HYUNDAI MOBIS HM T032 User Manual

FCC ID: TQ8HM-T032/ IC: 5074A-HMT032

ATTACHMENT E.

- User Manual -

HCT CO., LTD.

SAN 136-1, AMI-RI, BUBAL-EUP, ICHEON-SI, KYOUNGKI-DO, 467-701, KOREA

TEL:[phone] F AX:[phone] www .hct.co.kr

Report No. : HCTR1007FR20 1/1

Description of Transmitter

1. PRIMARY FUNTION

- Remote door lock/unlock/panic

- Operating distance : 30 m over

- Id input(setting mode)

2. ELECTRICAL CHARACTERISTICS

model name HM-T032

Operating voltage 3 VDC

Consumption current Max 15mA

TRANSMITTER

Operating frequency

Power 75.6dBuV/m under

Sensitivity -

Operating temperature -20 ~ +60℃

ETC FM modulation

315㎒

3. OPERATING DIAGRAM

1) TRANSMITTER
A) DATA FRAME

B) DATA FORMAT

C) TRANSMISSION SPECIFICATION

- BAUD RATE : 1kbps

- CODING METHOD : MANCHESTER

- TRANSMISSION BIT COUNT : 380Bit

- TRANSMISSION TIME : 380ms±15%

LOGIC "0" LOGIC "1"

2) BCM

g

Sync Code

for Rolling

EEPROM

Array

BCM

RF Module

Check For

Match

Decrypted

Rollin

Code

Serial Number

User Code

Output Circuit

Output Circuit CAR

Check For

Match

User Code

Serial

Parity Error Detection

Received Information

Rolling

Code

Decryptio

n

Rolling

Button

Door Lock Door lock Relay

Door Unlock Door unlock Relay

Tail Gate Unlock

PANIC

Tail Gate Unlock Relay

Hazard Relay

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

Caution: Any changes or modif cations to this device not explicitly approved by manufacturer could void your authority to operate this
equipment.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired
operation.

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be
installed and operated with minimum 20 cm between the radiator and your body. This transmitter must not be collocated or operating
in conjunction with any other antenna or transmitter unless authorized to do so by the FCC.

IC Warning

Operation of this device is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must
accept any interference, including interference that may cause undesired operation of the device.