Hyundai H-1613 User Manual
H-1613
PORTABLE RADIO RECEIVER ПОРТАТИВНЫЙ РАДИОПРИЕМНИК
Instruction manual Руководство по эксплуатации
Description
1. Display Screen
2. Lock button
3. Power Switch/Sleep button
4. Reset Button
5. Up Tuning
6. Store Scan /Alarm button
7. Down Tuning
8. Memory +
9. Band / Mode
10. Memory
11. Store Station
12. Volume-
13. Volume+
14. Telescopic Antenna
15. Supporting Buckle
16. Hand Belt
17. Earphones Socket
18. External Power Socket
19. Battery Slot
LCD
1. Volume indication
2. Sleep indication
3. Alarm indication
4. Time or Frequency indication
5. FM band indication
6. MW band indication
7. SW band indication
8. Receiver indication
9. FM and SW frequency unit indication
10. MW frequency unit indication
11. Lock indication
12. Store address indication
13. Store station indication
2
Important safeguards
• Prefer servicing to qualified service personnel.
• ATTENTION: The owner’s manual contains important operating and maintenance instructions for your safety, it is necessary to refer the manual.
Power supply
Battery operation
• Open the battery compartment cover.
• Insert 2 AA batteries. Please observe correct battery polarities or the set will not work.
• Close the battery compartment cover.
• When the battery is exhausted, it should be removed from the set to prevent leakage.
Note: When replacing batteries the stored information will be lost.
Use External Power
Please use output DC 3V 300mA regulating external direct current power, check the positive and negative of the plug
.
Radio Operation
Power Switch
Press the power switch/Sleep OFF button once to turn on the radio, the last band frequency before turning off the radio is displayed. Press the power switch
button again to turn off the radio, the time is displayed.
Adjust Volume
• The radio is with electric volume function, do not listen with highest volume. The volume can be set and stored.
• In receiving state, press the VOL+ button / VOL- button to adjust volume, you can select your desired volume.
Band Selection
In receiving state, press the Band / Mode button to choose FM, MW, SW programs.
Manual Search
In receiving state, press the up tuning button or down tuning button to select your desired station frequency. Each press, the frequency varies
one step, until the station is found.
Attention: Manual searching station mode is fit to search weak signal station.
Automatic Search
• In receiving state, keep the up tuning button or down tuning button pressed, when you see the display frequency automatic change, let go,
when there is a station, it will stop searching automatically.
• In the course of automatic searching, press the up tuning or down tuning button, it will discontinue searching.
Attention:
• Automatic searching station mode is fit to search strong signal station.
3
• In the course of automatic searching, if the digit on the display screen varies slowly, it means that there is weak signal station nearby, you can change to
use manual to search station.
Frequency Change Law
• Receiving FM, press the up tuning or down tuning button once, the frequency increases or decreases 0.1 MHz.
• Receiving SW, press the up tuning or down tuning button once, the frequency increases or decreases 0.005 MHz.
• Receiving MW, press the up tuning or down tuning button once, the frequency increases or decreases 9 KHz.
Store Scan
In receiving state, press the store scan/Alarm ON button once, it will begin to scan station, in the course of searching, when there is a station, it
will store it automatically, and then hold on. In the course of automatic scanning, press the store scan/Alarm ON button once again, it will
discontinue scan.
Attention:
• In the course of automatic scanning, if not clear, please change to use manual to search station.
• When using the store scan function, the old frequency will be covered with the new station
Store Stations
• You can use one of the methods of auto, manual and direct input station to receive station frequency.
• Press the store station button, the "PRESS" is flashing on the display screen.
• Press the Memory + or the Memory -to within 5 seconds to select stored address. Press the store stations button again to confirm the stored
address, the station frequency has been stored in the address.
Attention:
You can store 10 stations in each band. If in 1-10 address the station frequency already exists, store new frequency according to the abovementioned methods, the old frequency will be cancelled.
Using Stored Stations
In receiving state, press the Band Change-over/Mode button to select band, press the Memory + or the Memory - button to select the station
which is saved in the memory.
Lock Switch
The button lock switch is set in the radio to avoid mis-operation. Before to the use, please check the lock function.
After selecting the station or turning off the radio, please press the lock switch, the " " will display, the buttons on the surface do not
function.
Earphones Socket
For private listening please insert the earphones in the Earphone socket (the speaker inside the radio disconnects automatically), you can listen to the radio by
earphones.
Night Illumination Button
The button on the face all have illumination function, press any of them and the lamp lights up, it will automatically go out after several seconds, which is
convenient for you to operate the radio in darkness.
4
Loading...