ICPDAS I-7016D Quick Start Manual

I-7016D

Strain Gauge Voltage Input, Current Input

Data Acquisition Module

Quick Start Guide

Product Website:

https://www.icpdas-usa.com/i_7016_d
http://www.icpdas-usa.com/dcon_utility_pro.html

1. Introduction

I-7016 is a cost-effective solution for a wide range of valuable industrial
control signals and systems. The DCON utility can help users to configure
and test I-7016 modules. Plenty of library functions and demo programs are
provided to let users develop programs easily under Windows, Linux and
DOS operating systems. Users may mount the modules on a DIN rail,
panel or wall. Modules have a screw-terminal block to connect to the
signals. I-7016 comes with FREE EZ Data Logger Software.

2. Terminal Assignment

I-7016D - Strain Gauge Voltage Input, Current Input DAQ Module - QuickStart (Nov/2017)

ICP DAS USA, Inc. | www.icpdas-usa.com | 1 -310-517-9888 | 24309 Narbonne Ave. Suite 200. Lomita, CA 90717

1

3. Block/ Wiring Diagram

I-7016D - Strain Gauge Voltage Input, Current Input DAQ Module - QuickStart (Nov/2017)

ICP DAS USA, Inc. | www.icpdas-usa.com | 1 -310-517-9888 | 24309 Narbonne Ave. Suite 200. Lomita, CA 90717

2

4. Default Settings

Default setting for I-7016/16D/16P/16PD :

- Address : 01

- Analog Input Type : Type 05, -2.5 to +2.5 V

- Baudrate : 9600 bps

- Checksum disable, engineer unit format, 60Hz filter

5. Configuration

To install the module, follow the steps below:

1. Connect the analog output.

2. Connect the module to the RS-485 network using the DATA+ and DATA- terminals. If
the host is only equipped with an RS-232 interface, then an RS-232 to RS-485
converter will be required.

3. Connect the module to the power supply using the +Vs and GND terminals. Note that
the voltage supplied should be in the range of +10 to +30V DC.

I-7016D - Strain Gauge Voltage Input, Current Input DAQ Module - QuickStart (Nov/2017)

ICP DAS USA, Inc. | www.icpdas-usa.com | 1 -310-517-9888 | 24309 Narbonne Ave. Suite 200. Lomita, CA 90717

3