Idw G-10-N33EB, GCG-10-N33EB User Manual
G-Series Cooler
GCG-10
UPRIGHT COOLER
Manual is for the following models:
GCG-10-N33EB
G-10-N33EB
Instruction Manual
Manual is for the following models:
GCG-10-N33EB
G-10-N33EB
Instruction Manual
GCG-10
1
GCG-10
FOR YOUR FUTURE REFERENCE
• This easy-to-use manual will guide you in getting the best use of your cooler.
• Remember to record the model number and the serial number. This information can be found on the
inside of your cooler.
• Keep your receipt with this manual for future warranty service.
Model #:
Serial #:
Date of Purchase:
TABLE OF CONTENTS
Safety Precautions ..............................................................3
Parts & Identication ..........................................................4
Features ..............................................................................5
Flammable R290 Warnings .................................................5
Instructions ......................................................................... 5
Ambient Environment .......................................................... 5
Preparation Before Operation ..............................................6
Removal of Light Canopy & Instruction ................................7
Lamp Decoration, Illumination & Switches ........................... 8
Startup, Operation & Temperature Adjustment .....................9
Lit Door ‘Logo’ Switch .......................................................... 9
Repair & Maintenance for Refrigeration Drawer ................... 9
Condenser Maintenance .................................................... 10
Maintenance ..................................................................... 10
Cleaning Shutdown Questions & Answers ........................... 10
Troubleshooting ................................................................ 11
After-Sales Service ............................................................. 11
Specications .................................................................... 12
Circuit Diagrams ............................................................... 12
2
Innovative DisplayWorks
Instruction Manual
PARTS & IDENTIFICATION
GCG-10
1. Cabinet
2. Upper Hinge
3. Bushings
4. Rubber Hinge Cover
5. Wire Sleeve
6. Top Hinge Cover
7. Evaporator Bracket
8. Evaporator
9. Fan Baffl e
10. Evaporator Fan
11. Evaporator Fan Motor Bracket
12. Thermostat Bolt
13. Thermostat
14. Thermostat Label
15. Evaporator Fan Shroud
16. Door Upper Trim
17. Door Gasket
18. Glass Door
19. LED Light
20. Inner Light Wires
21. Door Side Light Wires
22. Door Bottom Trim
23. Door Stop
24. Bottom Hinge Washer
25. Key
26. Lock
27. Glass Door Light Covers (GCG
models only)
28. Front Grill Clip
29. Front Grill
30. Transformer (1A)
31. Transformer (600mA)
32. Transformer for Evaporator Fan
33. Transformer Box
34. Leveling Legs (4)
35. Castor Installation Base
36. Transformer Box
37 Wire Tray Bracket
38. Bottom Hinge
39. Shelf Strip
40. Wire Protector Cover
41. Thermostat Connecting Wire
42. Transformer Connecting Wire
43. Fan Connecting Wire
44. Wire Clips
45. Shelf Clips
46. Drain Funnel Support
47. Flat Shelf
48. Inside Light Cover
49. Light Cover Bracket
50. Inner Drain Pan
51. Drain Pipe
52. Interior Rear Holder
53. Lock Holder
54. Overload Breaker
55. Starter Relay
56. Glass Door Support
57. Condenser Fan
58. Condenser Fan Motor Bracket
59. Condenser Fan Blade
60. Junction Box
61. Defrost Timer
62. Electrical Board
63. Condenser
64. Drip Pan
65. Connecting Pipe
66. Compressor Base
67. Filter Drier Bracket
68. Filter Drier Clip
69. Filter Drier
70. Drain Connected Pipe
71. Hoop
72. Compressor
73. Plastic Clip
74. Rear Compartment Grill
75. Power Cord Holder
76. Power Cord
77. Light Switch
78. Switch Box
79. Switch Box Cover
80. Suction Tube
81. Left Glass Door Light Cover
82. Right Glass Door Light Cover
3
GCG-10
SAFETY PRECAUTIONS
When using this appliance, always follow the basic safety precautions:
1. Read the entire User’s Manual before operating this appliance.
2. Use this appliance only for its intended purpose as described in this User’s Manual.
3. This cooler must be properly installed in accordance with the installation instructions before being used. See grounding
instructions on page 6.
4. Never unplug your cooler by pulling on the power cord. Always grasp the plug rmly and pull it straight out from the
outlet.
5. Unplug your cooler before cleaning or making any repairs. (Note: If for any reason this product requires service, we
strongly recommend that a certi ed technician perform the service.)
6. Immediately repair or replace all electrical cords that have become frayed or otherwise damaged. Do not use a cord that
shows cracks or abrasion damage along its length, the plug or the connector end.
7. This cooler should not be recessed or built into an enclosed cabinet. It is designed for freestanding installation only.
8. Do not operate or store your cooler near or around explosive fumes, gasoline or other fl ammable vapors and liquids.
9. Setting the temperature control to the 0 position does not remove power to the light circuit, perimeter heaters, or
evaporator fans.
Please save these instructions!
DANGER!
Proper Disposal of the Refrigerator
To prevent any risk of child entrapment when discarding your cooler remove the doors and leave the shelves in place so that
children cannot easily climb inside.
PRE-CAUTION, NON-OPERATING COOLERS SHOULD HAVE:
1. Glass door removed.
2. Shelves kept in place in order to prevent any small child from climbing inside cooler.
FOR PROPER DISPOSAL OF COOLER: Distributors / retailers need to contact a quali ed service technician:
1. To recover all Freon/refrigerant from the cooler
2. To remove the compressor or remove the oil from the compressor
Then the distributor/ retailer can contact their local metal recycling center to pick up the remaining cabinet, shelves, etc. By law,
disposal of hazardous wastes may be subject to nes and imprisonment under the provisions of the environmental regulations.
For more information please visit: http://www.epa.gov/osw/hazard/index.htm
4
Innovative DisplayWorks
Loading...