iHome iH12 User Manual
Model iH12
Dual Alarm Cube Clock
Radio For Your iPod
Questions? Visit www.ihomeaudio.com
Table of Contents
Quick Start
Controls and Indicators
iH12 Display
Install Clock Backup Battery
Using The Remote Control Unit
Install/Replace the Remote Control Battery
To check for iPod compatibility
Setting Up the iH12
Setting Time and Calendar
Using the Alarm
Charging you iPod
Listening to iPod
Listening to non-docking iPod or other portable audio devices
Dimme Operation
Listening to Radio
Sleep Operation
Click Sound Operation
3D Sound Operation
A Consumer Guide to Product Safety
Trouble Shooting
Solución De Problemas
Warranty Information
1
2
3
3
4
5
6
6
7
7
7
8
8
8
8
9
10
11
12
Maintenance
• Place the unit on a level surface away from sources of direct sunlight or excessive heat.
• Protect your furniture when placing your unit on a natural wood and lacquered finish. A cloth or other protective material
should be placed between it and the furniture.
• Clean your unit with a soft cloth moistened only with mild soap and water. Stronger cleaning agents, such as Benzine, thinner
or similar materials can damage the surface of the unit.
FCC Information
This device complies with part 15 of the Federal Communications Commission Rules. Operation is subject to the condition
that this device does not cause.
Quick Start
1:power
Attach AC adaptor cable to jack on
back of the iH12 and plug the other
end into a wall socket.
Use this insert
For this iPod
NOTE: If the insert for your iPod isn’t listed, please visit an Apple store or www.ihomeaudio.com
iPod Touch
insert 14
iPod Touch
2:inserts
Select the dock insert for your
iPod model from the table below
and place insert in dock.
Never dock an iPod without
an insert in place.
3rd Gen nano
insert 13
3rd Gen nano
to purchase the proper insert.
thin iPod with video (30 GB)
Insert 9
thin (30 GB) iPod with video
thin (80GB) iPod classic
3:iPod
Insert iPod into dock with proper
insert (iPod must not be in a skin or
case). iPod will charge while docked.
Press the Play Button on the iH12 to play
iPod.
iPod with video (60,80 GB)
Insert 10
thick (60, 80 GB) iPod with video
thick (160 GB) iPod classic
1
<< Button
Controls and Indicators
Top panel
iPod Dock
Alarm-1 Button
Alarm-2 Button
Alarm Reset /
Power On/Off Button
Wake-to Button
Front panel
Snooze/Dimmer Button
Clock Adj Button
Preset Button 1-4
iPod Play/Pause Button
>> Button
Volume + Button
Volume - Button
Radio/Aux Button
Sleep Button
Back panel
Time Zone Button
2
DST Switch
AM Loop
Antenna Socket
Line-in JACK
iH12 Display
Alarm 1 Indicator
Alarm 2 Indicator
iPod Indicator
Wake-to Indicator
Wake-to Radio Indicator
Wake-to Buzzer Indicator
Time Display
Radio Frequency
or Alarm Time Indicator
(PM) Alarm Time Indicator
Sleep Indicator
Install Clock Backup Batteries
The iH12 uses 2 alkaline “AA” batteries to provide continuous alarm operation
and clock settings in the event of a power failure. If the backup batteries have
been installed and a power failure occurs or the AC cord is accidentally disconnected, the display backlight will not remain lit, but current time and alarm time
settings will be temporarily maintained. Otherwise, you must reset the time and
alarm settings.
1. Please make sure the AC adaptor is connected. Otherwise all settings may
be lost during battery replacement.
2. Open backup battery compartment door located on the bottom of the unit.
3. Insert 2 AA batteries, checking that the polarity (+ and – ends of the battery)
matches the drawing near the battery compartment. Close the compartment door.
Note: Make sure you dispose of batteries properly (see your local regulations).
Daylight Saving Time
Indicator
Battery Low Indicator
PM Indicator
Line in Indicator
(AM, FM1 & FM2)
Radio band Indicator
Installing Backup Batteries
3
Loading...