Igadgitz Disnix S1 User Manual

iGadgitz ‘Disnix’ S1 Waterproof Bluetooth Speaker (U3614)

For more instructions in English please
visit:

www.igadgitz.com/guides

Eine Anleitung in Deutsch ¬nden Sie
unter:

Para obtener instrucciones en Español
por favor visite:

Pour obtenir des instructions en
Français s'il vous plaît aller à:

Per istruzioni in Italiano si prega di
visitare il sito:

Ref

Function

1

During Music Playback: Play or Pause
During incoming call: Answer call or End call
All: Hold for 2½ seconds to disconnect Bluetooth

2

Up selection key:
Short press (<1 second): Selects Previous track
Long press (>2 seconds): Volume Up

3

Down selection key:
Short press (<1 second): Selects Next track
Long press (>2 seconds): Volume Down

4

Power button:
Hold down for 3 seconds to switch the speaker on or off.

5

Under cover: 3.5mm audio jack

6

Under cover: USB charging port

Safety and General Information
Please read the following information before using this product.

1. Do not use the product while operating a motor vehicle.

2. To avoid electronic interference and/or compatible conflicts, turn off the product in any
facilities where posted notices instruct you to do so. For example: Aircraft, Military Base,
Hospital or Health Care Facilities.

3. To avoid impairing your hearing, keep the speaker volume at a moderate level. Do not
listen at high volumes for prolonged periods. Check volume before turning on.

4. For your safety, avoid distractions from music or phone calls while in public places or
potentially dangerous environments.

5. Keep away from fire, and high voltage equipment.

6. Do not install, place or use the speaker near any source of heat such as a cooker, radiator,
oven, toaster, coffee maker or other apparatus (including microwave ovens) that gives off
heat. Do not use in direct sunlight.

7. It is recommended to keep the environment temperature between 15°C & 25°C

8. Follow the battery and charging procedure in this guide to charge the product.

9. Do not use chemicals or detergents to clean the product.

10.The speaker is designed to withstand splashing water to IPX4 under the Ingress Protection
Rating, as defined in international standard IEC 60529, when the charging/AUX port cover
is in place. If the cover is not fully in position the speaker will not be waterproof to the
advertised level.

11.The speaker should not be submerged in water or exposed to jets of water.

12.Do not charge if damp or wet. Ensure fully dry before charging.

13.Should the unit become hot to touch during charging or emit smoke/vapour, switch off at
the mains, disconnect and do not use. Then contact your retailer

IMPORTANT WARNING: Do not connect to a PC or USB charger if speaker is damp or wet.
Danger of electrocution.

Diagram

User Guide

Page 1 of 6

Page 3 of 6

Product Overview

 With Bluetooth wireless technology, this iGadgitz ‘Disnix’ S1 Bluetooth speaker gives you the convenient

wireless way to enjoy streaming stereo music transmitt ed from a Bluetooth A2DP*1-Source device s uch
as MP3 players, Smartphones, PC/Laptop or Tablet in the available range.

 You can use S1 to remotely control the music playing functions of your Bluetooth device if it supports

Bluetooth AVRCP*2.

 Switching between music and phone calls, S1 also allows you to answer or make calls with a Bluet ooth-

enabled phone*3 while you are listening to music.

 After you end the call, the music will continue to be strea med in seconds.*4
 Besides the wireless stereo and mobile hands -free applications, you can pair the S1 to a Blueto oth-

enabled PC*5 to use with instant messaging applica tions such as Skype.

Notes:

*1: The playback or its plug-in Bluetooth adapt er/transmitter needs to support Bluetooth A2DP (Advanced Au dio
Distribution Profile).
*2: The playback or its plug-in Bluetooth adapt er/transmitter needs to support Bluetooth AVRCP (Audio Video Remote
Control Profile).
*3: The mobile phone needs to support Bluetoot h HFP (Hands-free Profile) and support Bluetooth A2 DP (Advanced
Audio Distribution Profile).
*4: Some mobile phones do not release the c onnection switch function to the speaker, which will cause the speaker to
fail to switch the Bluetooth connection between m usic and call.
*5: The computer or its plug-in Bluetooth ada pter needs to support Bluetooth HSP (Headset Profile).

Specification and technical parameters

Rated Power: 5W
Frequency response: 90Hz-20KHz
Sensitivity: 80dB+/-2dB
SNR: >/=76dB
Battery: Built-in Lithium Rechargeable (800 mAh)
Waterproof grade: IPX4 (Splashing water, as per Ingress Protection Rating as defined in international s tandard IEC

60529)
Performance: Bluetooth Specification V4.0 +EDR, up to 10 meters (in open space)
Operating distance: 10m (33 ft)
Music/Talk time: 6 hours*
Charging time: 2 hours
Bluetooth profiles supported:

 HSP Profile (Headset Profile)
 HFP Profile (Hands-free Profile)
 A2DP (Advanced Audio Distribution Profile)
 AVRCP (Audio/Video Remote Control Profile)

Charging Input: DC5.0V
Aux in: 3.5mm audio jack
Dimensions: 65.5 x 78mm

*The maximum operating time depends on the usag e frequency and environmental factors. A long dista nce wireless
connection and use with a mobile phone will increase the power consumption.

How to use iGadgitz ‘Disnix’ S1 Waterproof Bluetooth Speaker

Turn on the speaker

Press and hold the power button for around 3 s econds. The blue LED light will turn on.

Turn off the speaker

When the speaker is on, press and hold the Power button for around 3 seconds.

Paring

Pairing is the process of establishing an encr ypted link between S1 and Bluetooth devices.

Step-1 Make sure the S1 is switched off, then turn on. T he blue indicator will flash repeatedly to detect Bluetooth

enabled devices near you.

Step-2 Follow the operating instruction of your Bluetooth device to start the pairing process. Typically, this is done

by going to a “Connect” or “Setup” menu and t hen selecting the option to search for ‘Disnix S1’ t hat is still in the
pairing mode.

Step-3 The mobile will find ‘Disnix S1’ and ask whether you are willing to connect your device with the speaker.

Press “Yes” or “Confirm” to confirm this action.

If the connection is successful, you will hear a to ne from the speaker and the LED will flash every 3 seconds. If the
pairing is unsuccessful, please turn off the speaker and turn it on again. Then, return to Step-1 and do the pairing
procedure again. The speaker will automatically tur n off after 5 minutes if it cannot pair with a device.

Make a Call

Step-1 Use the mobile phone’s keypad to dial the phone number.
Step-2 Press mobile phone’s “Send” or “OK” key. The mobile ph one initiates the call and transfers the call from the

mobile phone to the speaker.

Answer a Call
Step-1 If there is an incoming call while you are listening to the str eaming music, you will hear your ring tone

through the speaker.

Step-2 Just press Button 1 (Play/Pause/Answer call/End call button) once.

End a Call

Use either of the following methods to end a call .

Method-1 From the speaker, press Button 1 (Play/Pause/Answer call/End call button) once.
Method-2 End a call from the mobile phone’s keypa d.

If you are listening to music when there is an incoming cal l the speaker will switch the connection from the music
player (A2DP) to the mobile phone (HSP or HFP); the streaming music will be paused temporarily. Aft er you end the
call, the music will should be played and streamed t o the speaker again.

Notes: When you press Button 1 to answer or end a call, please just press once. Do not press and hold.

Page 2 of 6

Page 4 of 6

Adjust volume

Volume Up: In call mode or music mode, l ong press (>2 secs) the Up Selection Key (Button 2 on the Diagr am).
Volume Down: In call mode or music mode, l ong press (>2 secs) the Down Selection Key (Button 3 on the Diagr am).

Play/Pause music

In idle state, press Play/Pause/Answer call/End call button (Button 1 in the diagram) once to Play or Paus e music.

Previous/Next Track

Previous Track: In music mode, short press (<1 s ec) the Up Selection Key (Button 2 on the Diagram).
Next Track: In music mode, short press (<1 sec) the Down Selection Key (Button 3 on the Diagram).

Line-in Mode

Insert a 3.5mm audio cable to the 3.5mm audio jack port. Then press Button 1 to Pause the music, the n press Button 1
again for playback to occur. During this method of playback the speaker will NOT be waterproof.

Troubleshooting

If disconnection occurs, please check the following factors:

1) Ensure that the speaker has enough power, it is turned on and has been successfully paired to the mobile.

2) The Bluetooth function of the mobile is enabled.

3) Check whether the range between the speaker a nd mobile is within 10 meters (about 30 feet.) O r if there are walls
or other disturbance or electrical devices between s peaker and mobile.

Battery and Charging Procedure

 iGadgitz ‘Disnix’ S1 uses a rechargeable battery. A normal charging process takes

about 2 hours. The red LED will turn on when charging and will turn off when
charging is finished. Do not charge for longer than 3 hours. This will shorten the
lifetime of the battery.

 Plug the USB cable into a PC/Laptop USB port or suitable 5.0V USB power charger.

Using any incorrect power supply device will cause damage and void the warranty.

 Should the unit become hot to touch during charging or emit smoke/vapour, switch

off at the mains, disconnect and do not use. Then contact your retailer.

 After charging has finished, please remove the cable from the speaker. Do not

charge the speaker for long periods of time.

 When the battery is nearly used up, the blue LED will stop flashing. Please charge

the speaker at this time.

 Please make sure the battery has been fully charged and fully discharged for the

first three uses to ensure optimum battery performance.

 Do not use the speaker in too hot or too cold environments. It is recommended to

keep the environment temperature between 15°C and 25°C.

 Do not connect, place or use the speaker near any source of heat such as a cooker,

radiator, oven, toaster, coffee maker or other apparatus (including microwave
ovens) that gives off heat. Do not use in direct sunlight.

IMPORTANT WARNING: Do not connect to a PC or USB charger if speaker is damp or wet.
Danger of electrocution.

igadgitz™ is a registered trademark of INNOV8 GB Ltd. All rights reserved.

Bluetooth® word mark and logos are registered trade marks owned by Bluetooth SIG,

Inc. and any use of such marks by the manufactu rer is under license. Other trademarks and

www.igadgitz.com

trade names are those of their respective owners.

Page 5 of 6

Page 6 of 6