iBeam TE-BPLTC Product Manual
If you are having difficulties with the installation
of this product, please call our Tech Support line
at 1-800-253-TECH. Before doing so, look over
the instructions a second time, and make sure
the installation was performed exactly as the
instructions are stated. Please have the vehicle
apart and ready to perform troubleshooting
IMPORTANT
steps before calling.
KNOWLEDGE IS POWER
Enhance your in stallation and fabrica tion skills by
enrolling in the most recognized and respected
mobile electronics school in our indu stry.
Log onto www.in stallerinstitute.com or call
800-354-6782 for more information and take ste ps
toward a better t omorrow.
Metra recom mends MECP
certified techn icians
Version 1.0
TE-BPLTC
Product Manual
800.221.0932
iBeamUSA.com
460 Walker Street, Holly Hill, FL 32117
If you are having difficulties with the installation
of this product, please call our Tech Support line
at 1-800-253-TECH. Before doing so, look over
the instructions a second time, and make sure
the installation was performed exactly as the
instructions are stated. Please have the vehicle
apart and ready to perform troubleshooting
Version 1.0
IMPORTANT
steps before calling.
KNOWLEDGE IS POWER
Enhance your in stallation and fabrica tion skills by
enrolling in the most recognized and respected
mobile electronics school in our indu stry.
Log onto www.in stallerinstitute.com or call
800-354-6782 for more information and take ste ps
toward a better t omorrow.
Metra recom mends MECP
certified techn icians
TE-BPLTC
Product Manual
800.221.0932
iBeamUSA.com
460 Walker Street, Holly Hill, FL 32117
I. Specifications
II. Connection
（ ） （ ）
℃ ℃
℃ ℃
RED
BLACK
Video (in)
1. This is a behind license plate camera. Begin by removing the license
plate bolts and the license plate, then install camera. Replace license
plate and bolts.
2. Connect the RED wire to the +12 volt reverse wire
3. Connect the BLACK wire to ground (a metal, non-painted surface).
4. Run video cable though vehicle, up to video display. (Avoid placing
video cable where it can get pinched or damaged).
5. Attach the YELLOW video rca to camera’s output and to the reverse
camera input of the radio or video display.
NOTE: The camera needs to angled down 30 - 40 degrees for proper
functionality.
I. Specifications
（ ） （ ）
℃ ℃
℃ ℃
II. Connection
RED
BLACK
Video (in)
1. This is a behind license plate camera. Begin by removing the license
plate bolts and the license plate, then install camera. Replace license
plate and bolts.
2. Connect the RED wire to the +12 volt reverse wire
3. Connect the BLACK wire to ground (a metal, non-painted surface).
4. Run video cable though vehicle, up to video display. (Avoid placing
video cable where it can get pinched or damaged).
5. Attach the YELLOW video rca to camera’s output and to the reverse
camera input of the radio or video display.
NOTE: The camera needs to angled down 30 - 40 degrees for proper
functionality.
Loading...