IDW RCM-2, RCM-2-N13EB Instruction Manual

G-Series Cooler

RCM-2

RECHARGE COLD MERCHANDISER

**Patent Pending**

2

Manual is for the

following models:

RCM-2-N13EB

Instruction Manual

Innovative DisplayWorks

RCM-2

FOR YOUR FUTURE REFERENCE

• This easy-to-use manual will guide you in getting the best use of your cooler.

• Remember to record the model number and the serial number. This information can be found on the
inside of your cooler.

• Keep your receipt with this manual for future warranty service.

Model #:

Serial #:

Date of Purchase:

TABLE OF CONTENTS

Parts and Identication ......................................... 2

Safety Instructions ................................................. 3

Preparation ........................................................... 4

Location ................................................................ 5

Installation and Operation ..................................... 5

Rechargeable Battery Instructions .......................... 5

Beverage Storage .................................................. 6

Maintenance ......................................................... 6

Changing Graphics ................................................ 7

Troubleshooting .................................................... 8

Cleaning ............................................................... 8

Circuit Diagram ................................................... 10

1

Manual is for the
following models:
RCM-2-N13EB

Instruction Manual

RCM

2

Instruction Manual

Innovative DisplayWorks

RCM-2

2 3

1. Cabinet

2. Hinge Cover (6)

3. Damping Box Left Upper

4. Damping Box Left Bottom

5. Damping Left

6. Coolant Box (30)

7. Damping Box Right Upper

8. Damping Right

9. Damping Box Right Bottom

10. Door Gasket

11. Lid

12. Handle

13. Rim

14. Basket

15. Cooling Inner

16. BafeofInnerFan

17. InnerFanSupporter

PARTS AND IDENTIFICATION

充电器

蓄电池

18. EvaporatorFan

19. Castor (2)

20. Caster Locking (2)

21. Retaining Clip of Line

22. Compressor Accessories

23. Compressor

24. FrontBottomBafe

25. Compressor Base

26. Assembly

27. DryerFilter

28. Drip Pan Assembly

29. Ground Wire - 1

30. Ground Wire - 2

31. Compressor Connection Wire

32. Thermostat Connection Wire

33. Power Cord

34. BottomFrontGraphicStrip

35. CornerGraphicStrips(4)

36. TopMagnetStripsFront/

Back (2)

37. TopMagnetStripsSides(2)

38. BottomSideGraphicStrips

(2)

39. BottomBackGraphicStrip

40. Compressor Room Cover

41. CoverSupporter(2)

42. Power Cord Holder (2)

43. Battery Box

44. RailSupporter(2)

45. Wire Retaining Clip (4)

46. FixingPlate

47. Thermostat

48. Recharger

49. Battery

SAFETY INSTRUCTIONS

When using this appliance, always follow the basic safety precautions:

1. Read the entire Userʼs Manual before operating this appliance.

2. Use this appliance only for its intended purpose as described in this Userʼs Manual.

3. This cooler must be properly installed in accordance with the installation instructions before being used. See grounding
instructions.

4. IDW requires that a dedicated circuit be used for the unit. Failure to do so voids warranty.

5. Never unplug your cooler by pulling on the power cord. Always grasp the plug  rmly and pull it straight out from the
outlet.

6. Unplug your cooler before cleaning or making any repairs.

Note: If for any reason this product requires service, we strongly recommend that a certi ed technician perform the service.

7. When disconnecting the power source, wait at least 5 minutes to reconnect the power to avoid damage to the compressor
and the cooling system.

8. Immediately repair or replace all electrical cords that have become frayed or otherwise damaged. Do not use a cord that
shows cracks or abrasion damage along its length, the plug or the connector end.

9. Do not operate or store your cooler near or around explosive fumes, gasoline or other fl ammable vapors and liquids.

10. Do not use fl ammable liquids to clean unit.

11. Setting the temperature control to the 0 position does not remove power to the light circuit, perimeter heaters, or
evaporator fans.

12. Do not adjust the temperature control. The temperature control is factory set between levels 4 and 5 for maximum
performance.

IMPORTANT!

Please Save These Instructions

For Proper Disposal of the Refrigerator!

PRE-CAUTION, NON-OPERATING COOLERS SHOULD HAVE:

1. Door removed

2. Shelves kept in place in order to prevent any small child from climbing inside cooler

FOR PROPER DISPOSAL OF COOLER: Distributors / retailers need to contact a quali ed service technician:

1. To recover all refrigerant from the cooler

2. To remove the compressor or remove the oil from the compressor

Then the distributor / retailer can contact their local metal recycling center to pick up the remaining cabinet, shelves, etc.

By law, disposal of hazardous wastes may be subject to  nes and imprisonment under the provisions of the environmental

regulations. For more information please visit: http://www.epa.gov/osw/hazard/index.htm