ididit Tilt Dress-Up Kit User Manual
PROPERTY OF
ididiT, inc
PROPERTY OF
ididiT, inc
PROPERTY OF
ididiT, inc
PROPERTY OF
ididiT, inc
How to install your Tilt Dress-Up Kit
Turn Signal Lever:
The turn signal lever is the lever closest to the top of the column.
With the steering wheel and adaptor removed, look down from the
top of the column and you’ll see where a single screw holds the
lever in place. Remove the retainer screw and original lever. Insert
the new lever by using the provided screw, and screw into the round
hole (not the “D” shaped hole) (Figure 1A). When installing this
lever in a new column, use the screw supplied and fasten the lever
in the recessed area on the signal switch arm. (Figure 2)
Tilt Lever:
Look directly below the turn signal lever, and you’ll see another
opening in the column. Inside this opening is a threaded hole
which the new lever screws into. When replacing an existing lever,
unscrew the old lever (counter-clockwise) and replace it with the
new lever. (Figure 3)
Emergency Flasher Knob:
Located directly opposite the turn lever on the steering column is
another opening. Inside is a round hole in the nylon switch. Simply
screw the new knob in place (clockwise). When replacing an
existing knob, remove the old screw and knob and replace them
with the new knob. (Figure 4) When nished installing the asher
knob, make sure the knob is in the out (off) position.
ididit inc. 610 S. Maumee St. 49286 Tecumseh, MI • PH: 517-424-0577 • FAX: 517-424-7293 • ididitinc.com
Instruction #: 8000010080 REV 01/13
Loading...