TE-MIIRW
Product Manual
1. Find a suitable
camera’s view is unobstructed and be careful not to drill into any wires that
might damage the vehicle. When all connections have been made and before
mounting the camera, verify the camera is working and has good view of the
area. Then mount the camera down with the supplied two screws.
2. Connect the RED wire to the +12 volt reverse wire
Note: P
BLUE power wire provided on the extension cable. If this is done, connect
the RED and the BLUE wire closest to the RCA together. The blue wire is
just a pass-through, RED must be connected to power the camera.
ower ca
location to surface mount i
n a
lso be obtained in the rear of the vehicle using the
nstall the camera. Make sure the
3. Connect
4. Run video cable though vehicle, up to video display. (Avoid placing video
cable where it can get pinched or damaged).
5. Attach the YELLOW video RCA to camera’s output
input of the radio or video display.
the BLACK wire to ground (a metal, non-painted surface).
and to the reverse camera
Loop cutting Instructions:
Green loop will turn the parking guidelines off White loop will flip
the image (top to bottom) Blue loop will mirror the image (flip
left to right
Sensor
CMOS
Effective Pixel
Video Signal
Resolution
S/N Ratio
Current Consumption
Power Supply
Operating Temperature
Storage Temperature
View Angle
Water Resistance
480 X 720
NTSC
500 TV Line
46dB
35-55 mA
DC 6V-12V
-30ºC - 75ºC
-40ºC - 85ºC
175º Dia
IP68
gonal
Minimum Illumination
0.1 Lux
IMPORTANT
If you are having difficulties with the installation of
this product, please call out Tech Support line at
1-800-253-TECH. Before doing so, looks over the
instructions a second time, and make sure the
installation was performed exactly as the instructions
are stated. Please have the vehicle apart and ready to
perform troubleshooting steps before calling.
REV 1/16/2019
Loading...