IDUINO for Maker’s life
www.openplatform.cc
Mini Reed Switch Module(SE013)
1 Introduction
This module is a simple reed switch module, it’s similar with the module17(Reed
switch module), but it has no analog pin, no adjustable resistor, just soldering one 10K
ohm resistor.
Specification
Operation voltage: 5V
3Pin
Size:25*15mm
Weight: 2g
2 Pinout
Pin
Description
D0
Digital output pin, output Low or High
signal when there current or magnetic
exists
+(middle pin)
Power
-
Ground
3.example
The example show that Reed module and the interface comes with digital 13 LED
build a simple circuit to produce a Reed warning lamp 13 comes with digital interfaces
of the LED, the Reed sensor access number 3 interface, when Reed sensors Sensed a
key signal, LED lights, otherwise off.
IDUINO for Maker’s life
www.openplatform.cc
********Code Begin********
int Led = 13 ; / / define LED Interface
int buttonpin = 3; / / define the Reed sensor interfaces
int val ; / / define numeric variables val
void setup ()
{
pinMode (Led, OUTPUT) ; / / define LED as output interface
pinMode (buttonpin, INPUT) ; / / output interface as defined Reed sensor
}
void loop ()
SunFounder{
val = digitalRead (buttonpin) ; / / digital interface will be assigned
a value of 3 to read val
if (val == HIGH) / / When the Reed sensor detects a signal, LED flashes
{
digitalWrite (Led, HIGH);
}
else
{
digitalWrite (Led, LOW);
}
}
********Code End********
Loading...