Hyundai Electronics H-CDM8023 User Manual

H- CDM8023

CD/MP3-RECEIVER CD/MP3-РЕСИВЕР

Instruction manual Руководство по эксплуатации

Dear customer!

Thank you for purchasing our product. For safety, it is strongly recommended to read this manual carefully before connecting,
operating and/or adjusting the product and keep the manual for reference in the future.

Table of contents

Table of contents....................................................................................................................................................................... 2

Important safeguards................................................................................................................................................................. 3

Installation/ Connections........................................................................................................................................................... 4

Accessories ............................................................................................................................................................................... 9

Panel controls.......................................................................................................................................................................... 10

Menu Function........................................................................................................................................................................ 13

MP3 Play back ........................................................................................................................................................................ 16

MP3 Overview........................................................................................................................................................................ 17

Anti-Theft System................................................................................................................................................................... 18

Handling compact discs........................................................................................................................................................... 19

Cleaning.................................................................................................................................................................................. 19

Troubleshooting guide............................................................................................................................................................. 20

Specification........................................................................................................................................................................... 21

2

Important safeguards

· Read carefully through the manual to familiarize yours with this high-quality sound system.

· Disconnect the vehicle's negative battery terminal while mounting and connecting the unit.

· When replacing the fuse, be sure to use one with an identical amperage rating. Using a fuse with a higher amperage rating may

cause serious damage to the unit.

· Do not attempt to disassemble the unit. Laser beams from the optical pickup are dangerous to the eyes.

· Make sure that pins or other foreign objects do not get inside the unit; they may cause malfunctions, or create safety hazards

such as electrical shock or laser beam exposure.

· Do not use the unit in places where it can be exposed to water, moisture and dust.

· If you have parked the car for a long time in hot or cold weather, wait until the temperature in the car becomes normal before

operating the unit.

· Do not open covers and do not repair yourself. Consult the dealer or an experienced technician for help.

· Make sure you disconnect the power supply and aerial if you will not be using the system for a long period or during a

thunderstorm.

· Make sure you disconnect the power supply if the system appears to be working incorrectly, is making an unusual sound, has a
strange smell, has smoke emitting from it or liquids have got inside it. Have a qualified technician check the system.

· The unit is designed for negative terminal of the battery, which is connected to the vehicle metal. Please confirm it before
installation.

· Do not allow the speaker wires to be shorted together when the unit is switched on. Otherwise it may overload or burn out the
power amplifier.

· Do not install the detachable panel before connecting the wire.

3

Installation/ Connections

Din front-mount (method 1)

· After inserting the holder into the dashboard, select the appropriate tab and bend them inwards to secure to the place

· Insert fingers into the groove in the front of frame and remove it.

· Insert the levers supplied with the unit to the grooves at both sides. The unit can be installed or removed from the dashboard.

4

1. Dashboard

2. Nut (5mm)

3. Spring washer

4. Screw (5 x 25mm)

5. Screw

6. Strap

7. Plain washer

Din rear-mount (method 2)

Installation using the screw holes at both sides of the unit.

1. Select a position where the screw holes of the main unit are fitted for aligned, and tighten the screws at 2 positions at each sides.

Use either truss screws (5 x 8mm) or flush surface screws (4 x 8mm), depending on the shape of the screw holes in the bracket.

2. Screw

3. Factory radio mounting bracket.

4. Dashboard or Console

5. Hook (Remove this parts)

Note: The mounting box, outer trim ring, and the Half-sleeve are not used for this method of installation.

5

Detachable control panel

Detaching the control panel

1. Press the OPEN button on the front panel. The panel will go down (pic. 1).

2. Push the panel to the left and then pull it towards you (pic. 2).

Pic. 1

Attaching the control panel

1. Insert the left side of the control panel into the main unit (pic. 3).

Note: the control panel must be attached into the T-Joint.

2. Press the right side of the control panel until a “click” sound is heard.

3. Close the panel.

Caution:

DO NOT insert the control panel from the right side. It can damage the control panel.
The control panel can easily be damaged by shocks. After removing it, place it in a protective case and
be careful not
to drop it or subject it to strong shocks.
The rear connector that connects the main unit and the control panel is an extremely important part. Be careful not to
damage it by pressing on it with fingernails, pens, screwdrivers, etc.

Note:

If the control panel is dirty, wipe off the dirt with soft, dry cloth only. And use a cotton swab soaked in isopropyl alcohol to clean the
socket on the back of the control panel.

Pic. 2

Pic. 3

6

Electrical connections

Notes:

· In spite of having any kinds of speaker system, must use 4 ohms impedance of speaker to reduce the distortion during high
volume level.

· Prohibit to make the conductors of auto antenna and ground touch with each other.

7

Using the ISO Connector

1. If your car is equipped with the ISO connector, then connect the ISO connectors as illustrated.

2. For connections without the ISO connectors, check the wiring in the vehicle carefully before connecting, incorrect connection
may cause serious damage to this unit.
Cut the connector, connect the colored leads of the power cord to the car battery as shown in the colour code table below for speaker
and power cable connections.

Location

Connector A Connector B
1 Rear Right(+)---Blue
2 Rear Right(-)---Blue/White Stripe
3 Front Right(+)---Grey
4 Battery 12V (+)/yellow Front Right(-)---Grey/White Stripe
5 Auto Antenna/Orange Front Left(+)---Green
6 Panel light/White Front Left((-)---Green/White Stripe
7 ACC+/red Rear Left(+)---Brown
8 Ground/black Rear Left(-)---Brown/White Stripe

FUNCTION

8

Accessories

№ Name pcs
1 Hexagon nut M5 T (3.5 mm) 1
2 Mounting box (0.6 mm) 1
3 Left key (1.0 mm) 1
4 Right key (1.0 mm) 1
5 Metal bar (0.8 mm) 1
6 ISO connector 1
7 Plain washer Φ=5 mm 1
8 Carrying case 1
9 Outer trim ring 1
10 Spring washer Φ=5 mm 2
11 Screw Φ5X5 mm 4
12 Screw Φ5X25 mm 1
13 Screw M5 Φ5X29.3 mm 1
14 Customer information 1
15 Warranty card 1
16 Instruction manual 1

9

Panel controls

1. OPEN BUTTON

2. VOL KNOB / SEL BUTTON
Rotate it clockwise to increase the volume level; rotate anticlockwise to decrease the volume level.
Press it repeatedly to select the mode: VOL => BAS => TRE => BAL => FAD
Rotate VOL knob to adjust each mode.
Push more than 2 seconds to Menu mode.
MP3 track/ file/ character search
ESP 45s/120s

3. LOC button
Press to select: LOCAL or DISTANCE.

4. Display

10

5. 9/: buttons
In Disc mode press the buttons shortly to go to previous/next track. Press and hold them to start fast
backward/ forward rewind. In Radio mode press the buttons shortly to search the stations manually.
Press and hold for 2 seconds to start searching the stations automatically.

6. MUTE BUTTON
Press it to switch the sound off/on

7. MON button
Press to select: STEREO or MONO.

8. BAND
In radio mode press it to select desired band.

9. BAND
In radio mode press it to select desired band.

10. Clock

11. Disc playback: Play/ Pause. Top play (press more than 2 seconds).

12. Disc playback: Intro play (10 seconds).
Press this button to play the first 10 seconds or each track. Press this key again to clear this mode.

13. Disc playback: Track repeat play.
Press this button to repeat the same track continuously. "RPT ON." will appear on the display. Press
this key again to stop repeating.

14. Disc playback: Track random play.
Press this button to play all the tracks in random order. "RDM ON" will appear on the display. Press
this key again to stop random play.

15. Disc playback: MP3 track – 10 down.

16. Disc playback: MP3 track + 10 up.

17. F/PS button: automatic scan/Store.

18. Loudness.

11

19. MODE button
Press it to select the mode: TUNER => DISC => AUX.

20. Power on: press any button on the panel except OPEN to turn on the unit. Press more than 2 seconds to power off.

Inner panel

Press the OPEN button on the front panel to flip it down.

1. LED INDICATOR

2. RESET BUTTON

3. DISK SLOT

4. EJECT BUTTON

12

Menu Function

Press the POWER button to turn the unit on, the display will show a message to indicate it is ready to use. Press the
BAND for the radio mode, press MODE to select between Aux, Radio mode and CD/MP3 play. Press the POWER button again to
turn the unit off.

VOLUME CONTROL
A. The volume level can be adjusted at any time by rotating the audio level VOL knob as select mode has been initially defaulted at
volume mode.
BASS CONTROL
A. Press the SEL button to select the bass mode until BAS appears on the display.
B. Press the VOL knob to adjust the bass effect.
TREBLE CONTROL
A. Press the SEL button to select the treble mode until TRE appears on the display.
B. Press the VOL knob to adjust the treble effect.
BALANCE CONTROL
A. Press the SEL button to select the balance mode until BAL appears on the display.
B. Press the VOL knob to increase or decrease the sound level of left or right speaker.
FADER CONTROL
A. Press the SEL button to select the fader mode until FAD appears on the display.
B. Press the VOL knob to increase or decrease the sound level of front or rear speaker.

13

BEEP ON/OFF mode

Press SEL button for 2 seconds, the display will show DSP OFF.
Press the SEL button continuously until the display show BEEP ON, press the volume up/down button to toggle between it and BEEP
OFF, then leave the unit idle for your desired setting to take effect.

LOUD mode

Press the LUD to emphasize the Bass output, the word LOUD ON shows on the display indicates that the loudness function is on.
Press again to cancel.

Time clock setting

The time clock can be set anytime when the power is on.
Press the CLK button and then press and hold CLK button for 3 seconds, the time will blink on the display.

1. Rotate the volume knob clockwise to adjust the hour.

2. Rotate the volume knob anti-clockwise to adjust the minute.

3. Press the CLK button again or left the unit idle for new setting to effect.

Press the CLK button anytime to view the time clock display.

DSP mode

Press and hold the SEL button for 2 seconds, the display will show DSP OFF. Press the volume up/down button to choose EQ effect.
POP ROCK CLASSIC FLAT DSP OFF

After you have reached your desired effect, leave the unit idle in order for the new setting to take effect.

14