
110 4-Pair Punch-Down Tool
INSTALLATION INSTRUCTIONS
IMPORTANT: For safety purposes, the tool head is set to have the cutting blades hidden to prevent injury. Follow the instructions below to expose the
cutting blades.
110 Wiring Block 110 Connecting Blocks NOTE: Remove tool head from the handle and proceed below.
Tool Head
Terminator Set
o
Step 1a: For seating 110 connecting blocks without cutting wire, use the
tool as is. For terminating and cutting wire, follow the next set of directions.
180
Step 1b: Push terminator and blade set out of tool head body from either
side. Separate terminator set and blade set. Rotate blade set 180º. The
blades will point down at this point.
Blade Set
Patch Panel with Rear 110-Type IDC
Step 2: Push the terminator head set and blade set back into tool head.
Step 3: Attach tool head to handle and punch down.
Item # Description
ICACSPDT4P 110 4-Pair Punch-Down Tool (includes 4-Pair head)
ICACS04PH5 110 4-Pair Replacement Tool Head
FEATURES AND BENEFITS
• Cushioned rubber handle helps absorb impact to reduce hand fatigue.
• Anti-slip raised grip helps keep hand from slipping.
• Ergonomic body provides comfort.
• Compatible with ICC CAT 6, CAT 5e and voice patch panels, and CAT 6 and CAT 5e 110 wiring blocks
888-ASK-4ICC csr@icc.com icc.com
© Copyright 2013, ICC. ICC and ICC logo are registered trade name and trademark. All rights reserved. MSR-0500-RevB