Icotek KDR-BES Catalog Page

KDR-BES

Enclosure Base Plate
with Brush Grommets

Product Description

The new 2-piece enclosure base plates KDR-BES are
supplied with preassembled brush grommets.

For standard cut-outs:
KEL-BES - see page 57

KDR-BES Assembly

The base plates are installed with standard Rittal clips.

Depending on the maximum cable diameter to
be routed, the 2 halves of the brush base plate are
aligned further or closer to each other.

The base plates KDR-BES are perfect for protection of
the enclosure interiors against rough dirt.

Advantages & Bene ts

During assembly, almost the complete
base of the enclosure can be used for
installation of cables.
Retro tting possible without disconnecting
cables. Everything can be built around
the cables.
The base plates KDR-BES are designed for
Rittal enclosures TS8. Other sizes can be
supplied on request.

Speci cations

Material

Temperature
Properties

Base plate: Sheet steel, zinc-plated
Brush grommets: Polyamide (PA)

- 20°C to + 90°C (static)
Halogen free, silicone free

Accessories

ZL Strain relief plates 82 - 86

146

KDR-BES

Enclosure Base Plate

with Brush Grommets

~ 16

~ 12

24 - 49

100 - 125

Type Enclosure Enclosure Total length Sight size of base Order No.

type width base plate plate opening

KDR-BES-TS8-600 TS8 600 mm 458 mm 435 mm 58000

KDR-BES-TS8-800 TS8 800 mm 658 mm 635 mm 58006

KDR-BES-TS8-1000 TS8

KDR-BES-TS8-1200 TS8 1200 mm* 518 mm 495 mm 58018

1000 mm

without division bar

858 mm 835 mm 58012

* in case both elds of the enclosure are equipped, 2 complete base plates are necessary.

www.icotek.com

147