IgniteNet IRAC750 Quick Start Guide

Quick Star t Guide

Cloud-Enabled Enterprise Access Point

The Spark AC750 are dual AP. The units are designed to be operated either placed
on a desk or mounted on a wall or ceiling. The package includes a mounting plate
for attaching the AP to a wall or ceiling T-bar. The APs can be powered either by the
universal power supply included in the package, through an Ethernet cable
connection from a Power-over-Ethernet (PoE) injector, or from a 802.3af-compliant
PoE switch.

The Cloud-Enabled Enterprise Access Point includes these models:



IR-AC750 & IR-AC750-EU — dual-band concurrent enterprise AP with
integrated antennas plus passive Power-over-Ethernet (PoE)

Note: For Safety and Regulatory information, refer to the Safety and Regulatory

Information document included with the AP.

www.ignitenet.com

– 1 –

Quick

Start

Follow the steps in this guide to install the AP in your network.

Caution: The planning and installation of the AP requires professional personnel

that are trained in the installation of radio transmitting equipment. The user is
responsible for compliance with local regulations concerning items such as antenna
power for instance. Therefore, it is recommended to consult a professional
contractor knowledgeable in local radio regulations prior to equipment installation.

1. Unpack the AP

Unpack the AP and check the package contents.



Cloud-Enabled Enterprise Access Point Spark
AC750



Mounting plate



Mounting kit — 4 screws, 4 wall plugs, and 4 rubber feet



Universal AC/DC power adapter



Documentation —Quick Start Guide and Regulatory and Safety Information

2. Mount the AP Using the AP on a desktop

If the AP is not mounted on a wall or on the ceiling, place the provided rubber feet
on the AP.

Desktop Mounting

1

1

Place the provided rubber feet over

1

the four screw holes.

1

1

–

Quick

Start

2

1

Mounting the AP on a wall

Mount the unit on a wall using the mounting plate, screws, and wall plugs provided
in the mounting kit.

Wall Mounting

At the installation location, hold the mounting

1

plate against the wall with its release tab pointing
down.

Mark the four holes for the wall plugs and screws.
Drill four holes for the wall plugs, and then insert
the plugs and tap them flush with the wall surface.

Align the mounting plate with the four holes, and
then use the four screws to secure it to the wall.

With its ports facing down, place the AP against

2

the wall above the mounting plate.
Slide the rails on the back of the AP down onto the

mounting plate until it snaps into its secured
position. Do not let go of the AP until you confirm
that it is secure.

–