A vent kit is supplied along with accessories which consist of
adapter - A, hose - B, and two connectors - C (Fig -1)
Fig -2
Assemble connectors on both ends of hose by rotating
clockwise direction. (Fig. 2)
Fig -3
Insert one end of hose assembly into the adapter slot and
lock it (Fig. - 3)
Fig -4
Replace the existing exhaust air director on the back of dryer
with the adapter. Mount vent kit in sideways or upward position
on the back of dryer using the same fasteners (Fig.-4). Direct
other end of hose outside the window.
2310
Page 9
1122
Page 10
qThis dryer has been designed for domestic use of drying clothes and garments. It
should notbe used forany other purpose.
q
This appliance is not intended for use by persons (Including children’s) with reduced
physical, sensory or mental capabilities or Lack of Experience and Knowledge, unless
they have given supervision or instruction concerning use of the appliance by person
responsible for theirsafety.
q
Items that have ben soiled with substances such as cooking oil, acetone, alcohol,
petrol, kerosene, spot removers, turpentine, waxes and wax removers should be
washed in hot water with an extra amount of detergent before being dried in the
tumble dryer.
q
Items such as foam rubber (latex foam), shower caps, waterproof textiles, rubber
backed articles and cloths or pillows fitted with foam rubber pads should not be dried
in the tumbledryer.
q
Fabrics softness, or similar products, should be used as specified by the fabric softener
instructions.
Warning :
are quickly removedand spread outso that theheat is dissipated.
The appliance must not be installed behind a lockable door, a sliding door or a door
q
with a hingeon the oppositeside to thatof the tumbledryer.
“AIRING” : The final part of the tumble dryer cycle occurs without heat ( cool down ) to
q
ensure that the items are left at a temperature that ensures that the items will not be
damaged.
Take these precautions for safe efficient operation
of your dryer.
1.“Read theInstructions “
2.Check that electrical line can take the rquired
load.
3.Connect to a 220V, 50 Hz single phase AC
supply.
4.Appliance must be earthed properly before
operation. This can be done by using a 3 pin
plug and properly earthed socket of 15 amp.
with a 12amp. fuse.
5.No double adaptors or extension cords to be
used.
6.Make sure the lint filter and filter guard are
properly fitted. (Refer page 19)
Never stop a tumble dryer before the end of the drying cycle unless all items