FCC RF EXPOSURE INFORMATION
WARNING! Read this information before using your WLL
In August 1996 the Federal Communications Commission (FCC) of the United States
with its action in Report and Order FCC 96-326 adopted an updated safety standard
for human exposure to radio frequency (RF) electromagnetic energy emitted by FCC
regulated transmitters. Those guidelines are consistent with the safety standard
previously set by both U.S. and international standards bodies. The design of this
phone complies with the FCC guidelines and these international standards.
This device was tested for RF exposure compliance with the back of the phone kept
3cm (1.2 inches) from the body. To comply with FCC RF exposure requirements, a
minimum separation distance of 3cm (1.2 inches) must be maintained between the
user/bystander and the back of the phone, including the antenna.
For more information about RF exposure, please visit the FCC website at www.fcc.gov
i
_-., __. ..^.l._-
.I
_
---
.I
Contents --
1. Before Using...........................................................................
1.1
.Checking
the Package
1.2. Name and Function of Each Part
.....................................................
...................................
1.3. Cautions.........................................................................
2. Installation
2.1. General Installation
2.2. Installation of Wall Bracket
2.4. Setup for Data Service
2.4.1 Connection between PC and the WLL terminal..
3. How to Use
3.1. To Make a Call
3.1.1. General
3.1.2. Redial Function
3.1.3. End of Digit Function
3.2. To Answer a Call
3.2.1..
..............................................................................
........................................................
...........................................
..................................................
.
............................................................................
............................................................
................................................................
..................................................
..........................................
.........................................................
When the subscriber is in on-hook status
..........
.12
2
2
3
3
5
5
8
11
11
..
11
11
11,
12
12
12
3.2.2. When the subscriber is in
3.3. To Adjust Volume
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ....
off-hook
status
.........
3.4. To Adjust Signal Sending Stand-by Time after Dialing
3.5.
To Adjust Hook Flash Time (Click Time) . . . . . . . . . . . . . . . . . . . .13
3.6. To Use Data Service
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
3.6.1 Data Service Receiving mode Setup Function . . . . 13
3.7 To use G3 Fax Service(Optional)
<Appendix>
. . . . . . . . . . . . . . . . . . . . . . . . . .
1. HWT-2 10 Features
2. Technical Specification
.12
12
.13
13
13
..
3)
Put Al and A2 parts of the terminal on the screw head and press them down to hold.
4) It will be seen as followings after the installation.
Screw required
to fix the bracket
to the wall.
)Bt
The backup battery is built-in within the WLL terminal so that it can operate without external
power for some time. If the SMPS is removed, the backup battery starts to operate. It can be used
about 15 hours in stand-by mode and two hours during the call.
-9-
_.” .._..- -...-
<Appendix>
1.
Features
General
Local
Tone
Hook
Flash
User Control
”
_. . .
Operation
I..
.- .,.
-
- Connection with normal telephone
- Line interface capability : 2 wire
- 3 LED (Power, Battery, Service)
- Wall Mountable
-
Dial tone
- Busy tone
- Warning Tone
- Last Number Rediai
- End of Digit
-
Received Volume Control :
Sstep
- Dial Time Control : 4s - 8s
-
Hook
Flash Time(Click
Time) Control
2.
Tech&al Specifrca’tion
-
Air Interface
Common air interface standard:
-
Frequency: TX: 1850 - 1910MHx
RX: 1930 -
-
TX Output Power:
199oMHx
316mW(25dBm)
J-STD-008
- RX Sensitivity: - 104dBm
-
Vocoder:
8K/13K
QCELP
8K EVRC
-
Channel Bandwidth: CDMA
1.25Mhx
- Spurious: TX Freq. Band: -61dBm below
: RX
Freq. Band: -81dBm below
- MOD/DEMOD: OQPSK/QPSK
-
Frequency
-
Battery Back-up
I
- I
Connectors for Various
Type: Ni-Cd
-
Capacity:
-
Talk Time: 2 Hours
- Standby.Time: 20 Hours
-
RJ-11: standard wire-line telephone
Service Support
-
Serial port : Maintenance Purpose
Accuracy:
Fo+/-150Hz
8.4@1.7A
i ,. ‘. * ’ .
:
Analog G3 Fax (Optional)
:
Data Service Purpose ( Internet,
k
.PC
Fax)
-
Physical
Environinental
Power Supply
4ccessories
Dimension
-
Weight (including Backup battery): 995g
-
Operating temperature:
-
Input Power
-
Output Power: DC
-
Power Supply
(DxWxH)
:
226xl66x65mm
-1OOC -‘+50°C
:llOV-24OV(fzO)AC, 50/6OHx
lZV@2A
-
16
-
Loading...