IDEAL INDUSTRIES 5009-1, 5009-2 User Manual

2345678901234567890123456789012123456789

0

2345678901234567890123456789012123456789

IDEAL 5009-1 IDEAL 5009-2

Modular conveyor belt system

Operating Instructions

1

2345678901234567890

1

IDEAL 5009-1 • IDEAL 5009-2

2

2345678901234567890123456789012123456789

0

2345678901234567890123456789012123456789

Table of contents

1. General ....................................................... 4

1.1 Safety Instructions ...................................... 4

1.2 Application ................................................... 4

2. Installation ................................................... 5

2.1 Transport ..................................................... 5

2.2 Preparing for installation ............................. 6

Waste cart ................................................... 6

Conveyor belt (Accessory) .......................... 6

2.3 Power supply ............................................... 8

2.4 Checking rotating direction ......................... 8

When the machine works in the opposite

direction....................................................... 8

3. Operation .................................................... 9

3.1 Operating elements ..................................... 9

3.2 Starting the machine ................................... 9

Stopping the machine ............................... 10

Yellow pilot light flashes ............................ 10

3.3 Stopping the machine ............................... 10

For short breaks ........................................ 10

For longer breaks ...................................... 10

3.4 Replacing the plastic bag .......................... 11

3.5 Oiling the shredding mechanism ............... 11

4. Trouble shooting ....................................... 12

5. Accessories ............................................... 14

6. Technical data ........................................... 14

7. EC-declaration of conformity ..................... 15

3

2345678901234567890

1

IDEAL 5009-1 • IDEAL 5009-2

1. General

This instruction manual is meant to help you to operate the machine easily and safely. Please read these operating instructions before putting the machine into operation and observe the safety regulations.

1.1 Safety Instructions 

Danger!

Non-compliance with the instructions may endanger persons.

 Warning!

Non-compliance with the instructions may cause damage to the machine.

The operating instructions must always be available for the operator.

1.2 Application

The machine is constructed to shred paper, flat or crumpled, as well as cardboard boxes including staples. Data security is not guaranteed when shredding single sheets of paper. Access to the cutting mechanism is prevented by a grid.

Danger!

The machine may only be operated by qualified persons.

Do not let children operate the machine.

Danger!

When the main switch is switched on do not use steps or anything similar when operating or repairing the machine.

Danger!

Do not shred materials which may loop, liquids or materials which may explode, chemically react or splinter.

 Warning!

Do not feed large steel components, screws, nails or hard materials. This will damage the

25

4

shredding mechanism.

0

660 mm

27 “

2345678901234567890123456789012123456789

2. Installation

The machine is mobile on castors. The machine must be installed on a sturdy, dry and level floor.

Danger!

- The machine must not be used outside.

- Do not use in the vicinity of flammable liquids or gases.

- Do not use in wet environments.

- Protect the power cable from extreme heat, oil, and sharp edges.

 Warning!

- Consider the floor loading. Weight approx. 1200 kg.

780 mm

32 “

15-01

2.1 Transport

 Warning!

Do not lift the machine more than necessary

2

1

23

 Warning!

The transport safety device (1) and (2) must be mounted when the machine is transported lengthwise. The machine must be transported from the rear. It is not necessary to mount the safety device when the machine is transported from the side.

- Make sure the pallet-jack is centred under the machine.

5