IAdea IAD18001 User Manual

18001

10.1 HD Smart Signboard

IAdea Corporation

User Manual

IAD18000/

Hardware

綠創科技

綠創科技

綠創科技綠創科技

Warning:

Changes or modifications to this unit not expressly approved by the party responsible for compliance could void

the user’s authority to operate the equipment.

NOTE:

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following
measures:

 Reorient or relocate the receiving antenna.
 Increase the separation between the equipment and receiver.
 Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
 Consult the dealer or an experienced radio/TV technician for help.

Adaptor with ferrite must be used with this equipment to ensure compliance with the Class B FCC limits.

Correct Disposal of this product. This marking indicates that this product should not be disposed
with other household wastes throughout the EU. To prevent possible harm to the environment or
human health from uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse
of material resources. To return your used device, please use the return and collection systems or
contact the retailer where the product was purchased. They can take this product for environmental
safe recycling.

“FCC & CE RF Radiation Exposure Statement Caution: To maintain compliance with the FCC & CE’s RF
exposure guidelines, place the product at least 20cm from nearby persons.”

The power consumption of the product in networked standby is 5.927W which all wired network ports are

connected and all wireless network ports are activated.

Adapter manufacturer: Asia Power Devices Inc.

Model No.: WB-18D12R

Input: 100-240V~50-60Hz0.5A Max.

Output:

Contents

IAD18000/18001 Hardware User Manual 0

1. Introduction 1

1.1. Package contents 1

1.2. Physical view and features 1

1.3. Installation 3

1.4. System setup 4

1.5. Connect device to network 5

1.6. Content Management 5

2. Technical Data 6

2.1. Specifications 6

i