ICRealtime PWR-16DC-24A Specsheet

SPECIFICATIONS:

INPUT:

 110 VAC 4.2 amps
 230 VAC 2.1 amps

OUTPUT:

 12 VDC 12 amps
 12 VDC 3.5 amps
 24 VDC 6 amps
 24 VAC 4 amps

FEATURES:

1. Up to 6 AMPS @ 24 VDC - (24 VDC units only) - Up to 12 AMPS @ 12 VDC - (12VDC units only)

2. 110/220 VAC input is switch selectable.

3. 24 VAC outputs also available.

4. Up to 32 Fused or PTC protected outputs.

5. Extra-large enclosure with ample battery space (up to 2 x 12 AH, 12 VDC)

6. Trigger input for Fire Alarm Interface.

INSTALLATION INSTRUCTIONS:

1. Secure cabinet in desired location.

2. Connect AC lines marked to terminals “L” & “N”.

3. Secure earth ground to terminal “G” and green flying lead.

4. Select Line voltage, (110/220/ VAC). Selector switch is located on the side panel of the power unit. (Factory setting is

110VAC)

5. Connect back-up batteries to the terminals “-BAT+” on BC6 board.

6. Connect monitoring devices for battery and AC fail (if required) to terminals “AC Fail” and “Low R ery”.

7. Connect devices to be powered to lA- lB through 8A-8B. All “A” terminals are positive, All “B” terminals are negative, if

DC outputs are used.

8. For units equiped with both 24 VAC and 12 or 24 VDC outputs connect black and white flying leads of the transformer to

line voltage 110 VAC (unless otherwise specified)

9. When using fire alarm interface, connect trigger inouts to normally closed Fire Alarm Panel outputs. Leave trigger

terminals shooted if FACP interface is not used.

Battery

12VDC

BaXery

12VDC