IDEC PS5R Installation Guide
Installation Instructions
Time-Saving Spring-up Terminals
The innovative terminals on the PS5R series use a special, spring-loaded screw. This makes installation as easy as pushing down and turning with a screwdriver.
Installation time is cut in half since the screws do not need to be backed out to install wiring. The screws are held captive once installed and are 100% finger-safe.
Screw terminals accept bare wire or ring or fork connectors.
1. Insert the wire connector into the slot on the side of the power supply.
2. Using a Phillips screwdriver, push down and turn the screw.
Overcurrent Protection Characteristics
The wire is now connected, and the screw terminal is finger-safe!
Front Panel (terminals)
Terminal Name Description
V. ADJ
DC ON
+V, –V
L, N
NC
Voltage
adjustment
Operation
indicator
DC output
terminals
Frame
ground
Input
terminals
No connection
Adjusts within ±10%; turn clockwise to increase
output voltage
Green LED is lit when output voltage is on
+V: Positive output terminal
–V: Negative output terminal
Ground this terminal to reduce high-frequency
currents caused by switching
Accept a wide range of voltages and frequencies
(no polarity at DC input)
Do not insert wires here, as this may damage the
power supply
PS5R-A/B
100
50
Output Voltage (%)
0
Output Current (%)
Parallel Operation
PS5R
PS5R
PS5R
PS5R
PS5R
100 120
+V(24V)
-V (0V)
100
50
Output Voltage (%)
0
TERMINALS
PS5R-C/D/E
Output Current (%)
100 120
ELECTRIC LOAD
L
Power Supplies
Par allel operation only recommended for PS5R-Q24,
PS5R-F24 and PS5R-G24.
www.idec.com USA: (800) 262-IDEC or (408) 747-0550, Canada: (888) 317-IDEC L-11
Loading...