iGas R407C User Manual
Material name: R407C
Version #:1.0 Revision date: 11-20-2018.
SDS US
1 / 6
Issue date:04-29-2015.
Safety Data
Sheet
According to Hazard Communication Standard (29 CFR
1910.1200
)
R
407C
Issue date: 04/29/2015 Version 1.0 Revision date: 11/20/2018
1. Identification
Product name R407C
Synonyms -
CAS # See section 3
Product code -
Product use Used as refrigerants.
Manufacturer/Supplier
Supplier(Manufacturer):
Address:
Contact person(E-mail):
iGas USA, Inc.
8105 Anderson Road, Tampa, FL 33634
acoughlin@bmp-usa.COM
Telephone:
(813) 443-0757
Fax: (813) 886-7900
Emergency telephone Number:
2. Hazard(s) identification
GHS classification
Physical hazards Health
hazards Environmental
hazards
GHS label elements
Hazard Pictograms
Gases under pressure
Not classified
Not classified
Liquefied gas
Signal word
Hazard statement
Precautionary statement
Prevention
Warning
Contains gas under pressure; may explode if heated.
Not applicable.
Response Not applicable.
Storage
Protect from sunlight. Store in a well-ventilated place.
Disposal
Not applicable.
3. Composition / information on ingredients
Components CAS# Percent
Norflurane 811-97-2
52±2%
Pentafluoroethane
Difluoromethane
4. First-aid Measures
354-33-6
75-10-5
25±2%
23±2%
Material name: R407C
Version #:1.0 Revision date: 11-20-2018.
SDS US
2 / 6
Issue date:04-29-2015.
First aid procedures
Eye contact
Immediately irrigate with eyewash solution or clean water, holding the eyelids apart, for
at least 10 minutes. Obtain immediate medical attention.
Skin contact
Inh
alation
Ingestion
Notes to p
hysician
5. Fire-fighting measures
Thaw affected area with water. Remove contaminated clothing. Caution: clothing may
adhere to the skin in the case of freeze burns. After contact with skin, wash
immediately with plenty of warm water. If irritation or blistering occur obtain medical
attention.
Remove patient from exposure, keep warm and at rest. Administer oxygen if
necessary. Apply artificial respiration if breathing has ceased or shows signs of failing.
In the event of cardiac arrest apply external cardiac massage. Obtain immediate
medical attention.
Ingestion is not considered a potential route of exposure. Do not induce vomiting.
Provided the patient is conscious, wash out mouth with water and give 200-300 ml
(half a pint) of water to drink. Obtain immediate medical attention.
Treat symptoms.
Flammable properties Non flammable.
Extinguishing media
Suitable extinguishing media
Unsuitable extinguishing media
Firefighting equipment/instructions
Hazardous combustion products
6. Accidental release measures
Use appropriate extinguishing media.
Not available.
Shut off gas supply if this can be done safely. If possible, take container out of
dangerous zone. Cool cylinders with water spray. Self-contained breathing apparatus
(SCBA) may be required if cylinders rupture or release under fire conditions.
Hydrogen fluoride by thermal decomposition and hydrolysis.
Personal precautions Immediately contact emergency personnel. Keep unnecessary personnel away. Use
suitable protective equipment (section 8). Shut off gas supply if this can be done safely.
Isolate area until gas has dispersed.
Environmental precautions
Methods for cleaning up
Prevent liquid from entering drains, sewers, basements and work pits since the vapor
may create a suffocating atmosphere.
Provided it is safe to do so, isolate the source of the leak. Allow small spillages to
evaporate provided there is adequate ventilation. Large spillages: Ventilate area.
Contain spillages with sand, earth or any suitable adsorbent material.
7. Handling and storage
Handling Avoid inhalation of high concentrations of vapors. Atmospheric levels should be
controlled in compliance with the occupational exposure limit. Atmospheric
concentrations well below the occupational exposure limit can be achieved by good
occupational hygiene practice. The vapor is heavier than air, high concentrations may
be produced at low levels where general ventilation is poor, in such cases provide
adequate ventilation or wear suitable respiratory protective equipment with positive air
supply. Avoid contact with naked flames and hot surfaces as corrosive and very toxic
Loading...