Page 1
FTB12000JS
Multi-Function Jump Starter
USER MANUAL
Page 2
• Get to know your device
Lamp button SOS
DC out
ON/OFF/Flashlight
Lamp/SOS
• Features
1. In case a car battery cannot start the car, this device can play the role
of emergency ignition.
2. High capacity of 12000mAh.
3. Built-in LED light and SOS signal function.
4. Power bank for laptops (19 V), tablet PCs (5V), MP3 / MP4,
mobile phones, portable game consoles etc.
5. Multiple safety protection system to ensure, devices' safety: protection
against overcharge, overvoltage, overcurrent and short circuit.
6. Small size, light weight, easy storage. The device is much more easy
to use compared to traditional electric cable.
Сharge indicator
OUTPUT INPUT
DC in
USB out
Battery clip
interface
Flashlight
• Specications
Battery Type:
Li-polymer
Battery Capacity:
12000mAh/44.4Wh
Input:
DC 19V/2A
Output:
DC 12V (for car)
DC 19V
USB 5V
Peak current:
200A
Size:
163 x 87 x 37.3mm
Weight:
500g
Page 3
• Buttons
1. Power on/o
Short press Power button to turn the charge indicator on/o.
Note: The device will turn o automatically after 90 seconds of no-load.
2. “Flashlight” on/o
1) Long press Power key (3 sec) to turn ashlight on.
2) Repeat long press Power key (3 sec) to turn ashlight o.
3. “Lamp/SOS” on/o
1) Press shortly Lamp button to turn on rst level of brightness of
the lamp (maximum).
2) If this button is pressed again within 5 seconds, the second level
of brightness will turn on (medium).
3) Triple continuous pressing Lamp button starts the third level of
brightness (minimum).
4) To turn the lamp o, wait for 5 seconds, and then shortly press
Lamp button.
4. SOS signal on/o
1) Long press the Lamp button (3 sec) to turn SOS signal on.
2) Long press the Lamp button (3 sec) to turn SOS signal o.
Page 4
• Car start
(Applied only to 12 V car battery)
1 2
1. Connect red clamp «+» to the positive contact of the car battery,
then connect black clamp «-» to the negative contact.
2. Connect mini Jumper clamps to the FTB12000JS 12V out.
(Disconnect the car battery if it is completely discharged).
3. Start up the ignition. According to experience, if engine doesn't
start after 3-5 seconds, please wait for 1 minute, and then repeat starting.
4. Disconnect mini Jumper clamps from the FTB12000JS.
5. Disconnect mini Jumper clamps from the car battery.
3
4 5
• Charging mobile devices
Notebooks Tablet PCs Smartphones,
Charge your mobile phone:
1. Use original or standard USB cable to connect the device.
Charge your laptop or other devices (19V):
1. Choose the correct connector for laptop DC input port (19V).
2. Connect the power bank to laptop using the DC cable.
cell phones
Page 5
You can charge FTB12000JS using wall charger or car charger.
Warning:
• Never allow red and black clamps to touch each other or another
common metal conductor — this could cause damage to the unit
and/or create a sparkling/explosion hazard
• The product should be stored at temperatures above freezing to
prevent damage
• The unit is suitable for engine start up to 3 liters
• This system is designed to be used only on vehicles with a 12 V battery
system; do not connect to a 6 V or 24 V battery system
• It is necessary to disconnect the jump starter from the car battery
within 30 seconds after engine start
• Do not disassemble the device yourself. It may be dangerous
• Keep the device in dry place. Do not expose it to high temperatures
• Please fully charge the power bank at rst usage
• Keep the power bank away from children
• Please make a complete charge every four month to avoid shortening
life span
Page 6
• Accessories:
1. AC Adapter
2. DC Cable
3. USB Cable
4. Battery clip
5. Notebook connectors
www.iconbit.com
Loading...