IDX ET-PV2BM User Manual

ET-PV2BM

V-Mount Adaptor for Blackmagic Cinema Camera

Instruction Manual

Thank you for choosing the ET-PV2BM. Designed specifically for use with the Blackmagic Cinema Camera, the ET-PV2BM attaches directly to the IDX A-CP(A) universal mounting plate, or other 3 for 3 integral IDX V-Mount plate allowing direct mounting of any IDX ENDURA battery. To install, simply connect the DC power output cable to the DC-IN connector of the camera. The ET-PV2BM has a D-Tap DC-OUT connector that supplies power directly from the battery allowing the use of professional on-board camera lights or other accessories. Please note, this is an unregulated output.

Specifications

Dimensions: 82.5(w) x 142(h) x 12(d) mm Weight: 210g approx. Cable output voltage: 12~17V D-Tap output voltage: 12~17V Maximum output for D-Tap: 50W Cable length: 1m approx. Included accessories: M3 (8mm) screw x 4

General Notes & Safety

rd

party manufactured mounting plates. Please check which fixing positions are required

rd

party plates and use the appropriate location holes. The ET-PV2BM incorporates an

V-Mount Adaptor for Blackmagic Cinema Camera

Instruction Manual

Thank you for choosing the ET-PV2BM. Designed specifically for use with the Blackmagic Cinema Camera, the ET-PV2BM attaches directly to the IDX A-CP(A) universal mounting plate, or other 3 for 3 integral IDX V-Mount plate allowing direct mounting of any IDX ENDURA battery. To install, simply connect the DC power output cable to the DC-IN connector of the camera. The ET-PV2BM has a D-Tap DC-OUT connector that supplies power directly from the battery allowing the use of professional on-board camera lights or other accessories. Please note, this is an unregulated output.

Specifications

Dimensions: 82.5(w) x 142(h) x 12(d) mm Weight: 210g approx. Cable output voltage: 12~17V D-Tap output voltage: 12~17V Maximum output for D-Tap: 50W Cable length: 1m approx. Included accessories: M3 (8mm) screw x 4

General Notes & Safety

rd

party manufactured mounting plates. Please check which fixing positions are required

rd

party plates and use the appropriate location holes. The ET-PV2BM incorporates an

Do not attempt to open or modify this unit. All work should be carried out by IDX authorised

service personnel only.

Do not attach the ET-PV2BM to any non-compatible video camera or equipment as it may cause

defect, damage or other incidents. Please read this Instruction Manual carefully before use.

When connecting a battery or adaptor to the ET-PV2PM, be sure to connect firmly. If it is not

attached properly, it may result in loss or damage to the unit or even injury to the user.

Do not expose to, use or place the unit in direct sunlight, extreme dust or other hazardous

environments.

A short between the plus (+) and minus (-) charge pins may cause fire, electrical shock or other

incidents.

Stop using immediately in case of abnormal smell, leak, colour change or deformity during use. If you need any inspection or repairs, please contact your local IDX dealer or IDX office.

E & OE E & OE

IDX Technology Europe, Ltd.

Unit 9 Langley Park, Waterside Drive, Langley, Berkshire SL3 6EZ, ENGLAND Tel: +44-1753-547692

www.idx-europe.co.uk

Fax: +44-1753-546660 Email: idx.europe@idx.tv

20121812