SATA 6Gb/s, RS-232/422/485, ccTalk, Audio, TPM and RoHS
User Manual
Rev. 1.00 - June 29, 2017
Page I
Date Version Changes
June 29, 2017 1.00 Initial release
gKINO-DMF SBC
Revision
Page II
gKINO-DMF SBC
COPYRIGHT NOTICE
The information in this document is subject to change without prior notice in order to
improve reliability, design and function and does not represent a commitment on the part
of the manufacturer.
In no event will the manufacturer be liable for direct, indirect, special, incidental, or
consequential damages arising out of the use or inability to use the product or
documentation, even if advised of the possibility of such damages.
This document contains proprietary information protected by copyright. All rights are
Copyright
reserved. No part of this manual may be reproduced by any mechanical, electronic, or
other means in any form without prior written permission of the manufacturer.
TRADEMARKS
All registered trademarks and product names mentioned herein are used for identification
purposes only and may be trademarks and/or registered trademarks of their respective
owners.
Page III
gKINO-DMF SBC
Manual Conventions
WARNING
Warnings appear where overlooked details may cause damage to the
equipment or result in personal injury. Warnings should be taken
seriously.
CAUTION
Cautionary messages should be heeded to help reduce the chance of
losing data or damaging the product.
NOTE
These messages inform the reader of essential but non-critical
information. These messages should be read carefully as any directions
or instructions contained therein can help avoid making mistakes.
HOT SURFACE
This symbol indicates a hot surface that should not be touched without
taking care.
BIOS Menu 1: Main.......................................................................................................................66
BIOS Menu 2: Advanced..............................................................................................................67
BIOS Menu 3: Trusted Computing..............................................................................................68
BIOS Menu 4: ACPI Settings .......................................................................................................69
BIOS Menu 5: IDEConfiguration.................................................................................................70
BIOS Menu 6: F81866 Super IO Configuration ..........................................................................71
BIOS Menu 7: Serial Port n Configuration .................................................................................71
BIOS Menu 8: iWDD H/W Monitor ...............................................................................................79
BIOS Menu 9: Smart Fan Mode Configuration ..........................................................................80
BIOS Menu 10: RTC Wake Settings............................................................................................82
BIOS Menu 11: Power Saving Configuration.............................................................................83
BIOS Menu 12: CPU Configuration.............................................................................................85
BIOS Menu 13: Node 0 Information ............................................................................................86
BIOS Menu 14: NVMe Configuration...........................................................................................86
BIOS Menu 15: USB Configuration.............................................................................................87
BIOS Menu 16: Chipset................................................................................................................88
BIOS Menu 17: South Bridge.......................................................................................................89
BIOS Menu 18: SB SATAConfiguration.....................................................................................90
BIOS Menu 19: GFX Configuration.............................................................................................91
BIOS Menu 20: North Bridge.......................................................................................................92
BIOS Menu 21: Security...............................................................................................................93
BIOS Menu 22: Boot.....................................................................................................................94
BIOS Menu 23: Save & Exit..........................................................................................................96
Page XIII
gKINO-DMF SBC
Chapter
1
1 Introduction
Page 1
1.1 Introduction
Figure 1-1: gKINO-DMF
gKINO-DMF SBC
The gKINO-DMF series is a Mini-ITX form factor single bard computer. It has an on-board
AMD RX-421BD or RX-216GD processor, and supports two 260-pin 2400 MHz
dual-channel DDR4 ECC unbuffered SDRAM SO-DIMM slots with up to 64.0 GB of
memory.
The gKINO-DMF series includes two external HDMI 1.4 connectors and one external
Dual-mode DisplayPort (DisplayPort++) connector for triple independent display which
support up to 4K resolution.
Expansion and I/O include one PCIe x8 slot, one PCIe Mini slot, one M.2 B-key slot for
expansion, four USB 3.0 connectors on the rear panel, four USB 2.0 connectors by pin
header and two SATA 6Gb/s connectors. Serial device connectivity is provided by two
internal RS-232 connectors, two internal RS-232/422/485 connectors and two ccTalk
connectors. Two RJ-45 GbE connectors provide the system with smooth connections to
an external LAN.
Page 2
gKINO-DMF SBC
1.2 Model Variations
The model variations of the gKINO-DMF series are listed below.
Model No. SoC
gKINO-DMF-421-R10
gKINO-DMF-216-R10
Table 1-1: gKINO-DMF Model Variations
1.3 Features
Some of the gKINO-DMF motherboard features are listed below:
Mini-ITX motherboard supports AMD RX-421BD or RX-216GD on-board SoC
Triple independent display via HDMI 1.4 and DP++
Two 2400 MHz DDR4 SO-DIMM slots support up to 64 GB of memory
Two SATA 6Gb/s connectors with 5 V power output
Full-size/half-size PCIe Mini card slot for expansion
M.2 B-key modules supported
Support microSD card for data storage
One PCIe x8 slot for expansions
Four USB 3.0 external connectors
Two RS-232 connectors and two RS-232/422/485 connectors
IEI One Key Recovery solution allows you to create rapid OS backup and
recovery
Page 3
1.4 Connectors
The connectors on the gKINO-DMF are shown in the figures below.
gKINO-DMF SBC
Figure 1-2: Connectors (Front Side)
Page 4
gKINO-DMF SBC
Figure 1-3: Connectors (Solder Side)
Page 5
1.5 Dimensions
The dimensions of the board are listed below:
gKINO-DMF SBC
Page 6
Figure 1-4: Dimensions (mm)
gKINO-DMF SBC
1.6 Data Flow
Figure 1-5 shows the data flow between the system chipset, the CPU and other
components installed on the motherboard.
Figure 1-5: Data Flow Diagram
Page 7
1.7 Technical Specifications
gKINO-DMF technical specifications are listed below.
AMI UEFI BIOS
Two 260-pin 2400 MHz dual-channel DDR4 ECC unbuffered
SDRAM SO-DIMM slots (system max. 64 GB)
AMD Radeon HD 10000 graphics, 3rd Gen. graphics core,
supporting DX 12, HSA 2.0
UVD v6 decode for H.265 MPEG2/4, VC-1, MVC
VCE v3.1 encode for H.254 VCE
Triple independent display
2 x HDMI 1.4 (up to 4096x2160 @ 24Hz)
1 x DisplayPort++ (up to 3840x2160 @ 60Hz)
Ethernet
Digital I/O
Super IO
Audio
Watchdog Timer
I/O Interface
Audio Connector
Ethernet
Page 8
Dual Realtek RTL8119I PCIe GbE controller
8-bit digital I/O by 10-pin (2x5) header
Fintek F81866
Realtek ALC662 HD audio codec
Software programmable support 1~255 sec. system reset
3 x Audio jack (line-in, line-out and mi c-in)
1 x Front audio connector by 10-pin (2x5) header
2 x RJ-45 GbE port
gKINO-DMF SBC
Specification gKINO-DMF
Serial Ports
USB Ports
Front Panel
LAN LED
Fan
SMBus
I2C
TPM
2 x RS-232/422/485 by 10-pin (2x5) header
2 x RS-232 by 10-pin (2x5) header
2 x RS-232 (supports ccTalk, TTL) by 4-pin (1x4) wafer
4 x USB 3.0 on rear I/O
1 x USB 2.0 on rear I/O
4 x USB 2.0 by 8-pin (2x4) header
1 x Front panel connector by 10-pin (1x10) header for power
LED, HDD LED, power button and reset button
2 x LAN link LED connector by 2-pin header
1 x CPU smart fan connector by 4-pin (1x4) wafer
1 x System smart fan connector by 4-pin (1x4) wafer
1 x SMBus connector by 4-pin (1x4) wafer
1 x I2C connector by 4-pin (1x4) wafer
1 x TPM connector by 20-pin (2x10) header
Chassis Intrusion
Detection
Storage
Expansion
Environmental and Power Specifications
Power Supply
Power Connector
Power Consumption
Operating Temperature
1 x Chassis intrusion connector by 2-pin (1x2) header
2 x SATA 6Gb/s with 5 V SATA power connectors
1 x M.2 slot (B key, SATA 2 port + USB 2.0 signal)
1 x microSD socket
1 x Full-size/Half-size PCIe Mini card slot
1 x PCIe x8 slot
12 V DC input (AT/ATX support)
1 x External DC power jack (4-pin DIN)
1 x Internal power connector by 4-pin (2x2) connector
+12 V @ 5.54 A (AMD RX-421BD 2.1GHz CPU with
2400 MHz 16GB DDR4 memory)
0°C ~ 60°C
Page 9
Specification gKINO-DMF
gKINO-DMF SBC
Storage Temperature
Humidity
Physical Specifications
Dimensions
Weight GW/NW
Table 1-2: Technical Specifications
-10°C ~ 70°C
5% ~ 95%, non-condensing
170 mm x 170 mm
1100 g / 700 g
Page 10
gKINO-DMF SBC
Chapter
2
2 Unpacking
Page 11
2.1 Anti-static Precautions
WARNING!
Static electricity can destroy certain electronics. Make sure to follow the
ESD precautions to prevent damage to the product, and injury to the
user.
Make sure to adhere to the following guidelines:
Wear an anti-static wristband: Wearing an anti-static wristband can prevent
electrostatic discharge.
Self-grounding: Touch a grounded conductor every few minutes to discharge
any excess static buildup.
gKINO-DMF SBC
Use an anti-static pad: When configuring any circuit board, place it on an
anti-static mat.
Only handle the edges of the PCB: Don't touch the surface of the
motherboard. Hold the motherboard by the edges when handling.
2.2 Unpacking Precautions
When the gKINO-DMF is unpacked, please do the following:
Follow the antistatic guidelines above.
Make sure the packing box is facing upwards whe n opening.
Make sure all the packing list items are present.
Page 12
gKINO-DMF SBC
2.3 Packing List
NOTE:
If any of the components listed in the checklist below are missing, do not
proceed with the installation. Contact the IEI reseller or vendor the
gKINO-DMF was purchased from or contact an IEI sales representative
directly by sending an email to sales@ieiworld.com
The gKINO-DMF is shipped with the following components:
Quantity Item and Part Number Image
1 gKINO-DMF single board computer
1 SATA cable
1 I/O shielding
.
1 Utility CD
1 One Key Recovery CD
Page 13
Loading...
+ hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.