids such as water into the monitor. In case of an accident, unplug
your monitor immediately and contact your dealer or iiyama service center. Using the monitor with any
object inside may cause fi re, electric shock or damage.
INSTALL THE MONITOR ON A FLAT, STABLE SURFACE
The monitor may cause an injury if it falls or is dropped.
DO NOT USE THE MONITOR NEAR WATER
Do not use where water may be splashed or spilt onto the monitor as it may cause fi re or electric
shock.
OPERATE UNDER THE SPECIFIED POWER SUPPLY
Be sure to operate the monitor only with the specifi ed power supply. Use of an incorrect voltage will
cause malfunction and may cause fi re or electric shock.
ENGLISH
PROTECT THE CABLES
Do not pull or bend the power cable and signal cable. Do not place the monitor or any other heavy
objects on the cables. If damaged, the cables may cause fi re or electric shock.
ADVERSE WEATHER CONDITIONS
It is advisable not to operate the monitor during a heavy thunder storm as the continual breaks in
power may cause malfunction. It is also advised not to touch the plug in these circumstances as it may
cause electric shock.
FOR YOUR SAFETY 1
CAUTION
INSTALLATION LOCATION
Do not install the monitor where sudden temperature changes may occur, or in humid, dusty or smoky
areas as it may cause fi re, electric shock or damage. You should also avoid areas where the sun
shines directly on the monitor.
DO NOT PLACE THE MONITOR IN A HAZARDOUS POSITION
The monitor may topple and cause injury if not suitably located. Please also ensure that you do not
place any heavy objects on the monitor, and that all cables are routed such that children may not pull
the cables and possibly cause injury.
MAINTAIN GOOD VENTILATION
Ventilation slots are provided to keep the monitor from overheating. Covering the slots may cause fi re.
ENGLISH
To allow adequate air circulation, place the monitor at least 10 cm (or 4 inches) from any walls.
Do not remove the tilt stand when operating the monitor. Ventilation slots on the back of the cabinet
will be blocked and the monitor may overheat if the stand is removed. This may cause fi re or damage.
Operating the monitor on its back, side, upside down or on a carpet or any other soft material may also
cause damage.
DISCONNECT THE CABLES WHEN YOU MOVE THE MONITOR
When you move the monitor, turn off the power switch, unplug the monitor and be sure the signal cable
is disconnected. If you do not disconnect them, it may cause fi re or electric shock.
UNPLUG THE MONITOR
If the monitor is not in use for a long period of time it is recommended that it is left unplugged to avoid
accidents.
HOLD THE PLUG WHEN DISCONNECTING
To disconnect the power cable or signal cable, always pull it by the plug. Never pull on the cable itself
as this may cause fi re or electric shock.
DO NOT TOUCH THE PLUG WITH WET HANDS
Pulling or inserting the plug with wet hands may cause electric shock.
WHEN YOU INSTALL THE MONITOR ON YOUR COMPUTER
Be sure the computer is strong enough to hold the weight of the monitor, otherwise, you may damage
your computer.
DO NOT USE THE MONITOR FOR 24-HOURS CONTINUOUSLY
The monitor is not designed to work for 24-hours continuously, do not use the monitor for 24-hours
continuously.
OTHERS
ERGONOMIC RECOMMENDATIONS
To eliminate eye fatigue, do not operate the monitor against a bright background or in a dark room.
For optimal viewing comfort, the monitor should be just below eye level and 40-60 cm (16-24 inches)
away from your eyes. When using the monitor over a prolonged time, a ten minute break every hour is
recommended as looking at the screen continuously can cause eye strain.
2 FOR YOUR SAFETY
SPECIAL NOTES ON LCD MONITORS
The following symptoms are normal with LCD monitors and do not indicate a problem.
When you fi rst turn on the LCD monitor, the picture may not fi t in the display area
NOTE
because of the type of computer that is used. In this case, adjust the picture position
to the correct position.
Due to the nature of the backlight, the screen may fl icker during initial use. Turn off the
Power Switch and then turn it on again to make sure the fl icker disappears.
You may find slightly uneven brightness on the screen depending on the desktop
pattern you use.
Due to the nature of the LCD screen, an afterimage of the previous screen may
remain after switching the image, when the same image is displayed for hours. In this
case, the screen is recovered slowly by changing the image or turning off the Power
Switch for hours.
Contact your dealer or iiyama service center for the backlight replacement when the
screen is dark, fl ickering or not lighting up. Never attempt to replace it by yourself.
CUSTOMER SERVICE
ENGLISH
NOTE
CLEANING
WARNING
CAUTION
NOTE
CABINET
LCD
SCREEN
The fl uorescent light used in the LCD monitor may have to be periodically replaced.
For the warranty coverage on this component, please check with local iiyama service
center.
If you have to return your unit for service and the original packaging has been
discarded, please contact your dealer or iiyama service center for advice or
replacement packaging.
If you drop any materials or liquids such as water into the monitor when cleaning,
unplug the power cable immediately and contact your dealer or iiyama service center.
For safety reasons, turn off the power switch and unplug the monitor before you clean
it.
To protect the LCD panel, do not scratch or rub the screen with a hard object.
Never use any of the following strong solvents. These will damage the cabinet and the
LCD screen.
Thinner Benzine Abrasive cleaner
Spray-type cleaner Wax Acid or Alkaline solvent
Touching the cabinet with any product made from rubber or plastic for a long time may
cause degeneration or loss of paint on the cabinet.
Stains can be removed with a cloth lightly moistened with a mild detergent solvent. Then
wipe the cabinet with a soft dry cloth.
Periodic cleaning with a soft dry cloth is recommended.
Don't use tissue paper etc. because these will damage the LCD screen.
FOR YOUR SAFETY 3
BEFORE YOU OPERATE THE MONITOR
FEATURES
Supports Resolutions up to 1920 × 1080
High Contrast 1300:1 (Typical) / Brightness 450cd/m
Digital Character Smoothing
Automatic Set-up
Stereo Speakers
2 × 12W Stereo Speakers
Plug & Play VESA DDC2B Compliant
ENGLISH
Windows
Power Management (VESA DPMS Compliant)
VESA Mounting Standard (200mm×400mm) Compliant
®
95/98/2000/Me/XP/Vista/7 Compliant
2
(Typical)
CHECKING THE CONTENTS OF THE PACKAGE
The following accessories are included in your package. Check to see if they are enclosed with the
monitor. If anything is missing or damaged, please contact your local iiyama dealer or regional iiyama
offi ce.
Power Cable*
Touch Pen*
Quick Start Guide
CAUTION
4 BEFORE YOU OPERATE THE MONITOR
1
2
1
The rating of the Power Cable enclosed in 120V area is 10A/125V. If you are using
*
a power supply higher than this rating, then a power cable with a rating of 10A/
250V must be used. However, all guarantees and warranties are void for any
problems or damage caused by a power cable not supplied by iiyama.
*2 Accessory for ProLite TH5563MTS.
D-Sub Signal Cable
iiyama Logo Sticker
Remote Control
Safety Guide
UNPACKING
Before unpacking your monitor, prepare a stable, level, and clean surface near a wall outlet.
Set the LCD Monitor box in an upright position and open from the top of the box before removing
the top cushions.
Remove the carton holders.
Remove the top cushion and take
the accessories box and the Monitor out.
Pinch and Pull the Knob.
CAUTION
Moving the monitor requires at least two people. If not, it may drop and
could result in a serious injury.
When moving/shipping the monitor, please hold by the carton holders.
SPECIAL NOTES ON : ProLite TH5563MTS
CAUTION
Permanent damage can occur if Sharp Edged, Pointed or Metal items are used to activate Touch.
This could invalidate any remaining warranty.
We recommend you use a plastic stylus (tip R0.8 or over) or fi nger.
ENGLISH
BEFORE YOU OPERATE THE MONITOR 5
CONTROLS AND CONNECTORS : MONITOR
<Back Controller>
ENTER/SOURCE Enter/Input Select Button
MENU Menu Button
ENGLISH
Up Button
Power Button
Down Button
Left Button
Right Button
<Front>
Green Normal Operation
Power Indicator
Remote Sensor Remote Sensor
Ambient Light Sensor
6 BEFORE YOU OPERATE THE MONITOR
Red
Off
Flash : Power Management
Lighting : If turn off the Power Button on the Remote
Control and the Back Controller.
Power Off
If turn off the Main Power Switch.
Detects ambient lighting conditions around the Monitor
and adjusts screen brightness automatically when the
Ambient Light Sensor function is activated.
ProLite TH5563MTS
<Back>
ProLite LH5563S
ENGLISH
HDMI HDMI
HDMI Connector
DVI DVI-D 24pin DVI-D 24pin Connector
VGA IN D-SUB mini 15pin D-SUB mini 15pin Connector
VGA OUT D-SUB mini 15pin D-SUB mini 15pin Connector
RS232C IN D-SUB 9pin RS232C Connector
RS232C OUT D-SUB 9pin RS232C Connector
COMPONENT VIDEO RCA G/B/R Component Video Connector
S-VIDEO Mini Din 4pin S-Video Connector
VIDEO IN RCA Video Connector
VIDEO OUT RCA Video Connector
AUDIO1 (PC Audio In) Mini Jack Audio Connector
AUDIO OUT RCA L/R Audio output Connector
SPEAKERS Jack Speakers Connector
AUDIO2 RCA L/R Audio Connector
AUDIO3 RCA L/R Audio Connector
AC IN AC-INLET AC Connector (AC-IN)
AC OUT AC-OUTLET AC Connector (AC-OUT)
(ON) / (OFF) MAIN POWER Main Power Switch
Speakers Speakers
USB Cable* Touch USB Cable
* Available for ProLite TH5563MTS only.
BEFORE YOU OPERATE THE MONITOR 7
INSTALLATION
CAUTION
Follow the manual instructions for the type of mount you have selected. Refer all servicing to
qualifi ed service personnel.
Moving the monitor requires at least two people.
Before installing, please make sure the wall is strong enough to hold the necessary weight of the
display and the mount.
ENGLISH
[WALL MOUNTING]
CAUTION
When using the wall mounting, consideration of thickness of the mounting stage needs to be taken.
Tighten the M8 Screw with washer which “L” length is 10mm to fasten the monitor. Using a screw
longer than this may cause electric shock or damage because it may contact with the electrical parts
inside the monitor.
Mounting Stage
L
Screw
Chassis
8 BEFORE YOU OPERATE THE MONITOR
[INSTALLATION NOTE]
The touch kit of this monitor is an optical device that utilizes infrared light source and sensitive sensors
for touch detection.
Notice the incident light that contains large quantities of infrared light may affect touch screen operation
and performance.
Please install it with care as follows to ensure reliable touch performance.
Intense light / Specular light / Focus spotlight / Wide spread light / Direct sunlight / Indirect sunlight
from the window and/or the glass door. / Not install the touch monitor right under the light source.
*Available for ProLite TH5563MTS only.
Light source
Front Front
Side
[CAN NOT ROTATE THE DISPLAY]
It is designed to be compatible in landscape modes.
Available
Light source
Side
A
A
Landscape
Windows
Not Available
Direct
Sunlight
A
Light
source
ENGLISH
A
BEFORE YOU OPERATE THE MONITOR 9
CONTROLS AND CONNECTORS : REMOTE CONTROL
MUTE Turns off the sound.
Not available on this model.
INPUT Selects the source.
ENGLISH
YPbPr
ENTER
INFO
VGA / DVI / YPbPr /
AV / HDMI
EXIT
MENU
Navigates through submenus and
settings.
: Up Button
: Down Button
: Left Button
: Right Button
(Volume-): Decreases the sound
volume.
(Volume+): Increases the sound
volume.
Confi rms your selection or save
changes.
Provides source and resolution
information.
Selects the source.
Turns the monitor ON and OFF.
Returns to a previous menu or closes
the OSD Menu.
Opens the monitor's on-screen menu
systems. When the menu system is
already open, pressing this button will
select the previous submenu.
10 BEFORE YOU OPERATE THE MONITOR
Loading...