HyVibe H1 User Manual
User Manual - HyVibe System 1
www.hyvibe.audio
Copyright 2018 HyVibe. All rights are reserved. No one is permitted to
reproduce or duplicate this manual, in any form, or any part thereof without
permission from HyVibe.
HyVibe™® is a registered trademark of HyVibe, 2018.
If you have any questions regarding HyVibe products or services, please
contact us at: info@hyvibe.audio
HyVibe
51 Rue de Maubeuge
75009 Paris
TABLE OF CONTENTS
Introduction...................................................4
Compliance Statements.....................5-6
Safety Instructions....................................7
Warnings.....................................................8-9
Battery Information..................................10
Installation...........................,........................10
User instructions .......................................11
Control Buttons/Knobs........12
Turning On/Off..........................13
Effects mode............................13
Record and loop.......................14
Speaker Mode...........................15
Aux In.............................................16
Aux Out.........................................16
Tuner..............................................17
Metronome.................................17
Charging instructions..............................18
Warranty.........................................................18
Notes
INTRODUCTION
The HyVibe System
vibration control system composed of actuators, a high-speed
processor, and a Bluetooth module to turn acoustic instruments into
its own amplifier, connected speaker, recorder, looper, and multieffect processor.
4
1 is a sound amplifying device that uses a
COMPLIANCE STATEMENTS
FCC COMPLIANCE NOTICE Model Numbers: HyVibe System 1
FCC ID: 2AR2L-H1
Changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
-- Consult the dealer or an experienced radio/TV technician for help
This device complies with part 15 of the FCC rules. Operation is subject to the following two
conditions (1)this device may not cause harmful interference, and (2) this device must accept
any
interference received, including interference that may cause undesired operation.
5
This Class [B] digital apparatus complies with Canadian ICES-003.
CAN ICES-3 (B) / NMB-3 (B)
This device complies with FCC and Industry Canada RF radiation exposure limits set forth for general
population. It must not be co-located or be operating in conjunction with any other antennas or
transmitters.
NOTE: HyVibe is not responsible for unauthorized equipment modifications that could violate FCC
rules, and/ or void product safety certifications.
EU Declaration of Conformity CE: Hereby, HyVibe declares that the HyVibe System 1 is in
compliance with the essential requirements and other relevant provisions of Directive 2014/30/EU.
The Declaration of Conformity can be found at: www.hyvibe.audio/cedoc
Hy
Vibe System 1 complies with:
IEC 61000-6-1
2005 Electromagnetic compatibility (EMC)
Part 6-1: Generic standards
Immunity for residential, commercial and light-industrial environment.
6
SAFETY INSTRUCTIONS
1. Read these instructions.
2. Keep these instructions.
3. Heed all warnings.
4. Follow all instructions.
5. Do not use this device near water.
6. Clean only with a dry cloth.
7. Only use attachments/accessories specified and/or included by the manufacturer.
8. Refer all servicing and installations to qualified service personnel. Servicing is required when the
apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has
been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or
moisture, does not operate normally, or has been dropped.
7
Loading...