IFB Senorita Dx, Digital 5.5KG User Manual
The user manual
USE ONLY GENUINE IFB SPARES & ACCESSORIES
* Company shall not be responsible for defects arising due to usage of spurious parts and accessories
Advancing the science of washing
SENORITA DX
3
5
CONTENTS
KNOW YOUR MACHINE.......................................................................................... 6
INSTALLATION.......................................................................................................... 7
?
?Unpacking
?Setting up
?Water inlet
?Water outlet
?Electrical connection
USING YOUR MACHINE.......................................................................................... 9
?Control panel
?Enviromental protection / conservation issues
?Before using your machine for the first time
?Program selector
?Optional buttons
?Child lock safety provision
?Automatic detergent dispenser tray
?Kinds of wash programs & Options available
?Exclusive programs
?Exclusive in -built features
?Programme chart
OPERATION............................................................................................................... 16
?Sorting of garments
?Loading the machine
?Detergent to be used & quantity
?Fabric conditioner
?Treatment of stains
?Fabric care symbols
?Cloth weights
?Check points
?Programming the machine
?When the program has ended
MAINTENANCE........................................................................................................ 20
?Coin Trap
?Drum
?Sieves
?Frost protection
?Draining during emergencies
TROUBLE SHOOTING............................................................................................. 22
?Why does it happen?
?Error interpretation
SAFETY PRECAUTIONS.......................................................................................... 25
TECHNICAL DATA.................................................................................................... 26
Pre Installation
6
Adjustable Feet
for Levelling
E
N
I
D X
S
O T
A
R
E
L
U
i
k
Q
u
c
c
E
o
D
ra
n
i
e
+
n
p
R
i n
s i
S
e
D
i
l
ae
t s
c
e
M
d
x
i
y
a C
a
E
s
re
t
o
Cot
n
°
C
d
o
C l
0
4
3
0
o
C
l
d
f
f
O
0
6
0
3
0
4
6
0
9
5
0
4
0
6
c
A
e
v
t
i
n
d
E
o
k
C
d
c
l
h
l
i
p
n
S
i
t
a
St
s
r
u
e
a
/
P
D
o
or
u
t
Sa
t
s
s
a
W
h
P
r
e
e
i
R
s
n
l
o
H d
0
3
o
W
l
o
Bottom Door
Special powder
coated
galvanized steel
Cabinet
Porthole Door
Control Panel
Detergent
Dispenser Tray
Top Lid
Interlocking Door
Lock Handle
Program Selection
Knob
7
WATER
SUPPLY
STOP
COCK
REDUCER
MACHINE
WATER
INLET
1/2
3/4
1. Remove Carton.
2. Remove top packing cover.
3. Remove side packing and plastic jacket.
4. Remove packing from the bottom of the motor
5. Place the machine at the site at which it is to be
Installed, and put the rat mesh.
6. Remove transit bolts.
7. Insert plastic caps provided into holes vacated and press till they click into
place.
8. Keep transit bolts carefully. They will be required in case you need to shift
the machine again.
9. For shifting and re-installation at a new site, please get in touch with our
service personnel.
10. Keep packaging material carefully. It comes handy while shifting
residence.
11. PLEASE DO NOT OPERATE THE MACHINE TILL TRANSIT BOLTS
HAVE BEEN REMOVED.
SETTING UP
The machine should be levelled properly on the floor. However, it can be
installed on any suitable platform or trolley, as desired.
Install machine in a room with adequate ventilation. Avoid a room with no
windows. The back of the machine should be at least 4 inches (100 mm) away
from the wall.
1. Do not place the machine on slanting, uneven, unstable surface.
2. Level the machine by using the adjustable screws provided at the bottom
for levelling.
3. Loosen securing nut. Adjust the screw to change level. Tighten securing
nut to ensure that screw is locked into place.
4. Make sure that the machine rests on all four feet on a level surface, at all
times, to avoid vibrations during operation
5. Machine should be leveled again in case it is moved to a new site.
6. Machine is provided with ventilating openings on the base. Hence it is
always recommended to put the machine on the floor after removing the
carpet.
7. In countries where there are areas which may be subjected to infestation
by cockroaches or other insects etc, pay attention to keep the appliance &
surrounding in clean condition at at all times any damage which be caused
by cockroaches etc will not be covered by the appliance guratantee.
PRE - INSTALLATION
C
point with a 16 amp. MCB or Automatic short circuit protection
device within 1 meter of the machine. Make sure it has proper
earthing.
C
machine has a collar with 3/4” parallel internal threads. The water supply
point with an external thread3/4” parallel thread should be available
within 1 meter of the machine location. Please refer the figures (page. no.
8) under the topics WATER INLET and WATER OUTLET.
CPlease contact our service centre for installation and demonstration of the
machine after the mentioned points have been completed.
It is mandatory to have a 16 amp. 3-pin 230V AC, 50Hz electrical
Fixed plumbing is recommended for the machine. The water inlet of the
WATER INLET
DRAIN
PIPE
X
WATER INLET
DRAIN
PIPE
8
l
lConnect to a 230V, 50Hz single phase AC supply. The appliance must
be positioned so that the plug is accessible.
lMachine must be earthed properly before operation. This can be done
by using a 3 - pin plug and a properly earthed operated socket of 16
Ampere rating.
lIf the supply cord is damaged, it must be replaced by the
manufacturer or its service agent or a similarly qualified person in
order to avoid a hazard. It should not be stretched when connected to
the main circuit.
lUse of extension cord not recommended since it may not be properly
earthed.
lUse ISI marked sockets of reputed make for preventing loose contact
of power supply cable.
lEnsure that there is a firm connection between the 3 PIN PLUG and
SOCKET, else it may result in sparking and subsequent failure of 3
pin plug.
lEnsure that L,N,E is as per the Fig. Shown
lWashing machine should always be connected to socket with 16 Amps
MCB or other automatic short circuit protection devices.
CAUTION :- The producer/Manufacturer declines any responsibility for
damage caused by failure to observe this rule. You are therefore advised to
check that your household supply has an efficient earth.
Check that the electrical line can take the required load.
16 AMPS
X
N L
E
SENORITA DX
Quick
Eco
Drain
Rinse + Spin
Delicates
Mixed
Easy Care
Cotton
°C
Cold
40
30
Cold
Off
60
30
40
60
95
40
60
Active
End
Child lock
Spin
Start/Pause
Door
Status
Wash
Pre
Rinse
Hold
DETERGENT DISPENSER TRAY
ON/OFF SWITCH WITH
PROGRAMME
SELECTOR KNOB
CHILD LOCK
30
Wool
9
ENVIRONMENTAL PROTECTION/ CONSERVATION ISSUES
Your washi ng m achine us e s w a ter, e nergy an d de terg ent effic iently, th ereby pro tectin g th e
environment and reducing your household costs.
Using your washing machine in an efficient and environmentally friendly manner:
Do not exceed recommended load.
Cottons 5.5kg
Easy-care 3.0kg
Delicates and Woollens 2.0kg
0 0
Where possible, use the 60 C Eco program instead of the 95 C Cottons program. The
0
extended washing time achieves a cleaning result comparable to the 95 C program, but uses considerably less
energy.
Avoid using the Prewash program when washing lightly to normally soiled laundry.
Add detergent according to the degree of soiling, amount of laundry and water hardness, and observe the
dertergent manufacturer’s instructions.
BEFORE USING YOUR WASHING MACHINE FOR THE FIRST TIME
Caution
The washing machine must have been installed and connected properly (refer page 7)
Your appliance was tested before leaving the factory. To remove any water left over from testing
procedures, the first washing cycle should be carried out without laundry in the machine.
Do not load any laundry.
1. Turn on water tap.
2. Pull out the detergent dispenser up to the end stop.
3. Pour approx. 1 litre of water into chamber II of the detergent dispenser.
4. Pour ½ measuring beaker of detergent into dispenser II. Do not use any special detergents for delicates or
woollens (excessive foam).
5. Close the detergent dispenser.
0
6. Set the programme selector to 95 C cottons.
7. Press the Start button. Door LED will glow Red once the door is locked.
8. When the End LED glows, Turn the programme selector to Off.
10
PROGRAM SELECTOR
The program selector is used to choose the desired program. The knob can be rotated in both
clockwise and anti-clockwise directions. The knob should be rotated slowly one step at a time.
A choice of 15 basic programs is available according to the fabric being washed and extent of
soilage. For more details please refer the topic “Kinds of wash programs”.
Program selection should be done before pressing the “Start/Pause” button.
Attention: To choose a different program during program run of the machine, switch
off the machine, wait for few seconds and then select a new program.
OPTIONAL BUTTONS
After the machine is powered on, available options to a program will be shown by flashing of
the corresponding led of the optional button. non flashing led’s refer to non applicable options
to that program. default selected options will be indicated by the glowing of the
led.
With the selection of optional buttons, the total time required for washing is automatically
readjusted
Start / Pause LED (Dual colour ) will flash Green before program start, and will glow Red when
program started
PRE WASH OPTION
Useful for the Cotton / Synthetic clothes which are highly soiled, stained, long wearing like
outdoor sports wear, kitchen wear, jeans etc.
When chosen, the detergent is to be filled in compartment marked I of the detergent dispenser
tray.
At the end of the ewash, the dirty water is pumped out automatically
Prewash can be selected by pressing th button Led glowing is an indication that the option
is selected.
SPIN SPEED
Program Max. Spin Speed (RPM)
Cotton, Eco, Quickwash, Easycare, Rinse+Spin 800
Spin 800
Delicate, Wool 600
l
l
l
lThe program selected can be futher supplemented by chosing the various option available as
listed below
l
/selected option
l
l
and will switch off at the end of the program and will flash red in pause mode.
lIf pre wash option is selected, the clothes are given a preliminary wash before the main wash.
l
l
l Pr .
l is
lIf the clothes are left unattended after final spin for a long time it will increase the creases on
the clothes.
l In order to minimize the creases,
lA
l
RINSE HOLD
Rinse hold option has to be selected which will prevent
clothes from creasing by holding them in water before final spin.
t rinse hold step LED will flash
During the Rinse hold stage, the programm will halt start pause red LED will flash & active
LED will glow.
11
Quick
Eco
Drain
Rinse + Spin
Delicates
Mixed
Easy Care
Cotton
°C
Cold
40
30
Cold
Off
60
30
40
60
95
40
60
Spin
30
Wool
Wash
Pre
Rinse
Hold
Loading...