ICP EBP1800A1, EBP1800B1, EBP2400A1, EBP2400B1, EBP3000A1 Installation Guide

Single Point Wiring Kit Installation Instructions

EBP, EBX, EBV and EBW Fan Coils

INTRODUCTION

The single point wiring kit is designed to allow single circuit field wiring to 15 kw and 20 kw fused electric heaters. Refer tofan
coil specification sheet for electric heater kit numbers that can be converted from dual circuit to single circuit electrical supply.

NOTE: When using single point wiring kit, wire size and over-current protection device must be based on single circuit electri-
cal data. Consult specification sheet.

INSTALLATION

1. Install 15 kw or 20 kw fused electric heater kit per Installation Instruction.

2. Install lug adapters in fuse box lugs and tighten securely. (See Fig. 18.)

3. Connect single circuit field power supply wiring to lug adapters. (See Fig.18.)

4. Connect ground lead from field power supply to unit ground lug.

LUG ADAPTER KIT

BEFORE LUG ADAPTER

INSTALLATION

L3 L1 L2 L4

FUSE BLOCK

AFTER LUG ADAPTER

INSTALLATION

L3 L1 L2 L4

INSTALLATION MAY BE AIDED BY FIRST
ATTACHING ADAPTER LUGS TO WIRE
THEN POSITIONING LUGS TO FUSE BLOCK

SINGLE CKT

FIELD POWER
SUPPLY WIRES

Fig. 18 - Single Point Conversion

482 01 2228 00 II 1 I

September 2002