
iBeeLink Everywhere
IoT-WiFi Module Spec Sheet
FCC ID: 2ATCG-BW682TY
1

iBeeLink Everywhere
1.1 Product Introduction
BW682TYIs ibeelinkCompanyIntroducea highly integratedARMCortex-M4F
Processor,384KB SRAM,1MB Flash Module. It Can be widely used in the fields of
intelligent household equipment, remote monitoring equipment, medical
equipment and the like
1.2 Main Features
Support 192MHz ARM Cortex M4 MCU with FPU.
Built –in 384KB SRAM/1MB(8Mbit) FLASH
Support AES,DES,MD5,SHA1
Support RTC Mode and XIP Mode
Working Voltage:DC 3.3V
Wi-Fi Features:
1. Support 802.11b/g/n(2.4Ghz,1X1)standard,20M、40M Bandwidth
2. Support Station and Soft AP Mode
3. Support APK,WechatOfficialAccount,Webbrowser and so on Configure Network
4. Support WEP/WPA2/WPS Security
5. Support Dynamic Switch STA to Soft AP Mode
6. Integration Balun/PA/LNA
7. Support Multi Cloud Connect
Peripheral Interface:
1.UARTX3(3mbps)
2. PWMX5
3.SDIO 2.0 Masterx1, 2.0 SlaveX1
4.I2S X 2(Master or Slave) TX/RX with 16/24/48/96/192 kHz ,11.025kHz, 22.05kHz,
44.1kHz frequencies
5.I2C X 1
6.SPI X2(MasterX1,Slave X1)
7.1 Chanel 12bit ADC
8.Up to 12 GPIOs
Support FreeRtos OS
Support Secure Boot
Comply with FCC rules part 15 subpart C
2

iBeeLink Everywhere
1.3 Electrical Parameters
1.3.1 Power Performance
Remark:If Set Then DTIM=10,Low Power may be less than 500uA.
1.3.2 Work Environment
1.Suggest Operating Conditions: -20 to 80°C,
2.WiFi During Normal Work Peak Current Dot less than 400mA.
3

iBeeLink Everywhere
1.4 RF Performance
1.4.1 Transmitter and Receiver Performance
Receiver sensitivity:
4