IDW GD-14 Instruction Manual
Instruction Manual
GD-14
Double Door
beverage Cooler
990 N. Amelia Avenue, San Dimas, CA 91773 • www.idw-usa.com
ofce 909.447.8254 • fax 909.305.8756 • toll free 877.307.2665
Manual is for the
following models:
GD-14-C13EB
GD-14
Innovative DisplayWorks
2
TABLE OF CONTENTS
Parts & Identication ................................................. 3
Safety Precautions ................................................... 4
Features ................................................................... 5
Instructions ............................................................... 5
Ambient Environment ............................................... 5
Preparation Before Operation ................................... 6
Replacing the Interior Light ....................................... 7
Replacing the Door LED Lights ................................ 8
Replacing the Canopy Light ..................................... 9
Startup, Operation & Temperature Adjustment ....... 10
Repair & Maintenance for Refrigeration Drawer ..... 10
Condenser Maintenance .........................................11
Maintenance ............................................................11
Canopy Graphics Replacement .............................. 12
Setting Up Power Cord Holder ............................... 12
Troubleshooting ...................................................... 13
After-Sales Service ................................................. 13
Circuit Diagram ....................................................... 14
FOR YOUR FUTURE REFERENCE
■ Thank you for using our product. This manual will guide you in getting the best use of your cooler.
■ Remember to record the model and serial number located on the back of the cooler.
■ Staple your receipt to your manual. You will need it to obtain Warranty Service.
Model #:
Serial #:
Date of Purchase:
Manual is for the following models:
GD-14-C13EB
GD-14
Instruction Manual
Instructional Manual
GD-14
Innovative DisplayWorks
43
23. Inside fan cover (2)
24. Evaporator fan (2)
25. Top right trim
26. Top left trim
27. Door gasket (2)
28. Lampshade (2)
29. Left glass door
30. Right glass door
31. Side LED light (8)
32. Lamp wire (4)
33. Long lamp wire (2)
34. Bottom right trim
35. Bottom left trim
36. Rubber cover (2)
37. Front grill
38. Front grill clip (2)
39. Compressor base
40. Condenser
41. Condenser fan
42. Fan cover
43. Compressor connection pipe
44. Drip pan
SAFETY PRECAUTIONS
When using this appliance, always follow the basic safety precautions:
1. Read the entire User’s Manual before operating this appliance.
2. Use this appliance only for its intended purpose as described in this User’s Manual.
3. This cooler must be properly installed in accordance with the installation instructions before being used.
See grounding instructions on page 6.
4. Never unplug your cooler by pulling on the power cord. Always grasp the plug rmly and pull it straight out
from the outlet.
5. Unplug your cooler before cleaning or making any repairs. Note: If for any reason this product requires service,
we strongly recommend that a certied technician perform the service.
6. Immediately repair or replace all electrical cords that have become frayed or otherwise damaged. Do not
use a cord that shows cracks or abrasion damage along its length, the plug or the connector end.
7. This cooler should not be recessed or built into an enclosed cabinet. It is designed for freestanding
installation only.
8. Do not operate or store your cooler near or around explosive fumes, gasoline or other ammable vapors
and liquids.
9. Setting the temperature control to the 0 position does not remove power to the light circuit, perimeter
heaters, or evaporator fans.
Please save these instructions!
DANGER!
Proper Disposal of the Refrigerator
To prevent any risk of child entrapment when discarding your cooler remove the doors and leave the shelves in
place so that children cannot easily climb inside.
PRE-CAUTION, NON-OPERATING COOLERS SHOULD HAVE:
1. Glass door removed.
2. Shelves kept in place in order to prevent any small child from climbing inside cooler.
FOR PROPER DISPOSAL OF COOLER: Distributors / retailers need to contact a qualied service technician:
1. To recover all Freon/refrigerant from the cooler
2. To remove the compressor or remove the oil from the compressor
Then the distributor/ retailer can contact their local metal recycling center to pick up the remaining cabinet,
shelves, etc. By law, disposal of hazardous wastes may be subject to nes and imprisonment under the
provisions of the environmental regulations. For more information please visit: http://www.epa.gov/osw/hazard/
index.htm
1. Cabinet
2. Interior LED
3. Interior lights cover
4. Interior lampshade board (2)
5. Canopy LED
6. Left top hinge
7. Right top hinge
8. Canopy top bracket
9. Canopy
10. Canopy blanking cap
11. Canopy liner
12. Canopy bottom bracket
13. Evaporator bracket (2)
14. Evaporator
15. Wire Sleeve
16. Outlet pipe
17. Outlet pipe cover
18. Inner drip pan
19. Drip pan plate
20. Switch (2)
21. Thermostat
22. Thermostat mark
45. Outlet pipe
46. Filter connection
47. Compressor
48. Capacitor
49. Starter relay
50. Overload protector
51. Shelf (4)
52. Shelf clip (16)
53. Shelf strip (4)
54. Clip
55. Filter bracket assembly
56. Filter
57. Cabinet bracket
58. Caster (4)
59. Beam plate
60. Heating wire
61. Beam trim
62. Foam insulation
63. Beam
64. Right bottom hinge
65. Combined connection wire
66. Side plate (2)
1
4
3
2
白
色
白色
1
2
3
4
5
6
7
8
9
10
11
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
25
26
27
28
29
33
32
30
34
35
36 37 38
31
84
12
59
60
61
62
63
13 14 15
16
17
18
19
20
21
22
23
24
39
40
41
42
43
44
46
47
49
50
45
48
54
57
58
55
56
51
52
53
PARTS & IDENTIFICATION
67. Middle plate
68. Water hose
69. Side plate
70. Circle pipe
71. Nylon washer (2)
72. Left bottom hinge
73. Transformer box (3)
74. Transformer #1
75. Transformer #2
76. Defrost timer
77. Junction box
78. Retaining plate bracket
79. Retaining plate
80. Power Cord
81. Back grill
82. Hang line stents
83. Rearbafeplate
84. Front plate (2)
Loading...