Model iH 26
The Portable System
For Your iPod
®
1
Table of Contents
®
......................................................................................................................................................................10
®
......................................................................................................................................................10
®
Shuffle ...........................................................................................................................................11
®
Shuffle........................................................................................................................................... 11
®
or other portable audio devices .....................................................................................................12
............................................................................................................................19
2
3
A Consumer Guide to Product Safety
4
Questions? Visit www.ihomeaudio.com
For any other questions: 1-800-288-2792 Toll Free
A Consumer Guide to Product Safety
5
Install Battery
Battery install for
Clock display back up
6
Controls and Indicators
Volume _ Button
Volume + Button
Alarm On/Off
Alarm Set Button
Sleep / Minute Set Button
Dock
Remote Sensor
AC Adaptor Jack
Travel Lock Switch
Alarm Armed
PM Indicator
Clock Backup Battery Low Indicator
Main
Battery Low Indicator
Time/Alarm Display
Sleep Display
iPod Indicator
Travel Lock Indicator
Clock Display
7
®
(see chart above). Using the
®
.
®
insert into the dock.
®
into the dock. (The iPod
®
must
®
, then
Getting Started
®
. Designed specifically
®
and Shuffle, this system provides high quality audio performance that brings
®
fits properly in the dock on the top of the system.
iPod 3Gen 10-15 GB
iPod 3Gen 20 GB
iPod 4Gen 20 GB
iPod Photo 30 GB
iPod 3Gen 30 GB
iPod 3Gen 40 GB
iPod 4Gen 40 GB
iPod Photo 40 GB
iPod Photo 60 GB
iPod Nano 2 GB
iPod Nano 4 GB
Replace rubber pad per
instruction on the 5G
rubber pad card
8
Using The Remote Control Unit
®
functions when the iPod® is docked in the iH26.
Sleep Button
iPod Play/Pause Button
Alarm Reset/
Power Off Button
Button
Button
Mute Button
Snooze/Dimmer Button
Volume+ Button
Volume_ Button
Tur ns iH26 ON or OFF or reset alarm when alarm is sounding
Selects iPod and plays track. In play mode, press to pause
Toggles sound ON or OFF
Selects Sleep Time function
Snooze mode when alarm sounds, otherwise dims display
Lowers volume level
Raises volume level
Skip to previous or next track when iPod is playing, or
HOLD to scan current playing track.
Battery
door
latch
9
Setting Up the iH26
Charging your iPod
®
®
and that it is properly docked into the
®
.
®
is docked in the unit and the unit is connected to an outlet (not running on batteries), it
®
s will NOT charge.
Listening to your iPod
®
®
.The iH26 will automatically turn on and you
®
. Adjust the EQ settings (treble,
®
is in play mode. Press the iPod Play/Pause
®
is docked and in standby mode, press the iPod
®
Playing mode.
®
will continue charging while in the dock.
10
11
Charging your iPod® Shuffle
Listening to your iPod® Shuffle
®
Shuffle and turn it on (see the instructions that came
®
Shuffle is in playing mode.
/ Volume Button to adjust the system volume. Adjust the volume on your Shuffle to no
12
®
or other portable audio devices
®
without a docking port or other MP3 player or other portable audio device, you can
®
is docked in the iH26.
and V olume Button on the iH26 (or Volume
CD player
13
Alarm Operation
®
, YOUR iPOD® MUST BE PROPERLY DOCKED AND OFF (NOT IN PLAY
Power Off
®
has enough songs to play for 1 hour, otherwise please set the iPod® repeat
®
present or there is no music detected on the iPod® at alarm time, the iH26 will
14
Sleep Operation
®
, press the Sleep Button to enter sleep mode. The unit will
or Volume Buttons (or press Volume and Volume Button on the remote
Power On/Off Button on the remote
Snooze/Dimmer Operation
Travel Lock Operation
will appear
Operating the Remote Control
15
Troubleshooting
AC adaptor isn’t plugged into a wall outlet
or the connector is not plugged into the
power supply jack on the back of the unit
Plug the AC adaptor into a wall outlet and plug the connector
into the supply jack on the unit
Wall outlet is not functioning. Plug another device into the same outlet to confirm the outlet
is working
Using no or wrong iPod insert
Make sure the dock insert is the proper fit for your iPod
iPod not installed properly Remove your iPod from the dock and check for obstruction
on the connectors in the dock and on your iPod. Then reseat
it in the dock.
Batteries are weak Replace with new batteries
Batteries were not installed properly Check to make sure the polarity ( + and – ends) matches
the diagram in the battery compartment
iPod is not installed properly Remove your iPod from the dock and check for obstruction
on the connectors in the dock and on your iPod. Then reseat
it in the dock.
Your iPod software is too old Upgrade software on your iPod. For details visit
http://www.apple.com/ipod/download
iPod is locked up Please make sure your iPod is working properly before
docking into the unit. Please refer to your iPod manual for
details.
Using 1
st
or 2nd generation iPod, iPod
Shuffle or other devices.
iH26 cannot control those iPods or other devices.
Travel Lock is in Lock position
Move Travel Lock to Remote position
Batteries are weak and dead
Replace with new batteries
16
Troubleshooting
on the connectors in the dock and on your iPod. Then reseat
it in the dock.
iPod is locked up/ frozen
iPod battery has problem
Please make sure your iPod is working properly before
docking into the unit. Please refer to your iPod manual for
details.
Sound source is distorted If the iPod original sound source (MP3) is of poor quality,
distortion and noise are easily noticed with high-power
speakers. Try a different audio source such as a music CD.
If you are using an external sound source like older generation
of iPod or iPod Shuffle, try reducing the output volume on
the device itself. Also try turning bass boost OFF.
Battery weak Replace current battery with new battery
Remote Control is not pointed toward the
iH26 remote sensor or sensor is blocked
Point the Remote Control toward the iH26, move within 10
feet of the unit, make sure sensor is unobstructed
17
Solucionando problemas
El adaptador de AC no está conectado al
tomacorriente o el conector no está conectado
a la ficha en la parte posterior de la unidad
Conecte el adaptador de AC al tomacorriente y también
conecte el conector a la ficha en la parte posterior de la unidad
El tomacorriente no funciona Coloque otro aparato en ese mismo tomacorriente para
confirmar si el que no funciona es el tomacorriente
No ha colocado el encastre del iPod, o está
utilizando el encastre incorrecto.
Verifique que el encastre sea el apropiado para su iPod
El iPod no encastra correctamente Quite el iPod del encastre y retire la posible obstrucción del
encastre o de su iPod. Vuelva a colocar el iPod dentro del
encastre.
Las baterías están gastadas Reemplace las baterías
Las baterías no están instaladas
correctamente
Verifique que la polaridad de las baterías (- y +) se encuentr en
de acuerdo al diagrama del compartimiento de baterías.
El iPod no está instalado correctamente Quite el iPod del encastr e y verifique posibles obstrucciones
del encastre o de su iPod. Vuelva a colocar el iPod dentro
del encastre.
Su software es obsoleto Renueve su software. Para mayor información, diríjase a
http://www.apple.com/ipod/download
El iPod no responde Verifique que su iPod funcione correctamente antes de
conectarlo a la unidad. Refiérase al manual de su iPod para
más detalles.
Usted tiene un iPod de primera o segunda
generación, un Shuffle u otro tipo de aparato
El iH26 no puede controlar estos otros aparatos
Causa Solución
La Traba para Viaje se encuentra en
ON (trabada), y no habilita las funciones
de los botones
Asegúrese que la Traba para Viaje esté en la posición
Remote (alejado)
Las baterías están gastadas Reemplace las baterías
18
Solucionando problemas
encastre o de su iPod. Vuelva a colocar el iPod dentro del
encastre.
El iPod está trabado/no responde
La batería del iPod podría tener algún
inconveniente
Por favor asegúrese de que su iPod funcione correctamente
antes de colocarlo en el encastre. Refiérase al manual de
su iPod para mayor información.
El volumen se encuentra muy alto Baje el volumen
El sonido sale distorsionado de la unidad Si el sonido original de su iPod era de pobre calidad, las
distorsiones y ruidos se harán más notables con los
parlantes de alta potencia. Pruebe utilizar otra fuente de
audio como un CD.
Si está utilizando un iPod de primeras generaciones o un
Shuffle, intente bajar el volumen de su aparato. También
intente apagar el amplificador de bajos
Las baterías están gastadas Reemplace las baterías por nuevas
No está apuntando el control remoto
hacia el iH26
Apunte el control remoto hacia el iH26 y manténgase a una
distancia máxima de 10 pies de la unidad.
Limited 90-Day Warranty Information
Consumer Repair Department
SDI Technologies Inc.
1330 Goodyear Drive
El Paso, TX 79936-6420
Questions? Visit www.ihomeaudio.com
For any other questions: 1-800-288-2792 Toll Free
19
Loading...