iBeam TE-GTGC Installation Guide

TE-GTGC/TE-GTGCC (CMOS)

wire goes to the rear camera input trigger wire on
your video source, plug RCA to your video screen
input

NOTE: Test to make sure video is working before
securing new handle.

7. Carefully replace new tailgate handle in tailgate
and secure the handle using the two bolts that
were previously removed.

CHEVY SILVERADO & GMC

SIERRA 1500 (2007-2013)

CHEVY SILVERADO & GMC

SIERRA 2500/3500 (2007-2014)

Replacement Tailgate Handle

with Camera

Removal and Installation

Instructions

Tools Needed: 13mm wrench/13mm

socket and ratchet

1. Start by lowering the tailgate. Stand and face the
back end of the truck you will see three bolts,
remove the two bolts that are side by side directly
in front of you. Those bolts secure the tailgate
handle to the tailgate.

2. Now close tailgate, carefully lift the factory tailgate
handle out and away from the tailgate.

NOTE: If desired parking lines can be removed by
attaching the green wires together.

1.800.221.0932

www.iBeamUSA.com

460 Walker Street, Holly Hill, FL 32117

3. Now that the handle is out of the tailgate, you will
have to swap the locking mechanism out of the old
handle to the new one.

4. Route the backup camera’s wires through the

tailgate handle’s opening and through the tailgate

itself.

NOTE: Avoid pinch points and things that can
damage wires and their functions.

5. Remove taillight and splice the red camera wire

into the reverse light’s 12v positive wire this will

trigger the camera to turn on when vehicle is
placed in reverse. Attach the black ground wire to
a metal non-painted surface.

6. Wires can now be fully routed from the tailgate to
the cab of the truck and to a video source. Red

REV. 05/21/2018