WATER INLET
DRAIN
PIPE
WATER INLET
DRAIN
PIPE
WATER
SUPPLY
STOP
LOCK
REDUCER
MACHINE
WATER
INLET
1/2
3/4
1. Remove Carton.
2. Remove wooden base. Keep machine on floor
or trolley.
3. Place the machine at the site at which it is to be
installed.
4. Remove transit bolts.
5. Insert plastic caps provided into holes vacated and press till they click into
place.
6. Keep transit bolts carefully. They will be required in case you need to shift the
machine again.
7. For shifting and re-installation at a new site,please get in touch with our service
personnel.
8. Keep packaging material carefully. It comes handy while shifting residence.
9. PLEASE DO NOT OPERATE THE MACHINE TILL TRANSIT BOLTS HAVE BEEN
REMOVED.
INSTALLATION
1. Make sure there is a 16 amp. 3-pin electrical point preferably with a 16 amp.
fuse, within 1 meter of the machine. Make sure it has proper earthing.
2. Fixed plumbing is recommended for
the machine. The water inlet of the
machine has a collar with3/4”parallel
internal threads. The water supply
point with an external 3/4” parallel
thread should be available within1
meter of the machine’s location.
4. Please inform our service centre for installation and demonstration of the
machine once the points mentioned above have been completed.
3. Two options on the water inlet and drain
pipe connection are shown. In case these
possibilities do not exist for the drain pipe,
please arrange an additional length of pipe.
PRE-INSTALLATION
UNPACKING
TECHNICAL DATA
Dimensions(DxWxH) : 56 cm x 60 cm x 85 cm
Weight : 67 kgs
Capacity : 5 Kgs of dry clothes (cotton)*
Programmes : 30 Wash Care Programmes
Selector Buttons : Eco, Water Save Device (WSD), No spin,
spin speed selection
Motor Rating : 690 Watts max.
Spin Speed : 600 to 800
Heater Rating : 1.9 kW
Drum : Stainless Steel
0
Temperature Selection : Cold to 90 C
Drain Pump Rating : 30 Watts
Water Consumption : 45 liters for normal wash.
Power Consumption : 0.15 - 0.25 unit for cold wash
0
(Cotton Wash Programme) : 1.2 - 1.4 unit hot wash at 60 C
Connected Load : 2.35 KW Max.
Programme Duration : 36 to 132 minutes
Power supply : 220 - 240 V, Single Phase, 50 Hz
22
Water Pressure : 1 bar ( 1.03 kg/cm ) - 10 bar ( 10.3 kg/cm )
Specifications are subject to change without notice.
*Capacity depends on size, texture and combination of clothes
Depending on water pressure, Water hardness, Water inlet Temperature, Quantity
and type of textile, Detergents used, Degree of soiling, Ambient condition, selected
additional functions & power supply fluctuations the actual values given on or with
the machine can deviate from the declared standard values, as they are tested
according to the laboratory conditions
29 7