Iiyama AQU5611D BK, AQU5611DTBK User Manual
AQU5611D BK
AQU5611DT BK 9.2 million pixels
Color TFT LCD Monitor
USER MANUAL
P/N: 55P1003
First Edition (July 2002)
© Copyright IIYAMACORPORATION 2002. All rights reserved.
Danger Statements
DANGER
To avoid shock hazard:
v Do not remove the covers.
v Do not operate this product unless the stand is attached.
v Do not connect or disconnect this product during an electrical storm.
v The power cord plug must be connected to a properly wired and grounded power
outlet.
v Any equipment to which this product will be attached must also be connected to
properly wired and grounded power outlets.
v To isolate the monitor from the electrical supply, you must remove the plug from
the power outlet. The power outlet should be easily accessible.
Handling:
v Your color monitor is heavy, so handle it with care. iiyama recommends that this
monitor is moved or lifted by two people.
iii
iv AQU5611D BK/AQU5611DT BK 9.2 Million Pixels Color TFT LCD Monitor USER MANUAL
Notices
Attention
v Do not exert strong pressure to the surface of the monitor screen. You may break
the LCD panel.
v Do not place heavy objects on top of this product. They may damage the
monitor.
v Do not touch the monitor screen with your fingers. Fingerprints and oil stains may
remain on the screen surface. They are difficult to wipe off.
v The monitor is heavy. Ask the help of others if you cannot carry it by yourself.
v When leaving your office for a long vacation, always unplug the power cords
from the main outlet.
LCD considerations
The liquid crystals in the display panel contain several irritants. If the panel is
damaged or broken, do not let the liquid come in contact with your skin, eyes, or
mouth. If you do come in contact with the liquid, flush the affected part with running
water for at least 15 minutes. If any symptom remains, consult a doctor.
The fluorescent lamp in the liquid crystal display (LCD) contains mercury (50 mg.
(0.002 oz.) maximum). Do not place in trash that is disposed of in landfills. Dispose
of it as required by local ordinances or regulations.
Considerations on the monitor resolution
This monitor is able to display characters, graphics, and pictures at high resolution.
When you connect this monitor to a PC with a high resolution (3840 x 2400), the
characters will be displayed at 1/4 the normal size. Do not continue to operate the
PC at this character size. You can spoil your eyes. Change the character size to a
bigger size or the resolution to a lower resolution on the operating system or
application.
Operating considerations
To ensure comfortable operation of the monitor, follow the instructions below:
v Place the monitor in front of you for easy viewing.
v Place the monitor at a comfortable distance (50 –60 cm) (19 – 24 in.) from you.
v Tilt the monitor so that top of the monitor is at your eye level.
v Adjust the angle of the tilt so that there is no reflection of light and objects. If
necessary, turn off the light or lower its luminescence. If near a window, close the
curtains or pull down the blind to cut the sunlight.
v Adjust the screen brightness.
v Use a chair with a high-reclining and sit deep into it.
v Operating on the screen for long hours can cause fatigue and eyestrain. Divert
your eyes from the screen for short intervals during operation, and take short
rests.
v
License inquiries
References in this publication to iiyama products, programs, or services do not
imply that iiyama intends to make these available in all countries in which iiyama
operates. Any reference to an iiyama product, program, or service is not intended to
state or imply that only iiyama product, program, or service may be used. Any
functionally equivalent product, program, or services that does not infringe on any of
the intellectual property rights of iiyama may be used instead of the iiyama product,
program, or services. The evaluation and verification of operation in conjunction
with other products, except those expressly designated by iiyama, are the
responsibility of the user.
iiyama may have patents or patents pending which covers the subject matter in this
document. The furnishing of this document does not give you any license to these
patents. You can send license inquiries, in writing, to:
IIYAMA CORPORATION
710-1 Kitaowaribe,
Nagano-shi, 381–0014
Japan
Trademarks
iiyama logo is a registered trademark of IIYAMA CORPORATION.
ATI is a registered trademark of ATI Technologies, Inc., in the United States or other
countries, or both. FireGL is trademark of ATI Technologies, Inc.
TMDS is a trademark of Silicon Image, Inc., in the United States or other countries,
or both.
Windows is registered trademark of Microsoft Corporation, in the United States or
other countries, or both.
vi AQU5611D BK/AQU5611DT BK 9.2 Million Pixels Color TFT LCD Monitor USER MANUAL
Contents
Danger Statements .......................iii
Notices ............................v
Attention............................v
LCD considerations........................v
Considerations on the monitor resolution ................v
Operating considerations......................v
License inquiries ........................vi
Trademarks ..........................vi
Chapter 1. Before setting up....................1
Prerequisites ..........................1
Unpacking ...........................1
Checking parts .........................2
Chapter 2. Hardware setup ....................3
Locations ...........................3
Front view ..........................3
Rear view ..........................3
Setup the monitor ........................4
Storing the connector tool ....................4
Connecting the cables......................6
Chapter 3. Adjusting and maintaining your monitor ..........11
Adjusting the viewing angle ....................11
Setting the monitor control buttons..................12
Accessing the on-screen display (OSD) menus ............13
Knowing the operating status of your monitor..............16
Disconnecting the cable .....................17
Using the security keylock.....................18
Maintaining your monitor .....................18
Chapter 4. Troubleshooting....................19
Symptom list..........................19
Warranty information.......................21
Service and support ......................21
Appendix A. Specifications....................23
Supported display modes .....................24
Updating the settings for your monitor ................25
Applicable models.......................25
Procedure..........................26
Valid settings ........................28
Appendix B. Field–Replaceable Units (FRUs).............29
Appendix C. Compliance.....................31
TCO’95............................31
Congratulations! .......................31
Why do we have environmentally labelled computers? .........31
What does labelling involve? ...................31
Environmental Requirements...................32
Federal Communications Commission (FCC) Statement..........33
vii
Industry Canada Class A Emission Compliance Statement .........33
Avis de Conformitéàla Réglementation d’Industrie Canada ........33
Deutsche EMV-Direktive (electromagnetische Verträglichkeit) ........34
European Union – EMC Directive ..................34
Union Européenne – Directive Conformitéélectromagnétique........34
Union Europea – Normativa EMC ..................35
Europese Unie -- EMC-richtlijnen ..................35
Europeiska Unionen - EMC Direktiv .................36
Statements for Other Countries ...................36
Power Cord ..........................36
MPRII ............................36
Hinweise ...........................37
viii AQU5611D BK/AQU5611DT BK 9.2 Million Pixels Color TFT LCD Monitor USER MANUAL
Chapter 1. Before setting up
This manual contains information on how to set up and operate the AQU5611D
BK/AQU5611DT BK 9.2 Million Pixels Color TFT LCD Monitor, hereafter called the
monitor.
This chapter describes the following:
v Prerequisites
v Unpacking
v Checking parts
Prerequisites
You will need a personal computer or a workstation (hereafter called the computer)
with the following.
v A Dual DVI output compliant video graphics card (hereafter simply called the
DVI)
Refer to http://www.iiyama.co.jp for the latest information. iiyama is not held
responsible for any damages incurred by the installation of unsupported cards.
Unpacking
Attention: The monitor is heavy. Be careful not to drop it. The LCD is fragile and
should not be bumped on an edge, or dropped.
Open the carton box and carefully remove the monitor. Hold the bottom of the
screen firmly with both hands, as shown below.
1
Checking parts
Check the box for the following items. If any items are missing or damaged, contact
your place of purchase immediately.
h Monitor h USER MANUAL
(This book)
h Connector tool
h Power adapter and cord h Power cord
h Digital signal cable
P/N: 07N2227
Note: The digital signal cable is shipped with one end connected to the monitor.
2 AQU5611D BK/AQU5611DT BK 9.2 Million Pixels Color TFT LCD Monitor USER MANUAL
Chapter 2. Hardware setup
This chapter describes the following:
v The location of the controls, switches, and connectors.
v The procedure for setting up the monitor.
Locations
Front view
Monitor screen
Rear view
Serial number label
DC-IN connector
Video connector
OSD control
Brightness control
Power switch
Base stand
Power light
(Power on/Standby)
Connector cover
Security keyhole
Stand rear cover
Cable clampCable hook
3
Setup the monitor
Storing the connector tool
This section describes how to store the connector tool for future use. This tool will
be useful when disconnecting the cables from the monitor.
Attention:
1. Remove any objects from the surface before tilting the monitor. They might
damage your screen.
2. Be careful not to pinch your fingers between the monitor and the surface when
tilting the monitor.
To store the connector tool, do the following:
1. Clear a work space, and turn the monitor face down.
2. Remove the stand rear cover.
Stand rear cover
4 AQU5611D BK/AQU5611DT BK 9.2 Million Pixels Color TFT LCD Monitor USER MANUAL
3. Remove the connector cover.
1
Connector cover
2
2
4. Unhook the digital signal cable from the cable hook and lift it up to store the
connector tool to the rear compartment of the monitor.
Cable hook
Connector tool
Chapter 2. Hardware setup 5
Connecting the cables
This section describes how to connect the following cables:
1. Power adapter cord
2. Digital signal cable
3. Power cord
Connecting the power adapter cord
1. Connect the power adapter cord to the DC-IN connector at the rear of the
monitor. Make sure that it clicks firmly into the connector.
Top
v
iew
Video connector
DC-IN connector
Bottom view
Note: The video connectors A and B on the monitor are Safety Extra Low
Voltage (SELV) circuits.
2. Route the cables through the cable clamp and the cable hook.
Cable hook
Cable clamp
6 AQU5611D BK/AQU5611DT BK 9.2 Million Pixels Color TFT LCD Monitor USER MANUAL
Loading...