ICP DAS PET-7H24M User Manual

PET-7H24M

ET-7H24 Quick use manual

Version 1.0.1, Sep. 2020

Service and usage information for

Written by Sean

Edited by Anna Huang

Document description

This document will guide users to quickly use the PET-7H24M module.。

1. Preceding procedure：PET-7H24M network settings.

2. Introduction to acquisition and trigger mode: Brief description of

PET-7H24M data acquisition and trigger mode.

3. Simple to use：Simple operation through the HSHSDAQ Utility, collecting

PET-7H24M data, and displaying the data in the utility chart.

4. Program development : VC/.NET program: A brief description of the function call process and program

description according to different acquisition and trigger modes.

5. LabVIEW development: Simply use the process description.

Content

Preceding procedure .......................................................................................................... 4

Introduction to acquisition and trigger mode .................................................................... 8

Simple to use ................................................................................................................... 10

Program development ..................................................................................................... 13

LabVIEW development ..................................................................................................... 23

Preceding procedure

There are two ways for the PET-7H24M module getting the power. One is through Ethernet by a PoE switch; the other is as usual through wiring by an external power

 POE power supply

 Connect PC to the Ethernet port via the PoE switch.

 Connect the power supply to the PoE switch, which supplies power to the

PET-7H24M.

 External Power supply

 Connect PC and PET-7H24M to the Ethernet Switch.  Connect the power supply to the switch and PET-7H24M. (The

external power supply should be in the range of +12 VDC to 48 VDC)

 Network settings

Item

Default

IP Address

192.168.255.1

Subnet Mask

255.255.0.0

Gateway

192.168.0.1

The factory default settings for the PET-7H24M network are as follows:

The way to modify the PET-7H24M network configuration settings is through the HSDAQ Utility.

Steps:

1. Obtain and install the HSDAQ Utility in the following path

http://www.icpdas.com/en/download/show.php?num=2327&model=PET-7H24M

2. Run HSDAQ Utility

3. Press choose “Search” from the “Tools” menu

4. The searched PET-7H24M module will be displayed on the screen of this program.

5. Select the PET-7H24M to be set, and the following setting screen will appear.

6. Write the new setting value in the IP address/Mask/Gateway/Alias field and press the "OK" button

7. Wait for the PET-7H24M to reboot. (After reboot, the new setting value will take effect)

+ 16 hidden pages