Hyundai H-AS1203u User Manual [ru]
H-AS1203U
USB/SD AUDIO SYSTEM
WITH SUBWOOFER
АУДИОСИСТЕМА С USB/SD
И САБВУФЕРОМ
Руководство по эксплуатации Instruction manual
Instruction manual
Dear customer!
Thank you for purchasing our product. For safety, it is strongly recommended to read
this manual carefully before connecting, operating and/or adjusting the product and keep
the manual for reference in future.
Description
Front panel
1. STBY/MODE button
2. SLEEP/CLOCK button
3. P+ button
4. Display
5. P- button
6. button
7. /PRESET button
8. IR sensor
9. EQ button
10. VOL+/ALARM2 button
11. VOL-/ALARM1 button
12. button
1
2
3
4
5
6
7
8
9
10
11
12
Back panel
13. FM-antenna
14. Power cord
15. POWER switch
16. Line input
Not shown: memory card slot (top
panel), USB port (top panel), speakers
(left and right panel)
2
13
14
15
16
Instruction manual
Remote controller
1
2
3
4
5
6
7
8
9
10
11
12
1. SLEEP button
2. STANDBY button
3. MODE button
4. DIMMER button
5. The button is not operable for this model
6. The button is not operable for this model
7.
button
8.
/ buttons
9. The button is not operable for this model
10. P+/P- buttons
11. RESET button
12. Number buttons
13. CLOCK button
14. SNOOZE button
15. BED TIME button
16. WAKE UP TIME button
17. SELECT/SCAN button
18. EQ button
19. SHUFFLE button
20. REPEAT button
21. +/- buttons
22. SHIFT button
23. MUTE button
13
14
15
16
17
18
19
20
21
22
23
Utilization of the product
If you want to dispose this product, do not
mix it with general household waste. There is a
separate collection system for used electronic
products in accordance with legislation that
requires proper treatment, recovery and
recycling.
Please contact your local authorities for
the correct method of disposal. By doing so,
you will ensure that your disposed product
undergoes the necessary treatment, recovery
and recycling and thus prevent potential
negative effects on the environment and
human health.
Important safeguards
• The instruction manual contains important
operating and maintenance instructions. For
your safety, it is necessary to refer the manual.
Keep the manual for use in future.
• Do not hit or drop the unit.
• Do not expose the unit to vibration, direct
sunlight, too high or low temperature or humidity.
• Do not disassemble the unit yourself.
Refer servicing to qualified service personnel.
Power supply
• Before the first connecting of the appliance
check that voltage indicated on the rating label
corresponds the mains voltage in your home.
• Insert the plug into power supply.
Caution: Always unplug the appliance from
power supply, when no use long time.
General operations
Power on/off
When the unit is connected to the current
supply mains, slide POWER switch to ON
3
Instruction manual
position to switch the power on; the unit will
go into standby mode. Press STBY/MODE
button on the panel or STANDBY button on the
RC to switch the unit from standby mode; the
backlight on the front panel will light up. To turn
the unit to standby mode press and hold STBY/
MODE button on the panel or press STANDBY
button on the RC. To switch the power off, slide
POWER switch to OFF position.
Clock setting
• In standby mode press CLOCK button
on the RC or press and hold SLEEP/CLOCK
button on the panel to enable time setting
mode. Hour digits will blink; press repeatedly
/ buttons to set hours. Press CLOCK
button on the RC or SLEEP/CLOCK button on
the panel again; minute hours will blink. Press
repeatedly
CLOCK button on the RC or SLEEP/CLOCK
button on the panel to confirm the time.
• In time setting mode, if no button is pressed
within 5 seconds, the unit will automatically go
to clock mode.
/ buttons to set minutes. Press
AUX input
You can connect the audio output of an
external device to this unit, to listen to the sound
of that device through the speakers of this unit.
• To connect an external audio device,
please use a standard audio cable with 3.5-mmto-3.5 mm plugs to connect the headphone out
or audio line-out of the external device to the
AUX input socket of this unit.
• Press repeatedly MODE button on the RC
or STBY/MODE button on the panel to select
LINE mode; LINE will be displayed.
• Turn on the external device. You cannot
control playback with the buttons of this unit
except adjusting the volume.
Volume
Press VOL+/ALARM2 and VOL-/ALARM1
buttons on the panel or +/- buttons on the RC
to adjust the sound volume level. Press MUTE
button on the RC to mute the sound, press this
button again to resume the sound.
Equalizer
Press EQ button repeatedly to select an
equalizer mode: ROCK/CLASS/FLAT/POP/
JAZZ.
Modes
Press MODE button on the RC or STBY/
MODE button on the panel repeatedly to select
an operation mode: external audio device from
the line input (LINE) => FM radio => USB =>
SD. USB and SD modes are available only if
corresponding storage is connected.
Display backlight
Press DIMMER button on the RC repeatedly
to change the display backlight brightness level
or switch off the backlight. When the backlight
is switched off, you can activate it for several
seconds by pressing any button; it will go off
again after several seconds.
Radio operation
• Press MODE button on the RC or STBY/
MODE button on the panel repeatedly to select
radio mode.
• For FM reception extend the wire antenna.
• To adjust the frequency step by step
press repeatedly / buttons. For automatic
search of a station, press and hold
button; the unit will look for the next
available station and start its broadcast.
Repeat the operation to search more stations.
Press SELECT/SCAN button on the RC to
automatically search available stations.
• To save a station, press PRESET button
on the RC or press and hold /PRESET
button on the panel. The memory position
will blink. Press P+/P- buttons to select a
memory position. Press PRESET ( /PRESET)
button again to save the current station under
the selected number. You can maximum 20
stations in the memory.
To input a position number for saving
or a stored station number you can also press
or
4
Loading...