ididit Electrical Wiring for Neutral Safety Switch User Manual
PROPERTY OF
ididiT, inc
PROPERTY OF
ididiT, inc
PROPERTY OF
ididiT, inc
PROPERTY OF
ididiT, inc
Wiring for Neutral Safety Switch (Two different styles)
Style A: The two tabs on the left side of the Neutral Safety Switch (NSS) control the
actual starting of the engine.
Hook the solenoid wire from the ignition switch to the top tab on the left side of the NSS.
Connect a wire from the bottom tab to the starter solenoid marked with the letter “S”.
The NSS has been pre-adjusted. If you remove the switch to paint the column, you may
have to adjust it so it will only start in park and neutral again.
Style B: The two tabs on the right side of the NSS control the actual starting of the
engine.
Hook the solenoid wire from the ignition switch to the top tab on the right side of the NSS.
Connect a wire from the bottom tab to the starter solenoid marked with the letter “S”.
The NSS has been pre-adjusted. If you remove the switch to paint the column, you may
have to adjust it so it will only start in park and neutral again.
The other two tabs are for back-up lights. One tab goes to a fuse that is hot all the time.
The other tab goes to the back-up lights. If no back-up lights are to be used, disregard
these directions and hook no wires to either tab.
ididit inc. 610 S. Maumee St. 49286 Tecumseh, MI • PH: 517-424-0577 • FAX: 517-424-7293 • ididitinc.com
Instruction #: 8000020014 REV 05/10
Loading...