iArmor IA‐S177 User Manual
iArmor
iArmor® by APS
®
PART#:IA‐S177
BEFORE INSTALLATION
REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE
PRESENT. READ INSTRUCTIONS CAREFULLY BEFORE
STARTING INSTALLATION. ASSISTANCE IS RECOMMENDED. THANK YOU FOR CHOOSING OUR PRODUCT!
PART LIST
X1
Bar Bracket
X1
Driver Front
Mounting Bracket
(DFM/PFM)
X1
Front
Passenger Front
Mounting Bracket (DFM/PFM)
Fastener Size Tightening Torque (ft-lbs)
6mm 6-7
8mm 16-18
10mm 31-32
12mm 56-58
14mm 92-94
X1
Bar Bracket
X1
X1
Bar Bracket
X1
Bar Bracket
X1
Driver Side Step Bar
Driver Center
Mounting Bracket
(DCM/PCM)
X1
Driver Rear
Mounting Bracket
(DRM/PRM)
Customer Support: info@iarmorauto.com
Passenger Center
Mounting Bracket
(DCM/PCM)
X1
Passenger Rear
Mounting Bracket
(DRM/PRM)
1
Bar Bracket
X1
Bar Bracket
X1
Passenger Side Step Bar
Rev. 20201201
®
iArmor
X12
M10X45mm Bolt Plate
X2
M10X1.5-25mm
Hex Bolt
X6 X12
X2
M10 Lock Washers
M10 X1.5 Hex Nuts
X2
X16
U Bracket
The instruction here is for your reference only. We strongly
recommend the professional installer for best result. We are not
responsible for any damage caused by the installation.
M8 Lock Washer
M8 Clip Nut
X12
M10 X1.5 Hex
Flange Nut
M10 Large Flat
Washer
X10
M8X1.25-25mm Hex Bolt
X4
M8X1.25 Hex Nut
X12
M8 Large Flat Washer
M8X1.25-55mm Carriage Bolt
STEP 2
Install M8 Clip Nuts as shown, (Fig 2-3).
X2
X12
M10 Flat Washer
X22
X6
Spacer
STEP 1
Locate mounting locations as shown, (Fig 1).
(Fig 1) Passenger Side Mounting Locations
Fig 2
M8 Clip Nut
M8 Clip Nut
Fig 3
Customer Support: info@iarmorauto.com
2
Rev. 20201201
Loading...