ID-AL Flash MPX User Manual

ID-AL - FLASH MPX - MP2/3/4 audio/video player - ManualID-AL - FLASH MPX - MP2/3/4 audio/video player - Manual

ID-AL - FLASH MPX - MP2/3/4 audio/video player - Manual

® Waves System V 1.2 - 2006

Flash MPX

MANUAL

Firmware 1.2

ID-AL - FLASH MPX - MP2/3/4 audio/video player - ManualID-AL - FLASH MPX - MP2/3/4 audio/video player - Manual

ID-AL - FLASH MPX - MP2/3/4 audio/video player - Manual

® Waves System V 1.2 - 2006

ID-AL - FLASH MPX - MP2/3/4 audio/video player - ManualID-AL - FLASH MPX - MP2/3/4 audio/video player - Manual

ID-AL - FLASH MPX - MP2/3/4 audio/video player - Manual

® Waves System V 1.2 - 2006

TABLE OF CONTENTS

1 - Safety instructions ......................................................P2

2 - Products information...................................................P4

3 - Introduction.................................................................P5

4 - The MPX player dual drives .......................................P5

5 - Type of Compact Flash and USB flash drive ..............P5

6 - Video file types ...........................................................P6

7 - Audio file types ...........................................................P7

8 - Software conversion for PC user ................................ P7

9 - ImToo software converter...........................................P7

10 - For MAC user ........................................................... P8

11 - JPeg picture file........................................................P8

12 - How to loop a video ..................................................P8

13 - How to play video using push button ........................P8

14 - How to create file folder............................................P9

15 - Inputs .......................................................................P 9

16 - How to trigger an input .............................................P9

17 - How to jump into (enter) a file folder .........................P9

18 - How to play a file while inside a file folder...............P10

19 - Jump to file folder ................................................... P11

20 - Default mode ..........................................................P12

21 - Dark Screen ...........................................................P13

22 - IDLing with no sound ..............................................P13

23 - How to program...................................................... P13

24 - Application examples..............................................P14

25 - Technical specifications.......................................... P20

ID-AL products are distribued/manufactured by Waves System LA VILLE EN BOIS - 44830 BOUAYE - FRANCE Sales and information: +33 2 40 78 22 44 E-mail : info@id-al.com - Web site: http://www.id-al.com and www.wsystem.com

Technical support : support@wsystem.com For a detailed list of the technical support options, we suggest you to visit our site www.id-al.com.

Information in this manual is subject to change without notice and do not represent any commitment from Waves System. The equipment described in this manual is supplied under condition of the terms of license specifying the legal use conditions. This manual can’t be reproduced or used, in whole or in part, in any form and by any mean, for other use than private, without the written permission from Waves System.

ID-AL is a trademarks of Waves System.

- 1 -

ID-AL - FLASH MPX - MP2/3/4 audio/video player - ManualID-AL - FLASH MPX - MP2/3/4 audio/video player - Manual

ID-AL - FLASH MPX - MP2/3/4 audio/video player - Manual

® Waves System V 1.2 - 2006

WARNING: DO NOT EXPOSE TO MOISTURE AND DUST!

Unplug the power cord before any intervention!

FOR YOUR SAFETY, PLEASE READ CAREFULLY THIS OPERATION MANUAL

BEFORE USING YOUR PLAYER.

1. SAFETY INSTRUCTIONS

1.1 CE marking

The CE marking is on the ID plate, at the back of the product. It means this product complies with the low voltage CE directive, according the EN 55022 standard, and the EMC directive 61000-4-x.

1.2 Directives

• Electro-magnetic compatibility (EMC) and low voltage directive requirements are satisfied.

1.3 Overview

• The user’s manual forms an integral part of the unit. It must be kept close to the unit. Precise observance of these instructions is a pre-condition to use the unit for the intended purpose and for its correct operation.

This user’s manual must be passed on to any future purchaser or operator. The staff would receive instructions concerning the correct use of the product.

• Safety for the operator as well as trouble-free operation of the unit is only ensured if use is made of original equipment parts. Moreover, use may only be made of those accessories that are specified in the technical documentation or that have been expressly approved by the manufacturer. The manufacturer cannot guarantee for the safety or proper functioning of the unit in the case where accessories or consumables are used which are not supplied by the manufacturer.

• The warranty doesn’t cover damages caused by use of accessories or consumables which are not supplied by the manufacturer.

• The manufacturer only regard himself as being responsible for the equipment with regard to safety, reliability and proper functioning if assembly, re-settings, changes or modifications, extensions and repairs have been carried out by the manufacturer or a company authorized by the manufacturer and if the equipment is used in conformity with the operating instructions written in this manual.

• No reproduction, in whole or in part, without the written permission from Waves System.

1.4 General safety instructions

This equipment left our facilities in perfect conditions of operation. In order to maintain these conditions, for safety and to avoid any risk of injury, the user must imperatively follow the safety instructions and read the ´Warning!´ notes in this manual. This equipment has been so designed that any danger is virtually excluded provided it is used according to its purpose. However, for safety reasons, we are obliged to point out the following measures:

- 2 -

ID-AL - FLASH MPX - MP2/3/4 audio/video player - ManualID-AL - FLASH MPX - MP2/3/4 audio/video player - Manual

ID-AL - FLASH MPX - MP2/3/4 audio/video player - Manual

® Waves System V 1.2 - 2006

• When operating this appliance, observe all local rules and enforced regulations! The homologation shall be invalid if any modification or alteration is made on the appliance. Operating modified appliances may lead to a penal suit. In the interest of the safety of work, the manager and the operator will be responsible

for respecting the instructions.

• Retain all packing material in case the device must be shipped. Take care that it does not fall into the hands of children. Only the original packing guarantees optimal safety of the appliance during transport. Should it be necessary to ship the product during the guarantee period, Waves System will not accept

claims for damage arising during the transport from using incorrect packing material!

• This product is dedicated to broadcasting music. It may only be operated by trained or knowledgeable personnel who can handle the device correctly.

• Before every use, the operator must check the functional safety and the condition of the appliance and must be knowledgeable in the operation of the appliance.

• This device must not be used in places with potential explosion risk. Moreover, it must not be used in an environment favouring combustion neither in a wet or excessively hot or cold place.

1.5 Safety instructions against risks pertaining to electrical current

• The appliance must be connected to a grounded AC power outlet or a correctly wired CEE AC outlet.

• Before connecting the appliance, verify that the power supply voltage and frequency match the specifications indicated on the appliance.

• Before powering, check that the appliance and the cables are not damaged. Damaged cables and connections must be immediately replaced.

• Never leave power cords enter in contact with other cables! Handle the power cord and all the cables connected to a power supply with extreme care.

• Always connect the power supply last. Check that the power switch is ´off’ before connecting the appliance to mains supply. The mains outlet must be accessible after installation.

• Always grasp only the plug on the power supply cord. Never pull the cable to unplug.

• Power supply, repairs and maintenance must be done by qualified personnel.

• Do not switch the appliance on and off in short intervals, as this may reduce its life, especially concerning the hard disk.

1.6 - Conditions of use :

• This product has been designed for indoor use only.

• If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The arising condensation water might damage your device. Leave the device switched off until it has reached room temperature.

• Do not shake the device. Avoid brute force when installing or operating the device.

• When choosing the installation-spot, please make sure that the device is not exposed to extreme heat, moisture or dust. There should not be any cables lying around, for your own safety and that of bystanders.

- 3 -

ID-AL - FLASH MPX - MP2/3/4 audio/video player - ManualID-AL - FLASH MPX - MP2/3/4 audio/video player - Manual

ID-AL - FLASH MPX - MP2/3/4 audio/video player - Manual

® Waves System V 1.2 - 2006

2. PRODUCT INFORMATION

2.1 Correct usage

The player is designed for automatically broadcasting music, audio, video files. Correct usage implies observation of the instructions in this manual as well as observing the requirements concerning installation.

2.2 Incorrect usage

Any other use beyond this is considered as incorrect usage. The manufacturer will not be liable for any damage resulting from incorrect usage. The operator carries all risks.

2.3 CONTENTS

Flash MPX player Power supply block

User manual

2.4 INSTALLATION

The apparatus must be set up in a dry and dust-free room.

Do not install the player too close to a wall. To avoid overheating, the ventilation holes must be kept clear and an air circulation gap must be left above the unit.

2.5 ELECTRICAL CONNECTION

Before use, compare mains voltage with that specified on model plate.

- 4 -

ID-AL - FLASH MPX - MP2/3/4 audio/video player - ManualID-AL - FLASH MPX - MP2/3/4 audio/video player - Manual

ID-AL - FLASH MPX - MP2/3/4 audio/video player - Manual

® Waves System V 1.2 - 2006

- 5 -

FLASH MPX Manual

INTRODUCTION :

The mpx player is a self-contained Solid State Mpeg4 Video/MP3 Audio player housed in a small aluminum enclosure. The mpx player utilizes the latest development in custom design single chip to decode various Mpeg compression systems including Mpeg4 video, Mpeg4 Audio and Mp3 audio. Mpeg4 video is the latest video compression that gives similar or better video quality than Mpeg2 video (DVD video) at less than half the bit rate. The mpx player has two drives, Compact Flash Card and USB Flash drive. It has16 digital input and is configured to provide a very fast reaction time so that the video/audio playback is instantaneous. The mpx player is preprogrammed to play a multi stage interactive multimedia presentation and to support push buttons and sensors. The mpx player is a solid state device that will give you years of trouble free operation, superb video quality and at a much lower cost.

THE MPX PLAYER DUAL DRIVES :

The mpx player has two drives. It reads from a Compact Flash card OR USB flash drive, but not both. The mpx player is a video/audio playback device only, it is not configured for direct connection into a PC. The USB port on the mpx player is configured strictly for reading the USB Flash drive only. It can not communicate with your PC and/or download files from it. To copy files into the Compact Flash Card, use a USB card reader and a PC (USB port) and copy the files into the CF card. To copy files into the USB Flash drive, plug it directly into the USB port of your PC and copy the files into it.

TYPE of COMPACT FLASH CARD and USB FLASH DRIVE :

If you are using a compact flash card for Audio or Low bit rate Video (under 4 Mbit/ s), you can use any standard Sandisk Compact Flash card. For higher bit rate video (over 4 Mbit/s) use Sandisk Ultra II Compact Flash card only. If you are using USB Flash drive use a USB Flash drive with 2.0 interface only. Do not use USB1.1 interface. The mpx player reads Compact Flash card and USB Flash drive that uses Windows (98 to XP) DOS (FAT) format only, not NTSF. Do not format a new drive. However if you have to format a used drive, format it with DOS (FAT or FAT32) format only (not NTFS). The USB drive is also called Thumb Drive, Cruiser Mini, Stick Drive or Flash drive.

ID-AL - FLASH MPX - MP2/3/4 audio/video player - ManualID-AL - FLASH MPX - MP2/3/4 audio/video player - Manual

ID-AL - FLASH MPX - MP2/3/4 audio/video player - Manual

® Waves System V 1.2 - 2006

- 6 -

VIDEO file types:

xxx.mpg (Mpeg2 and Mpeg1):

Flash mpx is optimized to play Mpeg2 video files at up to 9 Mbps. Consider using Mpeg2 first before using other format. An Mpeg2 file most likely consists of Mepg2 Video stream and MP2 (Mpeg1 Audio) audio stream. This file should be readily played by the Flash mpx. If your Mpeg2 file does not play, then most likely it is not a program Mpeg file. Use the ImToo converter software to convert it into Mpeg2 program file.

xxx.vob (VOB file from DVD):

A DVD file (vob) most likely consists of Mpeg2 Video stream and MP2 (Mpeg1 Audio) or AC3 audio stream. If the vob file plays on the mpx but no sound, then most likely the audio portion is AC3. To play it on the Flash mpx, you have to convert the VOB file into Mpeg2 file using MP2 audio (Mpeg1 audio) stream. Please see ImTOO encoder software below.

xxx.mp4 MPEG4-10 AVC (h.264):

The Flash mpx plays Mpeg4-2 ASP video only, it will not play Mpeg4-10 video such as Mpeg4 iMovie or Mpeg4 Quicktime.

xxx.mp4 MPEG4-2 ASP file with AAC audio.

Almost all xxx.mp4 file that is encoded with Mpeg4-2 ASP contains Mpeg4 video and AAC audio. This file should be readily played by the Flash mpx, but maximum bit rate is 4Mbps. This video format is also compatible with I-Pod movie, Nero Digital (www.nerodigital.com) etc.

xxx.avi MPEG4-2 ASP file:

Most xxx.avi files contain Mpeg4 video and MP3 audio or PCM16 bit audio. The Flash mpx will readily play any Mpeg4 AVI file, maximum bit rate is 4 mbps. The Mpeg4 video format is compatible with Divx, AVI, 3IVX etc.

xxx.divx MPEG4-2 ASP file with MP3 audio.

The Flash mpx plays DIVX video (www.divx.com), maximum bit rate is 4Mbps. It will also play 3IVX and other Mpeg4 encoder that uses MP3 audio.

+ 16 hidden pages

ID-AL Flash MPX User Manual

Specifications and Main Features

Frequently Asked Questions

User Manual