ICPDAS PCI-1800 LU, PCI-1800HU, PCI-1802 LU, PCI-1802HU Quick Start Manual

One PCI-1800/1802 (LU/HU) series card
One companion PCI CD (V4.7 or later)
One Quick Start Guide (This document)
One CA-4002 D-Sub connector

for PEX-P8R8i/P16R16i

English/ Version 1.1/ April 2010

for PCI-1800 LU/H

U

PCI-1802 LU/HU

English/ May 2010/ Version 1.0

1

PCI-1800/1802 LU/HU Quick Start Guide

What’s in the shipping package?

Software Utility CD

CA-4002 D-Sub Connector

Quick Start Guide

PCI-1800/1802 (LU/HU)

Series Card

Installing Windows Driver

Follow these steps:

1. Setup the Windows driver. The driver is located at:

CD:\NAPDOS\PCI\PCI-180x\DLL_OCX\

http://ftp.icpdas.com/pub/cd/iocard/pci/napdos/pci/pci-180x/dll_ocx/

The Windows driver only supports Windows 98/NT/2000/ and 32-bit
Windows XP/2003/Vista/7 Versions.

2. Click the “Next>” button to start the installation.

3. Click the “N

ext>” button to install the driver into the default folder.

4. Click the “I

nstall” button to continue the installation.

5. Select “NO, I will restart my computer later” and then click the

“F

inish” button.

Jumper & Card ID Setting

2

PCI-1800/1802 LU/HU Quick Start Guide

SW1 Card ID Setting

JP1: Analog Input Type Selection.

(Please make sure JP1 jumper is kept in default setting before self-test. )

Follow these steps:

1. Shut down and power off your computer.

2. Remove the cover from the computer.

3. Select an unused PCI slot.

4. Carefully insert your I/O card into the PCI slot.

5. Replace the PC cover.

6. Power on the computer.

After powering-on the computer, please finish the Plug&Play
steps according to the prompted messages.

3

PCI-1800/1802 LU/HU Quick Start Guide

Installing Hardware on PC

Card ID

1

ID0 2 ID1 3 ID2 4 ID3

(*) 0 OFF OFF OFF OFF

ON OFF OFF OFF1

OFF ON OFF OFF2

: : : : :

ON OFF ON ON 13

OFF ON ON ON 14

ON ON ON ON 15

(*) Default setting

(Default Setting)