IER 602 1356 10 User Manual

IER 602

Reader

User Guide

N0F102A

N0F102A - Rev. 3

October 13, 2015

IER 602 Reader

This document is the property of IER and may not be reproduced

or communicated without prior written authorization

IER SIEGE - HEADQUARTERS
IER S.A.S.

3, rue Salomon de Rothschild
92156 SURESNES CEDEX
France
Tel. [phone]
Fax [phone]

IER DANS LE MONDE - IER WORLDWIDE

CHINA
IER Shanghai

Kuen Yang Plaza #1101
798 Zhao Jia Bang Road
SHANGHAI 200030
P.R.C.
Phone: [phone]
Fax: [phone]

UNITED ARAB EMIRATES
IER Dubai

PO Box 37585
DUBAI
Phone: [phone]
Fax: [phone]

GERMANY
IER GmbH

Wilhelm-Heinichen-Ring 4
29227 Celle
Phone: [phone]
Fax: [phone]

UNITED KINGDOM
IER Ltd

Unit 4 & 5, Lakeside Industrial Estate
Colnbrook-by-Pass
Colnbrook, Berkshire, SL3 0EE
Phone: [phone]
Fax: [phone]

SINGAPORE
IER PTE Ltd

120 Lower Delta Road
#14-13/16 Cendex Centre
SINGAPORE 169208
Phone: [phone]
Fax: [phone]

UNITED STATES
IER Inc. Dallas

2015 Midway Road
Suite 118
CARROLLTON, TX 75006
Phone: [phone]
Fax: [phone]
Toll free: 1-800 624 8538

IER Inc. Belton
815 Kirkley Blvd
BELTON, TX 76513
Phone: [phone]
Fax: [phone]

SPAIN
IER Impresoras Especializadas, S.L.

C/ Torre de Don Miguel, 23
E-28031 – MADRID
Phone: [phone]
Fax: [phone]

User Guide

Page 2
N0F102A - Rev. 3
October 13, 2015

This document is the property of IER and may not be reproduced or

communicated without prior written authorization

WARNING

THIS PRODUCT COMES WITH A LITHIUM BATTERY. BATTERY
REPLACEMENT MUST IMPERATIVELY BE PERFORMED BY
QUALIFIED MAINTENANCE PERSONNEL. MOREOVER, ONLY IER
APPROVED MODELS MAY BE USED.
DANGER OF EXPLOSION IF BATTERY IS INCORRECTLY REPLACED.
REPLACE ONLY WITH THE SAME OR EQUIVALENT TYPE
RECOMMENDED BY THE MANUFACTURER.
DISPOSE OF USED BATTERIES ACCORDING TO THE
MANUFACTURER’S INSTRUCTIONS.

NOTICE

The United States Federal Communications Commission (in 47 CFR 15.105) has specified
that the following notice be brought to the attention of users of this product.

NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation.

If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:

- Reorient or relocate the receiving antenna

- Increase the separation between the equipment and receiver

- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected

- Consult the dealer or an experienced radio/TV technician for help.

In accordance with FCC requirements, changes or modifications not expressly approved by
IER could void the user's authority to operate this product.

Use of a shielded cable is required to comply within Class B limits of Part 15 of FCC Rules.

This equipment complies with FCC’s radiation exposure limits set forth for an uncontrolled

environment under the following conditions:

- This equipment should be installed and operated such that a minimum separation

distance of 20cm is maintained between the radiator (antenna) and user’s/nearby
person’s body at all times.

- This transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.

Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils
radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes :

1. l’appareil ne doit pas produire de brouillage ;

2. l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le fonctionnement.

IER 602 Reader

User Guide

Page 3

N0F102A - Rev. 3

October 13, 2015

IER 602 Reader

This document is the property of IER and may not be reproduced

or communicated without prior written authorization

WARNING

THIS PRODUCT MUST EXCLUSIVELY BE CONNECTED TO AN
ELECTRICAL CIRCUIT PROVIDED WITH A GROUND FAULT
CIRCUIT INTERRUPTER (GFCI) AND COMPLYING WITH IEC 364
AND NFC15-100 REGULATIONS.

User Guide

NORWAY: This product is also designed for IT power distribution system with

phase-to-phase voltage 230V.

NORWAY – SWEDEN – FINLAND: Apparaten skall anslutas till jordat uttag när den

ansluts till ett nätverk.

The warranty shall be null and void in case of use of any spare part, special tool or

consumable not expressly approved in writing by IER and in the event of attempted

repair or servicing of the machines by persons lacking the requisite technical

qualifications.

This document contains proprietary information of IER. It may not be reproduced or

communicated without prior written authorization of IER. It is intended solely for the

use of the product described herein, to the exclusion of any other usage. It is

provided as is, for information purposes only, without any warranty of any kind,

including any warranty of fitness or a particular purpose, and may be modified by

IER at any time.

In compliance with the European Directive 2002/96/CE relative to the management of
Waste Electrical and Electronic Equipment (WEEE) implemented as of August 13, 2005,
this product may not be disposed of with regular household waste. All products concerned
by this directive are marked with the above symbol.
The end owner of this product is responsible for either:
 Transferring the product to an authorized treatment facility where the product

components, recognized to present a hazard to the environment and/or public health,
will be recycled and recovered properly,

 Or consulting with the manufacturer for appropriate product waste management

according to the terms of the manufacturer.

The information and specifications contained in this document are subject to change
without prior notice.
Translated from French - IER Documentation Department

Page 4
N0F102A - Rev. 3
October 13, 2015

IER 602 Reader

This document is the property of IER and may not be reproduced or

communicated without prior written authorization

User Guide

CONTENTS

1 General ............................................................................................................. 6

1.1. General Description .................................................................................. 6

1.2. User Interface ............................................................................................ 7

1.3. Dimensions and Weight ............................................................................ 8

1.4. Optional Thermal Printer ........................................................................... 9

2 Reader Connections ....................................................................................... 10

2.1. Connecting the Reader ........................................................................... 11

3 Operation ........................................................................................................ 12

3.1. Operating Conditions and Power Requirements .................................... 12

3.1.1. Environment ..................................................................................... 12

3.1.2. Power Requirements ....................................................................... 12

3.2. Powering up the Reader ......................................................................... 13

3.3. Barcode Scanning Recommendations.................................................... 14

3.4. Reading a Barcoded or RF-Enabled Document ..................................... 15

3.5. Powering down the Reader ..................................................................... 16

4 Maintenance ................................................................................................... 17

4.1. Periodic Maintenance.............................................................................. 17

N0F102A - Rev. 3

Page 5

October 13, 2015

IER 602 Reader

This document is the property of IER and may not be reproduced

or communicated without prior written authorization

User Guide

1 GENERAL

1.1. General Description

The IER 602 is primarily designed for airport applications to control access to
boarding gates and check-in areas or can be used for access control to security
check points. The reader can also be integrated into other public space
applications, dedicated, for example, to train stations, museums, stadiums, etc.

Not only is the IER 602 capable of scanning 1D and 2D barcodes printed on
boarding passes, it also reads digital barcodes displayed on cell phone screens.

Moreover, the IER 602 Reader is able to read Radio Frequency (RF) -enabled
smart documents.

An optional thermal printer can be connected to the USB port or one of the serial
ports of the IER 602 Reader to print out a receipt confirming that the scanned
barcode or RF-enabled document is valid.

Page 6
N0F102A - Rev. 3
October 13, 2015