ididit Golf Cart Steering Column Flasher Kit User Manual

PROPERTY OF

ididiT, inc

PROPERTY OF

ididiT, inc

PROPERTY OF

ididiT, inc

PROPERTY OF

ididiT, inc

PROPERTY OF

ididiT, inc

PROPERTY OF

Golf Cart Flasher Kit Wiring Instructions

For Part Number’s 3100500741

The turn signal switch found in your ididit steering column
will require three FEED wires (Figure A). These FEED
wires will provide the 12-volt power sources required for
your turn signal switch to function properly. These three
wires have been provided in the kit as well as the correct

asher units, and a convenient mounting stand. Each wire

has a pre-crimped clip. This clip will plug directly into
a female end plug provided with your steering column
(Figure B).

These three feed wires are pre-crimped (Figure A:) and
ready to be installed in the female end plug. Simply slide the
terminal into the harness. It will click and lock into place.

K- Dark Brown wire (Emergency Flasher Feed)
L- Purple Wire (Turn Signal Feed)
P- White Wire (Brake Light Feed)

(Above letters signify what terminal should be plugged into the harness)

White wire (end w/out Crimp-on Clip):
Attach this wire to the output wire from the brake light
switch. This wire will feed power to the brake lights when
the brake pedal is depressed. (Figure C 1.)

Note: Do not splice into or “T” off this wire to feed power to
the column. The wire should feed power to the column only.

Dark Brown wire (end w/out Crimp-on Clip):
Attach this wire to a constant 12-volt power source. This will

direct power through the asher. When the asher button is
depressed all four lights will light up and ash. (Figure C

1.)

Pink wire (end w/out Crimp-on Clip):

Attach this wire to a keyed 12-volt power source. This will

direct power through the asher. When the turn signal lever

is depressed and the ignition switch is on the corresponding

lights will light up and ash. (Figure C 1.)

Crimp-on Clips:

These crimp-on clips are included with your female end
plug. (Figure C 4.) Crimp one of these clips onto each of
the four pre-existing wires coming from the turn signal on
each corner of your cart. Once the clip has been crimped into
place slide and lock the crimp to the proper location (refer
to schematic Figure B.) in the plastic harness the plastic has

www.ididitinc.com

ididit inc. 610 S. Maumee St. 49286 Tecumseh, MI PH: 517-424-0577 FAX: [phone]

been lettered for your convenience.

Instruction #: 8000010031 REV 07/09