IEI Technology NANO-LX User Manual

Page 1
NANO-LX EPIC SBC
NANO-LX EPIC SBC User Manual
MODEL:
NANO-LX
EPIC AMD® Geode LX 800 SBC with VGA/LVDS/TFT
Single GbE, SATA RAID, USB 2.0 and Audio
User Manual
Rev. 1.23 – August 22, 2017
Page I
Page 2
NANO-LX EPIC SBC
Revision
Date Version Changes
August 22, 2017 1.22 Updated the following sections:
Section 2.3: Data Flow Section 4.2.23: Serial Communications Connector Section 5.6.3: UART Port A RS-422/485 Select Jumper
August 17, 2017 1.22 Clarified Section 4.2.23: Serial Communications
Connector
July 6, 2010 1.21 Modified CN13 connector diagram
April 9, 2009 1.20 Changed SATA controller to VIA VT6421A
Added SATA power connector (CN38) Updated BIOS section.
May 2007 1.10 - Added notice for LCD panel voltage select jumper (JP7).
- Added dimension drawings.
- Changed the document format.
April 2007 1.01 - Updated AMD VGA driver installation (Section 6.2)
August 2006 1.00 Initial release
Page II
Page 3
NANO-LX EPIC SBC
COPYRIGHT NOTICE
The information in this document is subject to change without prior notice in order to improve reliability, design and function and does not represent a commitment on the part of the manufacturer.
In no event will the manufacturer be liable for direct, indirect, special, incidental, or consequential damages arising out of the use or inability to use the product or documentation, even if advised of the possibility of such damages.
This document contains proprietary information protected by copyright. All rights are
Copyright
reserved. No part of this manual may be reproduced by any mechanical, electronic, or other means in any form without prior written permission of the manufacturer.
TRADEMARKS
All registered trademarks and product names mentioned herein are used for identification purposes only and may be trademarks and/or registered trademarks of their respective owners.
Page III
Page 4
NANO-LX EPIC SBC
Packing List
NOTE:
If any of the components listed in the checklist below are missing, please do not proceed with the installation. Contact the IEI reseller or vendor you purchased the NANO-LX motherboard from or contact an IEI sales representative directly. To contact an IEI sales representative, please send an email to sales@ieiworld.com
The items listed below should all be included in the NANO-LX motherboard package.
NANO-LX single board computer  IDE flat cable 44p/44p  RS-232 cables  Audio cable  Power cable  Keyboard/Mouse Y cable  SATA cables  SATA power cables  Mini jumper Pack  Quick Installation Guide  Utility CD
Images of the above items are shown in Chapter 3.
.
Page IV
Loading...