ICS LANTAP Installation Instruction
LANTAP
Primus Epic LAN Interface Kit
For these instructions and other information See:
http://www.icsaero.com/products/groundtest/lantap-10
Installation Instruction
REV H June 11
th, 2018
Innovative Control Systems, Inc.
10801 N. 24th Ave. Suite 103.
Phoenix, AZ 85029 U.S.A.
+01 602-861-6984 Voice
+01 602-794-6453 FAX
http://www.icsaero.com
sales@icsaero.com
Pag
e 2
Cable Connection
On the BNC side of the LANTAP,
make sure that the COAX, T, and
Terminator are connected as shown:
The LANTAP Adapter is a very simple and easy to use solution for connecting a standard 10/100/1000BaseT Ethernet bus to the Primus EPIC LAN.
On the opposite end, plug one end of the USB cable into the port
marked USB on the LANTAP, and the other end into your computer.
Please note, that ICS strongly recommends using a USB 3.0 port. These
are usually blue instead of black or grey and provide up to 1 amp of
current.
Please make sure that your computer is powered on and running.
Diagnostic LED,10/100/1000 Link.
Light Green / Flashing Green with
10/100/1000BaseT activity. RED
on collisions between 10/100/1000
and 10Base2
Diagnostic LEDs, 10Base2
Activity Yellow Flashing on
Activity
Loading...