iArmor IA‐S011 Installation Manual
iArmor
iArmor® by APS
®
PART#:IA‐S011
BEFORE INSTALLATION
REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE
PRESENT. READ INSTRUCTIONS CAREFULLY BEFORE
STARTING INSTALLATION. ASSISTANCE IS RECOMMENDED. THANK YOU FOR CHOOSING OUR PRODUCT!
PART LIST
X1
Driver Front Mounting
Bracket (DFM /DCM/PRM)
Fastener Size Tightening Torque (ft-lbs)
6mm 6-7
8mm 16-18
10mm 31-32
12mm 56-58
14mm 92-94
Front
X1
Passenger Front
Mounting Bracket
(PFM/PCM/DRM)
X1
Driver Center Mounting
Bracket (DFM /DCM/PRM)
Passenger Center
Mounting Bracket
(PFM/PCM/DRM)
X1
Passenger Rear
Driver Rear Mounting
Bracket (PFM/PCM/DRM)
Driver Side Step Bar Passenger Side Step Bar
Customer Support: info@iarmorauto.com
1
Mounting Bracket
(DFM /DCM/PRM)
X1
X1
Rev. 20201201
®
iArmor
X6
M10X1.5-30mm Hex Bolt
X12
M10 Large Flat Washer
X6
X6
U Bracket
The instruction here is for your reference only. We strongly
recommend the professional installer for best result. We are not
responsible for any damage caused by the installation.
M10 Clip Nut
M8X1.25-55mm
Carriage Bolt
M8 Large Flat Washer
STEP 1
X18
X12
M10 Lock Washer
X6
M8 Lock Washer
M10X1.5 Hex Nut
X6
M8X1.25 Hex Nut
X6
X12
X6
Spacer
Starting on the driver side-front of the vehicle, locate the (5)
pairs of factory holes along the bottom of the body, (pinch
weld). Running Board installation will use the 2nd,3rd,and 5th
mounting locations. Move to the 2nd pair of holes directly under
the center of the front door, (Figs 1 & 2). Each mounting loca-
tion on the inner body panel is comprised of a rectangular hole
with a round hole on each side directly above each pair of holes
in the pinch weld, (Figs 1 & 3).
(Fig 1) Driver Body Mounting Locations Illustrated Back Of
Front
Rocker Panel
(Fig 2) Bolt The Front Bracket To The 2nd Pair Of Factory
Holes In The Bottom Of The Pinch Weld
Line Up M10 Clip Nut
With Factory Hole
Factory Holes
In Pinch Weld
(Fig 3) Typical Mounting Location
Customer Support: info@iarmorauto.com
2
Rev. 20201201
Loading...