Ignis EB1200 User Manual

ACCALIA

Ventless Ethanol Fireplace

User’s Manual

Installation Instructions

What’s in the box:

Fireplace Body 1pc
EB1200 Burner 4pcs
Mounting Bracket 1pc
Wall Plugs & Screws 4pcs
Control Tool 1pc
Tempered Glass (if equipped) 1pc
User’s Manual 1pc

Installation Instructions

The fireplace must only be installed on a solid wall of non combustible material.

The Accalia Fireplace can be installed directly on the wall simply by mounting
the bracket and hanging the fireplace on it. For recess insatallation please follow
instructions below.

1. Unpack the fireplace and check for damage incurred in transit and missing
parts make sure to remove the mounting bracket prior to discarding the box.

2. Cut the opening in the wall according to sizes on Diagram 1. Your finished
opening should be 4 inches wider and 2-1/2 inches higher then the back of
the fireplace structure (including burners hanging from the bottom of the
fireplace) - refer to Diagram 2. This allows for faster installation and the added
space allots for air circulation and provides an escape for the hot air.

3. The depth of the finished opening should be no greater then 6-1/2 inches, but
could be less.

4. Inside walls of the recess opening should be made of or lined with a fireproof
material such as cement board, wonder board, steel sheet. Use metal studs
for framing.

5. Install the bracket 4 inches below the top of the opening and evenly centered.
You want to leave at least 1 inch above the insert to the top of the opening.

6. Insert fireplace into opening closer to the left side. Align bracket on the back
of the fireplace to the top of the bracket mounted on the wall and slide to the
right to lock in place.

7. Place the burners into the opening of the fireplace body.

www.ignisproducts.com

Accalia - User’s Manual

Diagram 1

Recessed Opening Sized for Accalia Fireplace

A = 61” B = 17-1/2” C = 6-1/2” D = 4”

Diagram 2

Accalia Fireplace Dimensions

www.ignisproducts.com

Operation Instructions

Step 1: Adjust the sliding lid to its widest opening. Fill the burner with the ethanol,
watch carefully untill you reach under the level of the “Max” line. Do not overfill or
spill.

CAUTION: Please ensure your pebbles or logs are not covering the opening in case of
accidental spillage.
Any spilled ethanol must be immediately removed with an absorbent tissue and
cleaned with water to prevent ignition outside the burner reservoir.

Fuel must be kept in safe distance (min. 1 meter / 40 inches) from the fireplace. Do
not place fuel in front of the fireplace.

Step 2: Use a long match or a long lighter to ignite. When igniting, keep a safe distance

at arm’s length. Do not stand directly over the burner.

CAUTION: Fuel will burn low at first. Please allow 10-15 minutes to reach the optimal
temperature and flame height.
Opening or closing the sliding cover on the burner can adjust the flame.
Avoid drafts for long burning time.

Always maintain a safe distance of at least 1 meter (40 inches) from the fireplace
when the flame is lit.

www.ignisproducts.com